Acura RL

To clean the EGR valve on a 1998 Acura RL, first, ensure the engine is cool and disconnect the negative battery terminal. Remove the EGR valve by unscrewing the mounting bolts and gently detaching any electrical connectors and vacuum hoses. Clean the valve using a throttle body or carburetor cleaner, scrubbing with a brush to remove carbon buildup, and then reassemble the valve, ensuring all connections are secure. Finally, reconnect the battery and test the engine for proper operation.

To change the time on the clock of a 2005 Acura RL, first, turn on the ignition or accessory power. Then, press the "Menu" button on the dashboard to access the clock settings. Use the "Tune" knob to adjust the hours and minutes, and press the knob to confirm each setting. Finally, exit the menu to save the changes.

To replace the neutral safety backup switch in a 2003 Duramax 2500, first disconnect the battery to ensure safety. Then, locate the switch, which is typically mounted on the transmission. Remove the electrical connector and the securing bolts, then take out the old switch. Install the new switch in reverse order, ensuring it is properly aligned, and reconnect the battery before testing.

To remove the rear seat from a 2005 Acura RL, start by locating the clips or bolts securing the seat bottom, typically found at the front corners. Use a trim removal tool or a socket wrench to unfasten these attachments. Once the seat bottom is removed, the seatback can usually be detached by unbolting it from the rear or by releasing any clips. Always consult the vehicle’s manual for specific instructions and safety precautions.

Sounds like a loose connection on the back of the bulb. Unplug them and plug them back in making sure the plug in all the way on.

If you are removing the radio because you need to get the serial number to reset the code then a better solution is if you don't have the navigation package (GPS screen) you will have 3 "dummy" buttons below the radio. Pop off the middle one and you can see the serial number with a flashlight. The dealer said they would charge me an hour and a half to remove the radio, this trick took a minute. Hope it helps.

Press and hold the select AND reset buttons at the same time. Turn ignition switch to on and wait maybe 10 seconds until the maintenance light goes out.

Egr code

1. Make sure headlamp is off and open hood. 2. Taurus model years 1990-1999: you must remove the whole headlamp to replace the bulb. Not a horrible task. Just annoying. 3. Facing the driver's side headlamp, and looking at the headlamp itself, at clock positions 8, 11 and 1 are the headlight housing screws. They all look the same. Using a 10mm socket wrench, remove these 3 screws and set them aside. 4. Just to the right of the "11 o'clock" housing screw is a bolt (same hexagonal 10mm sized top as the housing screws). This just needs a few turns to loosen it. 5. Gently pull the whole headlight forward. Now you can get at the bulb. 6. Disconnect the electrical connector from the bulb. Now the headlamp is free to work with. Remove the bulb, replace with a new bulb, make sure the bulb housing cylinder is in place and reconnect the electical. 7. Place headlamp back into position. Line up screw holes. Tighten the bolt. Replace housing screws and tighten. 8. Passenger side headlamp is mirror image of driver's side. Screws at 11, 1 and 4 o'clock positions. Bolt should be to the left of the "1 o'clock" housing screw.

The location on my 2000 RL is behind the ashtray

How to replace fog light bulb for acura rl 2002

The curb weight of the 2004 Acura NSX is 3197 lbs..

The 2000 Acura dash light fuse can be found in the fuse box. The fuse box is in the engine compartment. The location of the fuse is listed on the inside cover of the fuse box.

At the pivot point of the clutch pedal, underneath the dash. Very hard to get to. I would take the driver's seat out. That will make it easier.

Your temperature would usually fluctuate.

But if your car has over heated then there is a chance it may need changing

Taken from: http://rl.acurazine.com/forums/showthread.php?t=3276

"You remove the air intake, battery, and may need to remove the anitfreeze resivoir next to the battery. Then you can reach the bulbs from the back. Yo will no longer need to remove the bumper, taking out the housing is a pain. Just make sure you have the stereo + nav code when you take out the battery."

-referring to a '99 model.

Unplug or replace maint. timer

I have a 2002 Acura RL 3.5. The owner's manual states, "Your Acura is designed to operate on premium unleaded gasoline with a pump octane number of 91 or higher...we recommend gasolines containing detergent additives that help prevent fuel system and engine deposits." That being said, I ran 87 octane during the last gas crunch and all was fine.