Replacing your Rear Window Regulator of acura 3.5rl 2000?
its not impossible, but its not easy either. I did one 2 years ago and I just had another go on me. I am going to take it to an auto glass repair shop once I buy the regulator on line. They are a lot cheaper than repair shops. It took me few hours even with the on line directions, and I am pretty handy. You have to work in a tight space and its a pain. if you can get the glass shop to put it in for less than $100, its money well spent.
it is located underneath the dash on the drivers side left of the brake pedal
Where is the turn signal relay in a 1999 Acura RL located?
It is located just to the right of the interior fuse box, behind the kick panel, to the left of the emergency brake.
What does the M mean on the 2004 Acura RL shifter?
Someone can probably explain this better than I can, but it means "Manual". Your car is probably tiptronic which means it's automatic but you can put it in "m" and should be able to shift with the center console shifter or you might have paddle shifters on your steering wheel (probably not though).
Either way, you can shift up or down by using no clutch. It's really fun. Try it out one day when you're not on the freeway or in traffic by lots of people. ;)
Why is your gear shift stuck in drive in your 1997 Acura RL?
The brake pedal shifter release switch is disengaged. You will need to go under the driver kick panel area and manually press the switch (look to see if the switch wire harness is loose)
How do you tell if my thermostate is bad in a 1998 Acura RL?
If ur bottom radiator hase is COLD after the car has warmed up or normal driving temp then it is stuck closed and needs to be placed. They should both be HOT and at or near the same temp.
How do you reset the maintenance required light on a 2004 Toyota Rav4?
free easy video instructions on www.vehix411.com
Set the odometer to TRIP A. Turn the key off. Press and hold the ODO button. Turn the key on. Continue holding the button while the light goes through a series of flashes. When it stops flashing, turn the key off and release the button.
Turn the key back on to make sure it "took".
When you buy a new ignition key with a chip for an Acura how do you get the car to start?
you have to have acura dealer re program the new key. sucks but i guess its for your protection. you will need registration and i.d.
How do you reset check engine light on 2000 Acura RL?
There are pages and pages and items that can cause a check engine light. You need to have it checked for codes with a scan tool. After repair light can be shut off with scan tool.
Where is the fuel pump relay for 2000 Acura RL?
In the trunk ,(under the carpet there is a plate that comes off and that gives you access to the relay )
What is the best gas for a 2000 Acura 3.5?
I have a 98 3.5 rl and the manual says to use gas with an octane rating of at least 91.
What does the srs light on your 2002 Acura mean?
It means you have a fault somewhere - Honda's and Acura's are notorious for this problem, and sometimes all it takes to fix it is having the seat belt catch replaced (Seat belt clasps are also wired to the SRS system) Ask the advice of the Honda/Acura Dealer.
Ask your Acura dealer if they can fix it under an extended warranty. The first time this light came on, I did not have to pay anything. It turned out to be a seat belt catch problem. The next time it came on two years later, they wanted $129 just to look at it, so I drive with it on.
Where can one see an Acura RL in person?
"One could find and see an Acura RL in person by visiting Acura dealerships, and used car lots to view a 2011 Acura RL, but the 2012 Acura RL has yet to be released."
How do you replace a starter on an Acura RL?
To replace the starter on an Acura RL, begin by disconnecting the negative battery terminal to prevent electrical shock. Next, remove any components obstructing access to the starter, such as the air intake duct or engine covers. Then, unbolt the starter from its mounting location, disconnect the wiring harness, and replace it with the new starter. Finally, reassemble any removed parts, reconnect the battery, and test the new starter.
Where do you find thermostat on 96 Acura RL?
On a 1996 Acura RL, the thermostat is located at the engine end of the upper radiator hose. To access it, you need to remove the hose and the thermostat housing, which is typically secured with bolts. Make sure to drain some coolant before starting the work to prevent spills. Always refer to a repair manual for specific details and torque specifications when reassembling.
How do you set the time on the Acura RL 2005?
To set the time on a 2005 Acura RL, first, turn on the ignition without starting the engine. Then, press the "MENU" button on the audio system and select "Clock." Use the "H" (hour) and "M" (minute) buttons to adjust the time accordingly, and press "ENTER" to confirm your settings. Finally, ensure that the time is displayed correctly on the screen.
When to replace Acura 3.5 RL timing belt?
The timing belt on an Acura 3.5 RL should typically be replaced every 60,000 to 90,000 miles, according to the manufacturer's recommendations. It's important to consult the owner's manual for your specific model year, as guidelines may vary. Additionally, if you notice any signs of wear, such as cracks or fraying, or if you hear unusual engine noises, it's advisable to replace the belt sooner. Regular maintenance is crucial to prevent potential engine damage.
How do you replace vss on Acura rl?
To replace the Vehicle Speed Sensor (VSS) on an Acura RL, first, disconnect the negative battery terminal to ensure safety. Locate the VSS, which is typically situated on the transmission; remove any components obstructing access. Unscrew the old sensor, replace it with the new one, and reconnect any wiring. Finally, reassemble any removed parts, reconnect the battery, and test the vehicle to ensure the new sensor is functioning properly.
How do you change headlight bulb on 2006 Acura RL?
To change the headlight bulb on a 2006 Acura RL, first, ensure the vehicle is off and the keys are removed. Open the hood and locate the back of the headlight assembly. Twist the bulb socket counterclockwise to release it, then remove the old bulb and replace it with a new one, taking care not to touch the glass part of the bulb. Finally, reinsert the bulb socket into the assembly and twist it clockwise to secure it before closing the hood.
How do you replace a neutral safety switch on a Ford Taurus?
To replace the neutral safety switch on a Ford Taurus, first disconnect the negative battery terminal to ensure safety. Locate the neutral safety switch, typically found on the transmission near the gear selector linkage. Remove the electrical connector and the mounting bolts, then take out the old switch and install the new one in reverse order. Finally, reconnect the battery and test the switch to ensure it functions properly.