0
Acura RL
Also known as the Honda Legend, the Acura RL is a full-size luxury car and the flagship vehicle of the Acura brand for North America. The alpha call-sign “RL” stands for “Refined Luxury”.
419 Questions
What is the windshield wiper size for a 2005 Acura RL?
28" & 19" but be careful - these are not standard wipers and you cannot purchase standard aftermarket replacements - you may have to go Acura-only or try to find refills that will fit the existing frame assemblies. Always lookup the make, model and year of the vehicle to get part numbers - don't buy just by length on this vehicle.
How do you replace the taillight bulb located on a 1998 Acura RL 3.5L?
1998 Acura RL tail light bulb replacement: Purchase the correct replacement tail light bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the tail light bulb replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).
How do you reset the maintenance required light on a 1995 Montero?
After my 1995 Montero turned 150,000 miles the
How do you change a front signal light on a 98 Acura RL?
How do you change front signal bulb on 2000 acura RL
Check the starter solenoid, starter ground resistance, and voltage out of thesolenoid when activated. If the solenoid is not clicking then the issue is either the relay or the fuse to the solenoid.
How do you reset the Maintenance Required light on a 2003 Toyota 4 Runner?
If you mean the oil change maintenence light... Set the odometer to total miles (The actual odometer reading). Turn the truck off, then turn the key (While holding the re-set button) so the engin is not on, but the power is. The light will then flash and go out. It will come on again in another 5,000 miles to remind you to get your oil changed. the button the last guy is referring to is located to the left of the speedometer,tach,guage assembly (combination meter) it says "reset" on it
How do you reset the maintenance required light on the instrument cluster on a 2003 Honda Civic?
With your key in the "on" position but your "not" running. Disconnect the positive battery cable and leave off for a few minutes. Turn the key off at the end of the wait and plug the battery back in. If the code is cleared the light should be reset. If it comes back on, the trouble is still there.
There is another way of course... I've seen the worker at the Honda dealership use the trip/arrows and other buttons on the instrument panel to read the code and to turn off the maint. req. light on my S2000. He said that it is timed to go off when the next oil change is required.
Does anybody know how to do this without disconnecting the battery?
Thanks much! T
Ahhh I found it, from http://www.photoslave.com/journal/auto/s2000_maint.html : To reset the MAINTENANCE REQUIRED light: - Have key inserted in ignition but in the OFF or LOCKED position. - Push and hold the trip reset button on the right bottom corner of your gauge clutster. - Turn key to full ON position and continue holding the button till the light goes off.
How do you reset the maintenance required light on a 1992 Dakota 5.2L?
The maintenance light,You will need to take it to a Dodge dealer to reset it. Or get a DBR-2 code scanner.BIG $$$
Where is the fan blower located on a Acura RL 3.5?
behind the glove box under the dash 3 screws hold it in
How do you remove radio from Acura rl?
You cann't remove only radio you have to remove whole panel which contains radio.
There are two possible scenarios for you car radio panel
1. Your car can have Navigator, Climate Controller and Radio.
2. Your car can have Climate Controller and Radio.
You have to open whole panel.
This Panel contains some of SRS components, so have to be very careful while removing it!
Please search for "Acura RL Service Manual"
Follow this link you will be able to download it for free.
http://rapidshare.com/files/55768439/1996-2004__Acura3.5RL_Service_Manual.rar.html
When you find this helpful, then please help others
How can you reset the SRS light to Acura RSX 2002?
Our cars are known to have problems with the SRS lights, well basically all Honda/Acura because the system sometimes "hiccups" and causing codes to trip the SRS light.
DISCLAIMER: Please do this at your own risk, i am not responsible for any damages that you may cause by doing this SRS DIY reset. If you do not trust yourself, please take the car to Acura Dealership and have them reset it for you, Warranty will normally cover for reset at FREE of charge. Try this DIY at your own risk.
Note: If your airbag deployed or seats has been removed or anything that may have triggered the SRS, this DIY will not work for you. All you will get is two flashes or more and the light will remain on.
Tools Material Needed:
- Standard Paperclip (or wire)
- Maybe flash light (night job)
Time:
- 1 to 5 minutes
First make sure your key is out of the ignition.
Step 1:
You can use two options in this step to use to make two contact connect together:
Paper Clip, you can use the paperclip and bend it out to where both ends are next to each other so it can be put in to two pins.[img]http://www.dc5nation.com/DIY/SRSDSC02850.JPG[/img]
- or -
Regular wires, this is actually the best way to use to complete a circuit.
[img]http://www.dc5nation.com/DIY/SRSDSC07465.JPG[/img]
Step 2:
Remove the bottom panel under the dash, two twist clips which can be easily taken off. (turn counter-clockwise)
[img]http://www.dc5nation.com/DIY/SRSDSC02851%20copy.jpg[/img]
Step 3:
After the bottom panel is exposed, locate the fuse box (see drawing for location)
[img]http://www.dc5nation.com/DIY/SRSDSC02852%20copy.jpg[/img]
Step 4:
Locate the SRS plug above the fuses in the fuse box panel, you will see a yellow clip in the middle left side. It is also the ONLY plug that's yellow in the fuse box panel.
[img]http://www.dc5nation.com/DIY/SRSDSC02853%20copy.jpg[/img]
Step 5:
Unplug the clip. You should see two pin holes that you will be completing the circuit with using the paper clip or wires
[img]http://www.dc5nation.com/DIY/SRSDSC02857.JPG[/img]
Step 6:
plug the paperclip in to the 2-pin clip.
[img]http://www.dc5nation.com/DIY/SRSDSC02859.JPG[/img]
After all the Prep Work is done, here comes the steps you need to take to complete actually reset the light. TIMING MUST BE PERFECT, if the light comes back on, remove the key and repeat steps again. Read these steps first before attempting the reset.
Step 7:
With the paperclip or wires in the pins, place the key in and click to the Ingition On position II and leave it alone throughout the whole step.
[img]http://www.dc5nation.com/DIY/SRSDSC02865.JPG[/img]
Step 8:
You should hear beeps for 3 seconds, and when the beep is gone, the SRS should turn OFF.
[img]http://www.dc5nation.com/DIY/SRSDSC02864.JPG[/img]
Step 9:
QUICKLY, Take the paperclip/wires out and the light should come back on.
[img]http://www.dc5nation.com/DIY/SRSDSC02861.JPG[/img]
Step 10:
When the light comes on, QUICKLY plug the paperclip back in to complete the curcuit again, in a second or so, the SRS light should TURN off
Step 11:
At the final step here, you will remove the paperclip/wire and the light will quickly flash twice and turn off. You should wait a second or two to see if the light comes back, if so, YOU WILL NEED TO REPEAT steps 7-11 again. If not, read step 12
Step 12:
At this point, take the key out of the ignition and put the 2-pin clip back in to the proper place (same place where you took it out). Secure the bottom dash back in to place. Test out the SRS again with the Ignition Position II. It should beep then the SRS should turn off.
Quick Read DIY without pictures:
1. connect clip to yellow clip, turn key to position II
2. wait for the light to go off and remove the paper clip/wire.
3. As soon as the light turns back on, quickly connect the circuit again.
4. The light should turn back off. Remove the paperclip/wire again.
5. The light will wait a second or two before it tells you the follow word.
6. Final word is, 2 quick flashes and SRS light turns off completely.
6-A. two quick flashes and the light remains, you may be too slow or you have a short in your SRS somewhere.
7. turn off ignition and put back the clip.
Congratulations, you have successfully reset your SRS light.
Troubleshoot:
Most of the errors can cause by removing items such as steering wheel, seats, seatbelts and airbags. Its very rare for a sensor in the front to go bad but if you have been in to an accident and your airbag didn't deploy but the seatbelt locked, YOU MUST replace the SRS module.
If you have aftermarket steering wheel or seats, there is a resistor that you can purchase from Radio Shack where you stick in between those where the airbag or seats suppose to be and act to complete the circuit.
How do you reset the maintenance required light on a 2006 tacoma?
I have a 2007 Toyota Tacoma, but I believe the reset steps will be the same for the 2006 model. Here are the steps to reset the Maintenance Required light: 1) Turn your key to the on position (just before it turns the engine over). 2) Push the odometer button until the total miles are displayed and HOLD it in. 3) Turn the key Off, and then back ON while holding the odometer button in. Don't let up on the button. You will notice the odometer reading shows dashes and they will sequence off. After they sequence off, the Maint Reqd light will go off. Release the odometer button. That's it! You can also follow this youtube demo. It's for a different make of vehicle, but it is exactly the same process. http://www.youtube.com/watch?v=HulNtNltD7A -Pete-
Where is the interior fuse box on a 2000 Acura 3.5 rl?
On the left "wall". When you're sitting in the driver's seat, look to the left of your left leg just off the floor
Where is the oil filter Acura rl?
Underneath of the car back of the oil pan. to see it you have to be under the car.
Where is the fuel pump relay located on a 98 Acura RL?
The fuel relay is located in the back of the rear seat. Open the Trunk, remove the cover from the trunk the cover the back of the seat. and there is your trunk relay.
What does PEO error message mean on Bose CD system in 97 Acura?
"PEO" USUALLY means Player Error Optical,which means in most cases the
laser has malfunctioned.When this happens of course,no CD or disc will
play.Replacement of the unit is usually indicated.
Where is obd port on 1999 Mercury Cougar?
The 1999 Mercury Cougar OBD 2 port is under driver side dash left of steering column
How do you reset the Maintenance Required light on a 2005 Tacoma?
Remove the battery cables at battery,pump the brake pedal a couple times then rehook battery cables.This don't work all the time but sometimes.Cheaper than a dealer turning it off. Toyo joe The maint. Req. Light is nothing more than an "Oil Replacement Reminder Light". This is different than a "Check Engine Light". Pg. 154 Para(g) in the owners manual describes how to reset it. While holding the trip meter reset knob in, turn the key switch on, wait about 8 seconds and the odometer will come back on and the light should be out.
How do you take a code off the CD player in a 97 Acura RL?
I'm assuming you mean "How do I find out what the code for my radio is." It should be written in your owners manual. If not, call an Acura dealership and give them your VIN. They'll be able to tell you the code.
What is the stereo code for a 2000 Acura Integra?
Each stereo has a unique code. The only way to get this code is to take it to an Acura dealership. actually save a trip and get the Code off the back of the raido and call a acura dealership and give them the code and they will give you yours
1998 Acura RL 3.5 srs light is on how to manually retrive codes?
What does 1998 3.5 rl aura srs light on mean what is problem
How do you reset the maintenance required light in a 2000 Acura RL?
press the reset and select switch at same, turn ign. key to II (On) and wait 10 seconds
