Cadillac STS

Car wont start,anti theft system is activated,

The Cadillac STS 98 was constructed to drive it in the Autobahns, so I reachs 241 km/hr or 150 miles /hr

DON'T USE DEXCOOL.Drain out your system,Flush it out, And replace with regular anti freeze. O'reilly brand is O K. The Green stuff.

you must have a working fob first . take the second fob and place it in the holdr of your center console take the key and put it in the door unlock door 5 times you will see new fob recognized take fob out and press door lock twice all done

if you pull back the rubber seal on the front of the door, there's a hole to access the mounting screws for the mirror. You may need a special screwdriver to hold the screws to the driver to prevent them falling off the screwdriver as you insert the assembled screw driver and screw into the opening

emulsification and frothing of fluid causing pump to sound like it is rattling to death. seals on rack will fail some time later, replace rack, flush system, pump may be o.k.

It depends on the vehicle but most run at about 175 to 210.

The 2000 to 2002 Northstar motors should be the same in this perspective. First you need to remove the cover over the intake manifold. it should have 2 plastic nuts. for the front side, the ignition coil is visible and can be removed with 8 bolts and unplugging a pigtail. It sits directly on top of the Valve cover. Then you'll need to remove the boots that sit on top of the spark plugs. The rear is the same except you'll need to remove a few brackets for components that will be in your way.

where is my cruise control fuse located for a 1998 sts

On the right side of the instrument cluster there are three buttons

press ON/OFF and INFO UP together for 2 to 3 seconds.

The starter motor is located under the intake manifold. It's not as bad as it sounds to replce though. The first one I did took me about two hours, but I can whip them out in a hour now. Lots of wires and hoses that you need to make sure you keep track of and re-assemble properly. Be very careful of the MANY fule lines that run on top of the intake. They will crack easily.

you put a lifting kit that could lift as much as you need to put the 4ssss however if the wheels don't fit on the car at regular ride height then it probably shouldn't go on the car. Just go with a smaller size. You'll probably be more pleased with the over appearance of the car not to mention it will handle alot better.

we would need more information but most if not all bushings can be replaced

oil drain plug on cadillac sts42008

Behind the back seat that's where all the computers for the north star engine is located theres wire terminals that conect to the relay panel behind the back seat so i would suggest you look there.

the knock sensor on a 95 eldorado is located underneath the passenger side right above the trans-axel by the vss switch on the back of the motor, if its knot there its underneath the manifold.

out of gas?????????? their could be several reasons from a bad sensor to a bad fuel filter take it to your mechanic he sould be able to help you

Remove front wheel. Remove splash apron. remove air deflector. Remove front bumper. Now you can access the headlamp assembly.Can you give me a diagram

There were many people killed in 9/11, and most of them were in the wrong place at the wrong time. Bless them

is it the electric pul down that isn't operating.

If it is and you cant get a new one, remove it from the car, remove electric motor( the gear on the trunk hold down tends to break, it is plastic).

Disassemble from the top metal plate(2 screws) raise it up and inspect the gear, if missing teeth just hold the gear and rotate the trunk hold down it will lower. Re install in car.

You may have to adjust the heigh to get the trunk to shut correctly just raise or lower the hold down(you can do this while it is in the car)

You will need the GM water pump remover tool, you can rent one from Auto Zone or a similar store. The water pump housing is the bottom radiator hose on the right side of the engine. remove the hose and the outer-caseing,there is a small hose to remove from the crossover pipe also the water pump is now slightly visable. then take the cover off the pump drive belt one blolt and two nut 10 mm use a 13 mm wrench on the tensioner to get belt off pump pulley before removing pump Use a 1/2 inch rachet with the GM tool and turn clockwise. this is not an easy fix the pump has a oring in side the casing the book says nothing about the back side of the pump i got a tube of permatex red i had to put a little on the oring to get it to stay then the back plate of the water pump about where the oring would touch a complete band around it also to remember the small noched ear on the pump goes right about 7 oclock in the whole keep the pump dead center of the whole push firm on it, i put a long screwdriver down the front side up against the pulley to keep the pump center so i could get the big scocket on correctly them keep presure on it as you pull back towards you counter clockwise you will feel it catch pull it till it stops after you take off the socket look on the side of the pump you will see the bent part of the clips are flat up against the slot blocks in the housing if all looks good reinstall cover make sure you change out the cover oring to after you take old one out clean surface real good then install the new cover oring. reattach all other hoses and bolts and nuts. don't put antifreeze back in for about an hour to make sure all sets up good luck i just put my put in on 02/07/2012 and it hasn't leaked a drop good luck. ps don't force the pump back into car if it dont go on the first, take it back out and do it again. good luck i got my pump at autozone for $47.00 lifetime warranty and the cover oring $4.00 and $30 dollar deposit for pump scocket the i got it back when i returned the socket

I just got a 1994 STS and the temp seems to be at 215-226 city driving with the a/c on in 95 degree weather. Seems hot to me, maybe that's what the car needs to run at for the emissions. If this is normal I'll live with it.

There is none.

You pull it

If it is an after market CD player. Which im guessing. You need to buy a $100 wiring harness. You'll be better off just finding a good cheap disk changer and installing it in the trunk.