0
Chevy Cavalier Z24
Cavalier Z24 is a sport-themed style of the compact Cavalier. The Z24 model traversed two generations of the model line. Besides using a powerful V-6 engine, it offers five-speed manual transmission and an optional three-speed automatic transmission.
1,493 Questions
Where is knock sensor located on 2001 cavalier?
2.4 is on back side towards rear end of engine.
2.2 is on back side towards front of engine.
What is the oil capacity for 2005 Chevy Cavalier?
4 quarts.
No. This answer is wrong. It is somewhere closer to 5 and a half liters.
How do you remove tensioner pulley cavalier Z24?
remove the belt by pulling the tensioner up or down take off the altnator then it just three bolts and it s off
This may be only for the 2.4. The tensioner is not even close to the alternator on the 2.2. In order to remove the tensioner on a 2.2ltr you either need to lift the motor a bit or remove your fender and inner fender well because no tool can remove that pulley/assembly in that clearance. There is only a few inches between the tensioner pulley and the inner fender well. Chevy doesnt have a special tool like I hoped they would, to sneak in that little spot, so if anyone comes up with anything let me know. Hope everyones cavalier endeavors go well! :)
How do you remove rear seat cushion cavalier?
Push back on the lower section of the seat (difficult) to release locking clips Lift bench up and out
What could be wrong with your ac in your 93 Chevy z24 it blows perfectly it just wont get cold?
If the air conditioning pump in the 1993 Chevy Z24 blows perfectly, but won't get cold, it is possible that the Freon needs to be recharged in the air conditioning unit. This can usually be done for about $40 by the consumer.
How do you install a water pump in a 2000 cavalier?
its actually not a hard job to do on these motors (2200 4 cylinder) 1. with the serpentine belt still in place take a wrench and break loose the 3 bolts holding the pulley on the water pump. 2. remove the serpentine belt by relieving the tensioner pulley. ( just takes a standard ratchet) 3. remove the alternator, there are three bolts holding the alternator in place, two on the side that the belt is on (one on top of the alternator and one under it) and one on the lower back side of it under a bracket, then just move it out of your way (you dont even have to disconnect it). 4. remove the 3 bolts on the water pump pulley, remove the pulley. 5. break loose the 4 bolts holding the water pump to the motor, unthread them alittle to let the old coolent drain out of the motor past the pump, them remove the pump. 6. remove all the old gasket from the motor surface, use the new gasket that comes with the new pump and apply RTV to both sides of the new gasket. 7. install the new water pump by reversing the steps for removal, fill the car back up to spec with Dex-a-cool, you may wanna drive it around the block after filling to get the air out of the system, then recheck the coolant level. then you are done!
Where is the air control valve located on 2000 cavalier?
I belive that you are refering to the IAC Valve (Idle Air Control). It controls the engine idle speed. It is located on the throttle body and mounted with 2 star type screws.The wire connector looks square and is black in color. It has 4 wires on the plug. You can find out more and how to test it at autozone.com. Click repair info, then click repair manuals.
How do you get the convertible top down on a 1990 corvette?
First look under the visors, pull the latch handles away from the window. The lid will open slightly. Then push forward the drivers seat and look under the lid, you will find a spot to pull a cable which will release the top from the rear clips. After that pull up on the rear of the top and hold upward while you push one of the yellow buttons to lift the lid. One of these buttons is also located under the lid and there is also one inside the door jam. Once it raises you simply lower the back section and pull the front section up and back, it will seat itself in place. Then close the lid. It is quick and simple
Where are the wheel sensors located on a 2000 Chevy cavalier z24?
Get under the car. Look for a wire connected to the wheel. That is it. The front can be changed easily by removing 1 bolt. The rear, remove the wheel and brake drum. There are 4 bolts(torx or star head bolts) & nuts that need to be removed. There is no need to remove the brake shoes. First check that the wires are making good contact at the master cylinder and havent come loose. Also check the fuses and wire harness for bad spots. Could also be calipers or a malfuction with the master cylinder assembly.
How do you yank a digital dashboard from a 1987 Chevy Cavalier Z24?
Remove the dash panel below the sterring wheel (pop out fasteners). Drop the steering colum mount closest to the wheel and the retaining bolt half way down the column then lower the column. Unscrew the four bolts holding the dash in and gently pull the cluster away from the dash. The flexible circuit board will need to be re bent out to ensure proper contact upon reinstallation. See www.V6Z24.com for all you Z24 questions........
Not sure if it is the same as my '97, but a backup switch is located on the shifter assembly just under and behind the air filter. Remove the hose from the filter to the engine. Brad
It is in the neutral safety switch.On top of the trany.It's black and strait under the brake master cylinder.
Where is the fuel filter located on a 1991 Chevy Cavalier?
The fuel filter is located in the rear of the car. It will be between 2 hoses which are the fuel lines. Now the lines on my 91' Cavalier were all rusted, so I took a hack saw and cut on both sides of the filter. Then, I unscrewed the lines from the filter and placed them on the new one. Then went and bought some rubber hoses and some clamps and just clamped them together.
How can you rewire a washer fluid motor to just a toggle switch on an 88' Chevy Beretta?
Yes! Find the wires going to the washer switch and just use a toggle switch in it's place. If you can't locate the wires, you can just run power straight to the motor from the toggle switch. I recommend you use a spring loaded on/off toggle switch, to make sure you don't accidentally leave it in the on position.
How do you change a license plate bulb on a 1991 Chevy cavalier z-24?
their are 4 plastic nuts in the trunk that loosen the light assembly that the lights are in. Remove those and pull the assembly out and twist the connector for the license plate light to access the bulb.
How much horsepower does a 1997 Chevy cavalier have stock?
- z24 models have about 140 HP
- non z24s have about 100 HP
Do you have to pull the engine out of a 1998 cavalier with a 2.2L to change the head gasket thanks?
No
96 Chevy cavalier Z24 what to do when you hear knocking from the engine?
rebuild the motor or buy a crank kit and install it.
What are the speaker sizes on a 1997 Toyota Corolla?
There are numerous ways you could approach this situation. If you're interested in making vehicles run more efficiently, you could look into engineering. Or if you're looking to improve national infrastructure, you could try something like drafting, political science, or city planning.
How do you remove headlight assembly on 2002 caviler?
Open the hood. Remove the black plastic cover that goes across the top of the headlights/radiator. Remove the two silver screws that are on the top of the headlight assembly. Then remove the light housing...Not much holding them on.
