0
Chevy Impala
Launched in 1958, Chevy Impala is a full-size vehicle built by General Motor’s Chevrolet division. It is Chevrolet’s most expensive vehicle and US best selling automobile through 1965. It is distinguished by its triple symmetrical taillights.
4,997 Questions
What other wiper motors can fit a 1965 Chevy Impala?
Need to know if you have a single speed or two speed wiper motor.
What kind of antifreeze does a 2004 impala use?
Use antifreeze labeled as being "Dexcool approved". It'll typically be orange.
How much should a radiator Flush for a 2001 Impala cost?
The only thing you will need is the antifreeze and water which the impala holds a total of 10 quarts but i would say just over a gallon would be all you need because you wont be able to drain it all and you can get a gallon of antifreeze for $10 so maybe a max of $20
How do you change the brake light bulb on a 2007 impala?
See *Taillamps, Turn Signal, Sidemarker, Stoplamps and Back-Up Lamps* on page 349 of your "Owner's Manual", under Section 5: Service and Appearance Care - Bulb replacement.....
Can you put 24 inch rims on a 1996 Chevrolet caprice?
You should be able get the 24's on the car with a 5" lift since b-body cars like the caprice have a large wheel well. But if you are looking for a decent turn radius or would like to go with 26's you could always go with 7" complete kit. That 7" kit comes with everything you need to correct your alignment after putting on big rims. If you still want to go with the 5" kit you should at least get extended shocks with it so you can keep your ride quality as smooth as possible.
Where is the fuel filter on a 2007 Impala?
It is on the driver's side frame just forward of the gas tank.jd
Did the 1969 Chevrolet Impala come with a 327 engine or a 350?
it came with the 327 i believe i think i may be wrong im not quite sure cannot remember i think it was the 327
The last year of the 327 was 1967, I have one in my T-bucket from a corvette of that year. Also there is no such thing as a 327 4-bolt main. The 350 block had no breather pipe at the rear of the block, as did the 265,283,and327, asure fire way of telling the difference if someone trys to sell you a 327 4-bolt. PCV days with the 350 in 1969
The answer that the last year for the 327 was 1967 is incorrect. The 327 was placed in Gm vehicles up til the mid production year of 1969. Sadly it was replaced with the 307. The casting number on the block of a 327 of that year is 3932386, the same casting number as the 302Z motor stamped DZ. The other casting number for that block 3932388, which is the same casting number as the 350 block.To answer your question of whether or not it was used in the impala of that year, you would have to go to anengine ID site. By the way the 327 of that year put out about 210Hp. with simulsr torque ratings. This is a nice motor to build, but if you decide to do this, it's a good idea to update the heads if you plan on driving it regularly.
I have a 327 in my 60 apache panel truck that came from my friends grandmother 69 impala with 2bbl carb. and 200 hp (with 4bbl carb 210 hp) was advertised. it has been updated with 350 heads and 600 edelbrock carn and intake but is still too under powered for my panel.
A 1969 Impala come with a 327ci engine. a friend of mine has two of them they are a 1969 Chevrolet Impala, and they have the silver 327 sign above the signal lights on both of the front fenders.If you need proof you can call my friend Bobby Squires at 1-336-578-1226.He lives in Burlington N.C
My parent's, in 1969 bought brand new a 69 Chevrolet impala, It came with a 327 210 horses,case closed.
Standard engines for the Impala in 1969 were the 250 six cylinder and the 327 V8. You could also order various versions of the 350, 396 and 427 V8. As far as I know the 307 V8 was not available for full size Chevys in 1969, but you could probably make a special order if you for some strange reason wanted it...
The Standard v-8 in 1969 full size Chevys was a 327. I seem to recall that 1968 was the last year the Impala was offered with a 307. In addition, there were two versions of the 350 offered and a 396 big block.
My first car was a 1969 Impala with the low compression version of the 350 "Turbofire" which listed itself as 255 horsepower on the decal on the air cleaner. Unlike the 327, the 350 came with a four barrel carbutetor.
Of course that 255 horsepower was SAE gross, not SAE net as calculated today. Connected to a "Powerglide" two speed automatic, it didn't have much tire-chirping potential.
as far as i know it came with both, i believe that the first part of the year they had 327 and 350 for the second, i do know for sure that they camce with original 350s as that i own a 69 impala convertable and buy checking the Vin was able to see that it was a 350 car.
Yes the 1969 Impala came with a stock 327. You can look up the vehicle and it will have the emble on the side of the car.
In 1969 My Father traded in My Mothers 1968 Chevy Nova SS 350 for a 1969 4 door Impala with a Stock 396
ANSWER
1969 was in fact the first year of the 350, and the last year of the 327cid. Unfortuanetly, the 327 was only available in the Biscane, Bel-air, Impala, and Caprice. the emblem will be on the fender specifying the cid of the engine, which "in the V-8 family" should be 327, 350, 396, and 427. Chevy began the conversion in late 69 to the 350 engines! The transmission should be either a power glide "2 speed" or a 350 "3 speed", but I'm sure it could be ordered with a 400. I don't ever recall ever seeing a 307 in the 69 Impala, but anything is possable. The 5.0 litre 307 was more popular in light bodied trucks.
ANSWER
I have a 1968 Chevy Impala with a 327ci and Camel hump heads. Its sister car a 69 parts car both came from Georgia had 327's
I have a 1969 Impala and it has a 327 in it so yes this was the last year and also it is a two bolt but a very good engine to build.
How much is a motor for a 2000 impala?
I am going to assume you are referring to the engine. There are 3 motors in your car. The fan motor, ABS motor, and blower motor. The device that drives your car is not a motor, it is an engine. The cost of that engine depends on which engine you purchase. The 3.4 or 3.8 V6. Also depends if you buy a new, rebuilt, or used engine. New, either one will be around $2,000 depending on where you purchase it. A Google search will help answer your question.
Where is the location of the relay for the heated seats in a 2000 impala?
The Driver's Heated Seat fuse (LH HTD ST/BCM) is in the Driver's Side Instrument Panel Fuse Block. The Passenger Heated Seat fuse (RH HTD ST) is in the Passenger's Side Instrument Panel Fuse Block. See pages 6-63 & 6-65 of your "Owner's Manual", under Section 6: Service and Appearance Care - Electrical System - Fuses and Circuit Breakers...
How do you Replace 2003 impala brake lights?
See Tail Lamps, Turn Signal, Stop Lamps and Sidemarker Lamps on page 5-57 of your "Owner's Manual", under Section 5: Service and Appearance Care - Bulb Replacement...
Is 5x108 and 5x115 bolt pattern the same?
NO. one is 108mm and one is 115mm. However, some wheels have 10 holes, so they may fit both bolt patterns.
Where is the hood sensor located at on a 2006 impala?
It"s connected to the hood latch. Hope this helps
Until a better answer comes along, here's one to explore. Many cars are designed with headlamps that are replaced from the back. Unfortunately, they are not always easy to get to. But if you try to do it from the top or front by loosening bolts or screws, you run the risk of altering the direction of the headlights.
Again, generally speaking, if you can get your hand behind the headlamp, you wll find an electric plug that goes into the rear of the lamp. Pull out the plug. Then there may be a plastic ring that locks the headlamp bulb in place. Loosen that counterclockwise and pull out the bulb. Yu should be able to buy a replacement bulb at any auto parts store. Compare the used bulb and the new one to be sure they match up.
Finally, you can get a used Haynes manual for your particular model Honda at Barnes and NOble (www.bn.com)or Amazon.com for as little as $6.95 plus $3.50 postage. That's good enough for DIY backyard mechanics. The "official" repair manual published by the automobile companies cost roughly $50. It's worth the price but you will probably never need it.
What transmission fluid is recommended for 2001 impala?
Dexron III 7.4 quarts pan removal and replacement.
10 quarts compete overhaul.
Answer7.4 quarts for a 3.8 liter Chevy impala 2001How do the hazard lights work on a 2003 Chevy Impala?
See Hazard Warning Flashers on page 3-6 of your "Owner's Manual", under Section 3: Instrument Panel Overview.....
Why is the temperature gauge reading hot on a 2000 Chevy Impala?
Possibly low on coolant. Next most likely is a coolong fan not working. next a thermostat being stuck closed after thata water pump.
How do you reset tire monitor on 2008 Chevy van?
First you have to hit the button to "Relearn Tire Positions" with the vehicle running and in park. When you hit the button, the horn will beep twice, and the display will read "Relearning Tire Positions". You then have to get out of the vehicle and go to the left front tire and remove the air valve and let air out of the tire for at least 5 seconds. When you are done, after a couple of seconds, the horn will beep once. Then you go to the right front tire and repeat the procedure, then the left rear tire, then the right rear tire. They must be done in this order! The horn should beep once after every wheel you do, and then when you are done, the horn should beep twice again to let you know you've done it right. I think once you start the procedure, it gives you so many minutes to complete it (like five minutes, I think). Good luck! Do the above with ignition on or engine running. Once you have release air pressure from each wheel and heard the double beep at the right rear wheel refill tires to 35psi or 240kp. The display will recalibrate. At this point turn the igntion off and restart engine. The light will now be out.
Where can I find a wiring diagram for a 1968 Chevrolet Impala?
You need to purchase a Haynes Manual that is specific to your car.
Where is the Coolant level sensor 2001 Chevrolet impala ls?
coolant sensor on my 3.8 is located on right side of radiator about halfway down on back side, real close to battery.might have to remove battery to get to it.my light is on too,i just bought a sensor from autozone for $50 but need to know how to reset the fault code before i install to know for sure if its the problem
Why does the fan assembly not work on 2003 Chevy impala?
Check to see if you are getting power to fan motor turn on A/C or defroster If you are getting power to fan - then fan is defective If not check fuse Could be temperature sending unit in radiator
