0
Chrysler Cirrus
Chrysler Cirrus was a four-door midsize sedan manufactured by Chrysler Corporation from 1995 to 2000. This vehicle featured aluminum wheels, optional rear child seat anchorages, and an 8-speaker AM/FM cassette stereo as standard.
548 Questions
Check the sensors, mine did the same thing and it was the sensors
Okay, this might sound stupid, but I've done it before. Make sure the car is in park, if it is in the middle of park and reverse,it won't start. Make sure it has gas, and if nothing else, it's probably your starter or alternator. Take it to the mechanic.
Your 1995 Chrysler Cirrus wont start you think its going to be the map sensor but where is it?
map sensor is located on the upper intake on the passenger side near the back.
There is a little screw on your carb, should be on the right side(assuming your vehicle is carbureted)get a knife and slowly turn the screw to lower and raise your idle.
How do you change the fuel filter in a 1995 Chrysler Cirrus?
Jack up the rear of the car. Place a jack under the tank (preferably low on fuel or you can drain the tank.) Loosen the tank strap on drive side. Lower jack and you will get access to the fuel filter. Replace and reverse to install.
What are the Advantages of egr valves?
the advantages of an egr valve is that it dump exhaust gas back into the cylinder to cool down cumbustion temp so your vehicle doesn't release harmful gasses into the air
Why does my Chrysler cirrus sometime start and sometime hard to start.?
Because your starter is going bad. You will need a new starter soon!
the cap may not be cracked as you said when the cap gets wet when distributor cap gets wet, moisture will also get into where the plug leads go into cap. this will cause same problem you described. if cap is cracked it will misfire, etc whether wet or dry. to fix problem of cap getting wet, you need to somehow stop water from getting on the cap
Try removing both battery cables and cleaning them, if the are very dirty soaking them in a solution of water and baking soda will remove most of the corrosion. Clean the terminals on the battery as well.the reconnect both cables and retry. If this doesn't work try charging the battery or boosting it. Good luck
Were is the shift solenoid on a 1997 Chrysler Cirrus?
It is on the front of the transmission, below the cooler hoses.
thats called "limp home mode" and its a very obvious sign you have something wrong with your tranny. you probably need a new one or to get the old one rebuilt
What is the Plug Gap on Cirrus 2.4?
the spark plug gap setting should be located under the hood in the engine compartment right besides the type of refrigerant if not check with your locale auto store they would have that information for you
Location of fuel filter of 2000 Chrysler cirrus?
Its located next to the gas tank on the back side. Your going to have to lower the gas tank you cant miss it. Its kind of goldish and its about half the size of a beer can
Light Blue/Black wire is the sensor ground, Tan/Brown wire is the signal output and the Orange wire is the 8 volt power feed from the PCM.
How do you replace a speed sensor in a 2000 Chrysler Cirrus and where is the sensor located?
The speed sensor I know is located on the transmission. The top side most likely. Should be be like one bolt mounting it to the transmission. Just disconnect the electric lines running to it then remove bolt and it should just pull right out. Once replaced the Computer needs to be cleared out of the codes to eliminate the check engine soon light.
I've done thisSeems to be a common problem with these vehicles as well as 300Ms.You can access it from the driver side wheel well. You should jack up the driver corner of the car if you can to have some extra room. You then need to remove the plastic cover which in front of the wheel and covers the battery. If you look straight through to the transmission you will see a tan colered sensor on the side of the transmission which is towards the front of the car.
You just have to take the electrical connector off and then unscrew the sensor from the transmission. You may need to take the wheel off to have enough room to work. It's really very easy and you just need a wrench. Make sure to remove the one towards the outside of the car, not the inside, if you are looking for the output speed sensor. Then, just plop the new one in there and clip the wires back on. I did not even have to clear the engine codes, the light went off by itself after driving it a few times.
The new sensor was only $20-30 from the Chrysler dealership. Good luck!
I have found the sensors much cheaper on eBay motors, where there are several eBay stores specializing in transmission parts. ... as in $7.99 - $9.99ea
How do you charge the battery in a 2000 Chrysler Cirrus?
You hook the cables to the jump start posts under the hood on the driver side.
How do you Remove headlight on Chrysler Cirrus?
There are two 6" screws on top of the headlight casing under the hood. Take them out, then slide the entire headlight assembly out towards the front of the car and disconnect the wires running to each individual bulb. Unscrew the bulbs from the back of the casing and VOILA! you have successfully taken out a headlight.
