Clouds

If it is gone you need to find it. If it is still inside the female she will get an infection and very sick. Air bubbles are not uncommon when you put a condom on or as friction starts going. It means it came off sometime during the deed. Find it soon. Careful analysis [several times] of answer 1 and the question, suggests that its author MISUNDERSTOOD the QUESTION, and thus was answering as if the question were "If a condom is missing after intercourse...?" The following points relate to the "missing AIR BUBBLE" from the tip of the condom, and not a missing condom. 1. Although not probable, it is possible that the disappearance of the air bubble is the result of an opening [pinhole or tear] in the condom. 2. The DISAPPEARANCE of the air bubble described at the tip of the condom is PROBABLY the result of the air working out around the penis during intercourse. 3. You do NOT "need to find it" as answer 1 suggests, as that air is impossible to find or retrieve. 4. The statement, "If it is still inside the female" she will "get an infection," and "make her very sick" is accurate IF the subject is a condom in the vagina, but if the subject is AIR then there is no hazard. 5. The absence of the AIR BUBBLE does not indicate that the condom "came off sometime during the deed."j3h. I personally find this answer an honest one and it's coming from someone with little experience, but at least they had the sense to use a condom. The proper way to use a condom is to always check the expiration date on the side of the box (it will say "best before _____" and if you have gone past that date then get a fresh box of condoms or just a couple if that's all you feel you'll need. Be sure you get the right sized condom! Once you take the condom out of the sealed package you should gently stretch it, then blow in it to be sure there are no leaks. You should roll the condom gently leaving a bit at the end (at the bottom of your penis) and then roll the rest up to the end of the penis (near the crotch area.) The end of the condom is suppose for semen and thus, you probably think the end of it has disappeared when, in fact, it's full of semen. Marcy

The RPM decreases after a shift because the engine is no longer under heavy load from accelerating in the previous gear. When you shift, the transmission momentarily disconnects the engine's power from the wheels, causing the RPM to drop as the engine adjusts to the new gear ratio.

The evaporator may be dirty or the condenser(outside unit) may be dirty. You may be low on "freon", indicates a possible leak. Check the filter. ---------------------------------------------------------------------------------------------------- If you're asking why the 'outdoor' part freezes, it's too cool outdoors. You should never run a house central A/C when the outdoor temperature is below 60 degrees F. Professionals will tell you that you can blow out a compressor this way. Big $$$$. You may be asking why there's a part in your furnace (that has part of the central A/C inside) that freezes over with ice in the summer. Your first clue will be that the house gradually grows very warm even though the A/C is running, and it worked fine until now. If the indoor air is too hot and damp when you turn on the A/C, you can overwhelm the system's ability to move heat out of your home. Instead of collecting moisture at the heat exchanger inside your furnace and using gravity or a small pump to move the water to a drain or outdoors, the water freezes right on the heat exchanger. The ice acts as an insulator, continues to build and the house will remain warm. This can cause expensive damage as the ice grows too big for the area around it. Switch the thermostat to heat (furnace) instead of cool and raise the temperature setting for about 5 minutes and the ice should all melt, then you can switch back to cooling. Since you've already removed much of the moisture in the house, you'll probably be fine, and the few minutes the furnace was running won't even be noticed. Chazzzman ------------------------------------------------------------------------------------------------------

Common causes of low pressure in a pool filtration system can include clogged skimmer or pump baskets, dirty or clogged filters, air leaks in the suction lines, or a malfunctioning pump or impeller. Regular maintenance and cleaning of these components can help resolve low pressure issues.

You have to make sure your filter is clean otherwise you will receive low to no pressure for your barracuda/manta to move. There is a small ball inside belly of the barracuda that sometimes breaks apart and sometimes gets stuck. Replace the ball or break it free This should help. If its not the ball then I would suggest you replace the flapper but most times it is simply the ball mechanism inside that breaks. If the unit gets stuck in corners try moving the hose weight a litle to chang its cere of gravity. also have a look at diaphragm some times leaves or weed pods get stuck in them.RB

partially, less than 50%, no problems, beyond that, you will get negative results elsewhere in the house that outweigh the benefits of doing so. You would have to know the following: cfm (cubic foot per minute) requirements of the system (for example, a 3 ton system requires 1200 cfm). Next you would have to calculate what the size the opening would be (another example, 1200 cfm requires an opening that is 16" x 12"). If you block off too much return air (or supply, for that matter) you can cause serious problems on the cooling side, and potentially unsafe conditions on the heating side.

either air is getting into your lines or something in your water is getting in the o rings in your cartridges. air can get into your lines if you have even a small leak you don't know about. it could also be that either copper shavings or sediment from your water lines gets jammed into the o rings. The other problem could be to high of pressure coming into the building. you can install a pressure reducing valve to correct the problem. * The "hissing and gurgling" would concern me. Check your water heater right away. If it is electric, is an element always energized, and if it is gas is the burner running a lot or constantly? Is the Pressure relief valve plugged or inoperative for any reason? Does the water from the heater seem to be really hot? Over 140 degrees F? You might be making steam, and this is a very dangerous situation, SHUT OFF the energy or fuel source immediately and call a qualified plumber.

It is possible that there is an issue with the blend door actuator or the heater control valve. These components control the temperature distribution between the front and rear heating systems. I recommend checking these components to see if they are functioning properly.

If a 1994 Honda Civic has too much pressure on the high-pressure side of the AC system, it may indicate a blockage in the system, a faulty expansion valve, or an overcharged system. Have a professional technician inspect and diagnose the issue to determine if any components need to be replaced or if the system simply needs to be properly charged or cleaned.

Yes, it is possible to have water vapor at -10 degrees Celsius. Water vapor can exist in the air at temperatures below its boiling point, as long as there is enough energy for evaporation to occur. However, the amount of water vapor that can exist at colder temperatures is typically lower compared to warmer temperatures.

Sorry buddy but i work in that and...answer is no way.there is no tools that you could have some kind measuring tools that could help you.

Only way is that you ask your supplier/producer of fittings and ask him a catalog where you could find your specified fittings.

The Inter-tropical Convergence Zone (ITCZ) is a belt of low pressure near the equator where trade winds from both hemispheres converge. It is characterized by rising warm air, heavy rainfall, and often thunderstorms. The ITCZ moves north and south seasonally following the sun's zenith position.

Clouds have different prefixes based on their altitude and appearance. Alto- clouds are mid-level clouds, cirro- clouds are high-level clouds, and nimbo- clouds are associated with precipitation. This classification helps meteorologists communicate more precisely about the characteristics of different cloud types.

Rainfall in Belgium is common, with precipitation occurring frequently throughout the year. On average, Belgium receives around 200 days of rainfall annually. The country's weather is influenced by its maritime climate, leading to consistent and diverse precipitation patterns.

False. A rain shadow is the dry area on the leeward side of a mountain caused by the blocking of moisture-laden air by the mountain, leading to little or no precipitation. The side of the mountain with clouds and rain is the windward side.

The Dry Valleys of Antarctica is the driest place on Earth - 2nd would probably be the Sahara.

The intertropical convergence zone (ITCZ) is a region near the equator where winds from the northern and southern hemispheres come together. Consequences of the ITCZ's movement are the "monsoon seasons" that affect areas in the tropics, as well as the formation of tropical storms during the local hemispheric summer (north or south of the equator). Navigators in the age of sail learned to utilize the "trade winds" that blow to the east along the edge of the ITCZ.

Some countries near the equator that receive heavy rainfall include Indonesia, Malaysia, Brazil, Colombia, and the Democratic Republic of the Congo. These countries experience high precipitation due to their proximity to the equator and the presence of tropical rainforests.

If you're asking how it would feel to be in a cloud, it would feel a lot like being in fog. A rain cloud would be a "wetter" fog, more of a mist.

If condensation rates decrease leading to fewer clouds, humans may need to adapt by implementing more sustainable water conservation practices, such as reducing water usage and implementing water-saving technologies. Additionally, there may be a need for increased investments in alternative sources of water, such as desalination or rainwater harvesting, to mitigate the impact of decreased cloud formation on water availability.

Circadian rhythms govern daily variations in biological and psychological processes, such as sleep-wake cycles, hormone levels, and mood patterns. These rhythms are influenced by internal biological clocks as well as external cues like light and temperature. disruptions to circadian rhythms can impact overall health and well-being.

Ang dust cloud ay isang theorya ni Fred Whipple, Isa siyang Astronomer. Ang mga dust cloud ay nabuo sa maiinit na alikabok ng mga meteor na mabilis umikot sa kalawakan. Lumamig ang Dust cloud at nagkaroon ng pormasyon ng PLANETA

The suffix "nimbus" generally refers to a type of cloud that indicates rain or storm. It can also refer to a halo or aura that surrounds a person or object, often symbolizing divinity or holiness.

The prefix nimbo- indicates clouds or precipitation, while the suffix -nimbus refers to a distinct type or shape of cloud formation. Together, they are commonly used in meteorology to describe various cloud types associated with precipitation or weather events.