Dodge Avenger

The three carsymbols are for the satellite radio. When my subscription ran out they turned red.

Nooo!!

*note*

if you have enough time, skill, and money, you can make almost any engine fit into any car.

I have a 96 2.0L 16 valve 4 cylinder, so this may be different on your car. The first thing you want to identify is which of the two O2 sensors need replacing. The good ting on mine was that both were the same model so I could buy one and not have to worry which was bad. I new it was my pre-cat. sensor and located it towards the passenger side right below one of the tubes going into my radiator. It will look quite small in diameter compared to the new one, if you get the Bosch model at least, and looks like a wire going into the end of a device about the diameter of a pencil that then goes into the exhaust pipe right before it makes a 90 degree turn towards the rear. Its tip is quite larger than the body of it and it will be sticking out of the pipe on the passenger side. If you are looking for the post-cat. sensor, it is located a little more than half the distance to the rear of the car and is also in the exhaust pipe. I hope this is helpful. If further assistance is needed, just ask. daman155

Dodge does not use inertia/reset switches. The fuel system is computer controlled with relays.

Should be located in a removable a housing at the engine end of the upper radiator hose Drain about 1 gallon of coolant from the radiator Remove this housing Note how thermostat is installed Clean both surfaces Replace thermostat and gasket Re-install housing Start engine and look for leaks Run engine to normal operating temperature with heater on Re-check coolant level

Look under the dash there should be a panel you can take off and there are a bunch of fuses (left hand side under the dash) or look at the engine right hand side up top there are a bunch of fuses up top i can't remember off hand which one but those are both your fuses for the car it should be located in one of those two spots.

The four cylinder has two thermostats in the housing where the upper radiator hose attaches to the engine. The v6 thermostat is under the housing where the upper radiator hose attaches to the engine also.

Yes, there will be some modifications you have to do besides the turbo and intercooler and exhaust pipes for them. Turbocharged motors need better airflow then what comes stock on an engine. You should consider a cold air intake and atleast 2.5 inch turbo back exhaust with a high flow catalytic converter. You also need to find out how much boost the stock internals can take before you damage the engine. Once you get everything installed you will need to have it tuned as well. A dyno run performed by someone who knows what they are doing should be able to tune it from that information.

Racing technology or road and track.i thought its was rally/touring

just changed my transmission fluid, filter, and gasket, in 96 dodge avenger 4 cylinder. took roughly 3.5 quarts or, just under a gallon to fill it bk up, my advice is put 3 quarts in run it till its about normal operating temp then shift gears usually from drive to reverse and let everything soak in, then shut it off dont shift gears more than a min or so, and check your level till you get her just right. best of luck pal....D

The gross weight of the 2014 Dodge Avenger is 4600 lbs..

check under the fenders, i know it sounds strange but people, have been known to cause a lot of damage by improperly connecting booster cables to their vehicles, so many companies hide the batteries.

dodge, generally hides them under the front wheel well inner line (inner fender), turn the wheels all the way one way or the other and look under the exposed side, u should see a square of plastic with one or two screw type latches securing it, turn these and u should gain access to the battery.

DO NOT ATTEMPT TO REMOVE THE BATTERY IF U DONT KNOW WHUT YOU ARE DOING

u can severely damage your car or cause an extremely violent explosion.

Happy motoring.

There are two fuse boxes... one under the dashboard on the left, another under the hood behind driver's side headlight.

22mm

on the side of the shifter facing the driver there is a rectangular button. if it's pushed in then OD is on. If it's sticking out, OD is off.

in the oil pan

Blue exhaust smoke is burning oil.

You have a clogged up a/c drain tube that is located on the passengers side but being a 2008 model Dodge should take care of this under warranty...........

The 2010 Dodge Avenger has a 4-speed automatic.

if it is the same body as the 2008, remove the front portion of the drivers side front inner fender.

On the v6 its on the front valve to the far left side. You will see a rubber hose which goes into a 90 degree bend into the valve cover, slide that out.. Voila

Your 2.5 liter V6 engine has a timing BELT ( also , it is an interference engine )

The gas tank on the 2011 Dodge Avenger holds 16.9 gal..

The 2013 Dodge Avenger has double overhead cam (DOHC).