answersLogoWhite

0

Ford Trucks and SUVs

Trucks and SUVs are among the extensive product lines manufactured by the American automaker Ford Motor Company. Some of the models that belong to these product lines are the Ford Escape, the F-650, the Ford Transit and the Ford Cargo.

2,071 Questions

How to replace heater core for Ford 1975 truck?

Just did it on my 76, this is the only place I found any info and is a great site for all repair related info too. Hope this helps. Just did it on my 76, this is the only place I found any info and is a great site for all repair related info too. Hope this helps. http://www.ford-trucks.com/article/idx/12/089/article/Heater_Core_Removal_and_Installation_For_19731979_Ford_FSeries_Trucks.html

Where is the axle ratio code for 1996 ford explorer?

Should be on a sticker on the end of the drivers door D 4 - ( 3.73 traction lock ) " limited slip " D 2 - ( 4.10 traction lock ) " limited slip " - Eddie Bauer with 16 inch wheels 41 - ( 3.27 conventional ) non limited slip 42 - ( 4.10 conventional ) " 43 - ( 3.08 conventional ) " 45 - ( 3.55 conventional ) " 46 - ( 3.73 conventional ) "

What type of battery does a 99 ford truck diesel 350 use?

Two of the biggest 12 volt batteries that will fit under your hood. It takes a lot of amps to heat glow plugs and turn over that motor.

No spark on 1999 Ford F-150 what can it be?

Bad Coil,

Bad ECM.

Broken timing chain.

And the list could go on & on & on..........

How do you change a power steering pump on a 1995 Ford F-150 5.0L?

Get a manual on your truck from DISCOUNTAUTOREPAIRMANUALS.COM and it will help on the next repair also.

New HeadlineA manual is always useful. I recommend you have one for every car you own. The answer to your question however, depends on whether the pump is captive or not. The captive style pump must be removed along with it's bracket and have the pulley pulled with special tools(that can be rented at most autoparts stores), then it can be unbolted and replaced. The pulley then needs to be pressed back on, which is difficult due to the plastic reservoir and ungainly bracket. You may be able to simply unbolt the non captive pump. If not the previous procedure will work.

Where can you find an owner manuel for a 1996 Eddie Bauer Explorer?

Auto wrecker's/ Ford maybe Currently you can view your owner's manual on line Check out the website www.motorcraftservice.com On the left side of your computer screen click on owner guides Select your year and Ford model Select which guide you wish to look at Click on VIEW CONTENT

Which fuse controls the left rear turn signal and brake lights on a 2006 Ford F150 pickup?

I am having the same problem with my 2007 Ford f 150 if you find the answer to your question I would like to know as well

What late model Ford truck frame will fit a 1948 Ford half ton pickup body?

well the extended cab short bed s-10 is a good prospect however the wheelbase is 117", as where the the 89-95 ford ranger 's wheelbase is 113.9 inches and the f1 wheelbase needed is 114" you can also lokk at the 1966 ford pickup it has a wheelbase of 115" but why strip the 66' it really depends on the running gear your looking for I myself and 100% ford and the route I have chosen to use on my project is the ranger. Thanks Ford guy

What could cause a 1994 351 to run rough and smell of unburned fuel?

well i'd give it a tune up new plugs new cap and rotor new plug wires and have timing checked Fuel pressure regulators can also go bad, or your EFI poppets are clogged and you're not getting a full "spray" from them.

What is the drivetrain warranty on the 2012 Ford F-150?

The drivetrain warranty of the 2012 Ford F-150 is 5 yr./ 60000 mi..

Will not start -no spark 1989 ford truck?

More than likely it is your ignition module on the distributer. if not its the coil.

Where is the computer in a 1999 Ford Explorer?

It is in the engine compartment in the firewall right below the passenger-side wiper blade.

What is the transmission fluid capacity for a 1992 Ford F150 ext cab V8 351?

1992 FORD TRUCKS F150 PICKUP 5.8L 8-cyl Engine

CAPACITIES

Engine, with filter..........6.0 quarts[1]

Cooling System, 4-SPD AT 4WD Initial Fill..........16.0 quarts

AMSOIL Antifreeze and Engine Coolant

Cooling System, 4-SPD AT 2WD Initial Fill..........15.0 quarts

AMSOIL Antifreeze and Engine Coolant

Cooling System, 3 SPD AT 2WD Initial Fill..........12.0 quarts

AMSOIL Antifreeze and Engine Coolant

Cooling System, 3 SPD AT 4WD Initial Fill..........14.0 quarts

AMSOIL Antifreeze and Engine Coolant

Automatic Transmission, E40D Initial Fill..........8.5 quarts[2]

Automatic Transmission, C-6 W/ Deep Pan Initial Fill..........5.9 quarts[2]

Automatic Transmission, C-6 W/ Shallow Pan Initial Fill..........5.0 quarts[2]

Automatic Transmission, Initial Fill..........3.0 quarts[2]

Automatic Transmission, Total Fill

4 speed E4OD..........16.0 quarts

4 speed AOD..........12.0 quarts

3 speed 2wd C6..........12.0 quarts

3 speed 4wd C6..........14.0 quarts

Manual Transmission, 5-SPD Mazda..........7.6 pints

Manual Transmission, 5-SPD ZF..........6.8 pints

Manual Transmission, 4-SPD BW T18-19..........7.0 pints

Differential, Dana 60 Front..........5.9 pints

Differential, Dana 60 EX IU Rear..........5.9 pints

Differential, Dana 60-IU Rear..........6.3 pints[3]

Differential, with 10.25 ring gear Rear..........7.4 pints

Differential, Dana 70 HD Rear..........7.4 pints

Differential, with 8.8 or 9 ring gear Rear..........5.5 pints

Differential, Dana 44 Front..........3.6 pints

Differential, Dana 50 Front..........3.8 pints

Differential, Dana 70 EX HD Rear..........6.5 pints

Differential, Dana 80 Rear..........8.2 pints

Transfer Case,Warner 1345..........6.3 pints

Transfer Case,Warner 1356..........4.0 pints

1. When refilling, remove dipstick to provide adequate venting and allow oil to flow into crankcase.

2. With ENG at operating temperature, shift through all gears. Check fluid level in PARK and add fluid as needed.

3. Fill to no more than 1/4 to 9/16" below fill plug hole.

TORQUES

Oil Drain Plug.....15-25 ft-lbs

Transfer case BW 4406

Fill Plug.....7-17 ft-lbs

Drain Plug.....12 ft-lbs

Manual Transmission Mazda 5-SPD

Fill Plug.....29-43 ft-lbs

Drain Plug.....29-43 ft-lbs

Manual Transmission ZF 5-SPD

Fill Plug.....25-30 ft-lbs

Drain Plug.....25-30 ft-lbs

Manual Transmission BW T18 4-SPD

Fill Plug.....25-40 ft-lbs

FILTERS

AMSOIL Ea Oil Filter.....EAO15

Wix Oil Filter................51515

Wix Oil Vapor Filter......46976

AMSOIL Ea Air Filter.....EAA24

Wix Air Filter................46174

Wix Fuel Filter..............33296

Wix Trans Filter.....58929 [1]

Wix Trans Filter.....58937 [2]

Wix Trans Filter.....58939 [3]

Wix Trans Filter.....58949 [4]

Wix Trans Filter.....58967 [5]

1. C6 - 2WD

2. C6 - 4WD

3. AOT - 2WD

4. AOD - 4WD

5. E40D - 2WD

How do you remove the hood from a 1993 Ford F150 pickup?

Strongly recommend having a second person help you!! Pop the hood and remove the 2 bolts at each lever. Recommend using black sharpie to circle where the bolts were on the lever just to keep the alignment right on the hood. Ben

How do you replace the brakes on a 2005 ford f150?

No special tools needed, just the usual: c-clamps, wrenches, ratchet. I believe the caliper bolt is an 18mm, not sure on the slide bolts. I finished in less then an hour the first time I did it.