Where is the starter located on 1994 ford e 150 conversion van?
on the underside of the engine , next to the oil pan bolted to the transmission bellhousing.
Is the Ford V8 351 a small block or big block?
It depends. There is a 351 Windsor, a small block, a 351 Cleveland, a small block, and a 351 Modified, which is a strange mix of big and small block features.
These are referred to as 351W, 351C, and 351M, respectively. The 351W looks just like a 302, only it's a couple inches wider. The 351C has a smaller block than a 351W, but much wider cylinder heads than the 351W. The 351C was offered in both 2 barrel and 4 barrel versions. The 2 b heads had ports a bit bigger than the 302/351W, but the 4b heads had HUGE ports. The Cleveland, although it's quite wide, is still very much a small block. (the block isn't much bigger than a 302's block)
And then the 351M.. I refer to these as 351"Mutant", even though the M really means "Modified". This strange 351 has a hellhousing pattern and engine mounts that are interchangeable with 429/460 big blocks, but heads very similar to 351C 2barrel. The block itself is roughly the same dimensions as a 351W. It's more small block than big block, but a lot of guys refer to it as a medium block. Whatever. I just call them Mutants.
And there you have it.
A real quick way to check is to look at the number of bolts holding down the valve cover. Eight indicates 351C or 351M, Six indicates 351W. Also, 351W valve covers are flat and have a rectangular profile, while 351C and 351M usually have a trapezoidal profile. They never offered the 351C in a truck in the US, only the 351M/(and 400 - a stroked version of the 351M)
How long does brake fluid last in the container before you throw it away?
If it's tightly sealed it will last a year or more.
How do you replace the fuel filler neck on a Ford Econoline Van?
Unscrew it at the top and unclamp it at the bottom.
Ford escort ignition wont turn off after removing keys engine continues to run?
i had the same problem in a 95 escort, the switch itself id bad, if you cant afford to buy a new one, every time you turn the key off unplug the black connector, you will have to take the steering column cover off if your planning on doing that..
i had to replace mine because the black plug was getting really hot and i didnt want further damage done to the electrical..
Where is cylinder number 3 on a ford freestyle van?
On the 3.0 liter V6 engine in a Ford Freestyle :
firewall
1------2------3
4------5------6
front of vehicle > driver
How many gallons does the gas tank in the 2014 Ford E-Series-VAN hold?
The gas tank on the 2014 Ford E-Series-VAN holds 33.0 gal..
What is the spark plug gap on a 1990 ford 250 econoline?
According to one of Fords websites :
For a 1990 E-250 Econoline :
----------------------------------------------------------------------------------------------------
The 4.9 liter / 300 cubic inch inline six cylinder engine and the 5.8 liter / 351
cubic inch V8 engine have the spark plugs gapped at ( .044 inch )
-----------------------------------------------------------------------------------------------------
The 5.0 liter / 302 cubic inch V8 engine has the spark plugs gapped at
( .054 inch )
Where is the Power Lock Relay on 1992 Ford Van?
How do i take my spar tier form under the 1992 ford E-150
What causes an obd-2 code of po261 on a 2006 ford 6.0 diesel?
po261 reads out of the book "Cylinder 1 Injector Control Circuit Low"
1979 Ford econoline fuel pump?
This year of vehicle has a mechanical fuel pump bolted to the side of the engine. Follow the fuel line.
How do you tell if you have a bent push rod?
Which ever one you think may be bent, Just take it out and roll it on a flat surface.
If it is bent bad you will have a engine miss on that cylinder.
Where is the fuel pump cut off switch for a ford Econoline?
I have a 94. The switch on mine is located behind the kick panel on the passenger side. Remove the plastic panel right next to the passenger side door. have a great day. On a 95 it's up high, under the dash, on the plastic panel by the passenger door. The panel said "fuel reset", pointing to a hole. Reach in, feel around, press down - didn't even have to remove anything!
What does code 41 on an obd1 1995 ford probe mean?
OBD1 code 41 = solenoid valve, vehicle speed control