How do you change brake pads on a 1991 gmc sonoma?
1. jack up front end, stand on jackstands.2. remove front wheels. Turn steering wheel for easy access to caliper bolts.3. loosen, unscrew 2 brake caliper bolts (3/8 Allen or Torx tool).4. remove caliper from spindle/knuckle. 5. compress piston of caliper, into caliper using one brake pad against the piston and a large "C" clamp.6. inspect caliper, replace if necessary. Clean mating surfaces with wire brush7. inspect rotor, replace or resurface as necessary.8. some people use silicone on the back of the new pads to lessen brake noise.9. install new pads. match new pads to old pads to ensure you have the correct side.10. install caliper, tighten caliper bolts to roughly 30-40ft lbs11. do the same for the other side.12. get in vehicle, push brake pedal to floor slowly, hold, release, repeat 4 times until brake pedal height builds up.13. check brake fluid level, add if necessary.14. reinstall wheels, remove jackstands & lowerr truck.15. drive & test.
How many fuel injectors in a 2003 4.3 v6 vortec x code?
how many fuel injectors in a 2003 4.3 v6 vortec x code
turn wheels hard to the right .....jack up drivers side.....reach in past drivers side front wheel....lift rubber splash guard....and with a trouble light you can see the plugs and wires.
still hard to access but with the proper spark plug socket it can be done....if they are original the spark plug boot will not come off easily....so rotate the boot back and forth and it will pop off .
Cause of high fuel consumption on a efi?
High fuel consumption on an EFI could be caused by a bad O2 sensor. Another reason for high fuel consumption is a dirty air filter or oil filter that needs to be changed. Electronic Fuel Injection vehicles are also famous for clogged fuel injectors.
Where is the neutral safety switch on a 1994 GM Sonoma?
It is located under the vehicle on the driver's side of the transmission. If you are going to change the switch yourself make sure you have all the proper tools including a jack to raise the front end.
Where is the fuse for power windows located in a 1992 gmc sonoma?
My 2003 has a fuse box in the engine comparment driverside fendewell labeled fuse relay center.
What size speaker are in a 1996 sonoma?
With the Extended cab models they come stock with 6.5" speakers in the doors and 4x10" speakers in the rear. 4x10's are goin to be a little expensive due to the odd size.
as long as it's the same type.. 1 piece grille
How do you adjust ignition timing on 93 gmc sonoma?
PROCEDURE:
Set timing under the following conditions:
Connect timing light and adjust to specification by loosening hold down bolt and rotating distributor. See: Specifications
Tighten hold down and recheck the timing. Stop the engine and connect SET TIMING connector. Clear ECM trouble code by disconnecting ECM power source. With engine at operating temperature, drive vehicle at part throttle with moderate acceleration and decelerate to idle condition. This will "teach" the ECM/VCM and return the engine to normal performance.
Why does your manual transmission fight to go into gear every once in a while?
Your synchronizers are worn out.
Where is the fuse box on a gmc sonoma?
On a 1995 there's one located on the indside of the drivers side dash. Other than that... I'm still looking.
On a 1995 there's one located on the indside of the drivers side dash. Other than that... I'm still looking.
on a 94 open the drivers door and there is a panel on the side of the dash.
On a 1995 GMC Sonoma the fuse box is on the driver side . Open the driver door and box is on dash. ( Open the little door )
see where the wiring loses power. trace it back, starting at the pump, and go all the way back to the relay
Where are the freeze plugs in a 1996 gmc sonoma?
Where are the freeze plugs located on a 2003 GMC Sonoma 4.3L Vortec engine?
Where is the starter relay on GMC Sonoma?
in the fuse box under the hood, driver's side.
I have a 1996 GMC Sonoma 2.2
I have about the same question?If anyone can answer for me?
Does the starter relay cause the ignition switch to have a delay when starting?
Seems I have a 1-2 sec.delay when turning the ignition key seems not right.Is this normal?
Also?
I have a brand new starter & Battery installed 3 months ago.Now it won't hit a lick.If I turn the ignition key over a few 20 times maybe it will startup.
Could it be a starter relay?
Has anyone tried to swap a 4 cylinder in a 1991 GMC Sonoma with a 4.3L V6 from a 1991 Chevrolet S10?
This is possible to do but there are a few things you need to know first. A) Are both engines for a 2x4 or a 4x4? They must be the same type of engine. B) Check the bolt patterns on the transmissions. You have to make sure that the transmission from the Sonoma matches the bolt pattern of the S-10. C) Make sure you are changing all the engine parts including the brain box.
Where is the turn signal flasher on a 1997 GMC Sonoma?
The question is for a 1997 sonoma however the answer refers to a 1994 sonoma, and after trying this on my 1997 sonoma with no luck I found the answer under "Where is the flasher unit on a 1997 Chevy S10?" which is exactly where I found the flasher units for my 1997 sonoma and it was indeed the right flasher unit which was for the signal.
AnswerI have a 94 Sonoma and to locate the turn signal flasher, inside, under dash, on left side is a plastic sound protector, mine had 3 screws holding it up, drop this down and straight in you will see a 1" round thing - this is the flasher, pull it out and replace with new one (there are two flat prongs that plug in). It appears this is a well guarded secret!It sounds like a bad thermostat. I would have the radiator flushed and have the cap and hoses checked as well.
What is the gas tank size for 2002 GMC Sonoma?
on a 2dr or ext Cab the Tank is 19 gal. On a Crew cab it's 18 Gal
How do you replace the driver side mirror on a GMC Sonoma?
you need to pop the plastic cover and loosen the nut inside
What is Williams Sonoma known for?
Williams-Sonoma is a retail company based out of San Fransisco, California. They specialize in kitchenwares, housewares, home furnishings and some specialty foods.
Parts diagram for 1989 S10 steering column?
i had the same problem. here are some links that may be helpful. http://www.chevyasylum.com/column/tiltcol.html
http://www.autozone.com/az/cds/en_us/0900823d/80/12/b6/8c/0900823d8012b68c/repairInfoPages.htm
just paste them to your browser. the auto zone link has a lot of info on the right hand side of the page. hope this helps. pappy
How do i change The timing mark position on a 96 gmc sonoma?
what do you mean by change there is only one position for the timing mark and that t.d.c. top dead center