0
Oldsmobile Ninety-Eight
The Oldsmobile Ninety-Eight (98) was a full-size automobile manufactured by General Motors from 1941 to 1996. This model featured the highest-grade exterior and interior trim, as well as the Twilight Sentinel.
412 Questions
How do you replace transmission on a 1984 Oldsmobile ninety-eight regency?
If your car is that old and you aren't trying to restore it for a collection you probably should get a new car
What is the weight for a 1985 Oldsmobile regency?
The curb weight for a 1985 Oldsmobile Regency is approximately 3,500 pounds. This weight does not include any modifications made to the vehicle.
What is the oil capacity for a 1993 Oldsmobile 98 Regency Elite?
4.5 quarts w/o filter and 5 quarts with filter.
Diagram for 96 Oldsmobile eighty eight vacuum lines?
Get a chilton manual its in the back of the book its well worth it there 25.00.
What is a spark plug order on a 1991 Oldsmobile ninety-eight?
For your 1991 Oldsmobile 98: Firing Order 1-6-5-4-3-2 Standing in frony of the vehicle the cylinders from left to right are 1-3-5 and the farthest one on the backside are from left to right 2-4-6 NOTE: There are 2 different motors used this year. The Canadian motor produced runs in reverse order. But this motor is very rare as they only istalled approx. 500 of these motors in the 1991 model. Most of them were used in following year.
Where can you find a diagram of a 1983 Oldsmobile 98 engine?
The Haynes manual or Chilton manuals will both have those diagrams. They are available at most auto parts stores.
How do I Replace a engine control module on a 1991 olds 98?
1. Disconnect the battery
2. Label all spark plug wires so that they can be reattached in the exact positions on the Coil packs.
3. Unhook the spark plug wires from the coil packs.
4. There are usually 2 bolts holding each coil pack to the Ignition Control Module. undo all bolts and the coil packs should come off.
5. The wafer the coil packs are attached to is the Ignition Control Module. Where the wiring harness attaches to the ICM, there is 1 or 2 screws too detach the wires. Undo these screws.
6. On the new ICM place the new gasket onto the ICM, inside the area where the wires attach, be careful not too bend any of the wire prongs inside. I find a small flathead screwdriver and minimal pressure works well.
7. Place the gaskets onto the prongs where the coil packs attach. Again do not bend the prongs.
8. Attach new ICM back to the wiring harness.
9. Seat the CoilPacks onto the ICM and seat the coil packs onto the ICM using the bolts to hold them on. Align the bolts with the holes to mount entire assembly back to the motor. You can attach ICM first to motor then attach the coil packs. The bolts that hold the coil packs to the ICM also hold the ICM to the motor. Tighten all bolts.
10. Reattach the spark plug wires to the coil packs IN THE EXACT SPOT they were before removal. Getting the order wrong can really kill your engine.
11. Reconnect your negative battery cable and everything should be okay.
Flap that opens and closes the trachea?
The epiglottis is a flap of cartilage that opens and closes the trachea. It is located at the root of the tongue.
What is the oil pump bolt size for a 455 Oldsmobile block?
In order to remove the oil pump off my Olds 455, I had to go out and purchase a 12 point 9/16th socket. All I had were 6 points in my box. By using this socket, I was able to remove the pump....no problem. The actual bolt size is a 3/8-16 (course thread).
How much horsepower does a 1972 Oldsmobile 98 with a 455 4v have?
There were 4 engines available in the Oldsmobile 455 4V, a 225, 250, 270 and 300 HP.
How much does a 1991 Oldsmobile ninety eight regency elite sedan weigh?
how much does a 1991 oldsmobile regency elite weigh
Where is cooling sensor on a 1991 olds ninety eight?
sits on the right side of the block under the throttle body. has a yellow and black wire going to it. drain coolant before removing.
How do you reset 91 olds ninety eight computer?
brake vacuum line location on the 1991 oldsmobile regency 98
Where is PCV valve on 1989 Oldsmobile 98?
PCV Valve is located near front of hood on the engine block between the fuel injectors.
How do you replace the thermostat located on a Oldsmobile Ninety-Eight?
Follow the top radiator hose over to the engine and where it connects to the thermostat housing. There should be two bolts holding the housing to the motor. Remove the housing and replace the thermostat and gasket. The larger side of the thermo goes in the engine.
Where is turn signal flasher on a 1998 Olds delta 88?
Under the instrument panel on left side. There is a hush panel. (Plastic cover with three screws and a speed nut). Remove panel, flasher is fastened on top of fuse box under this panel. Difficult scale, 1 to 10 it's a 1 (one).
How do you replace the heater core in your 1998 Olds Intrigue?
it is in the middle of the car inside thedash area on the very bottem of the coverd areA back by the foot area you need 7mm and alot of time about 2 hours to change it
Where is the blower resistor on a 1995 Oldsmobile 88?
The blower resistor is located behind the glove compartment. Remove the glove compartment. Right in front of you is the resistor, and is held by two screws, and i believe three wires. You can buy one only from the dealer for around $30.00. I had to change mine, the only problem is that i do not get height speed. Go to a junk yard, and take one off.
Goog luck
What is the firing order for a 1990 Oldsmobile Ninety-Eight 3800 V6?
just had it done 1-6-5-4-3-2 front 3 cylinder odd numbers 1-5-3 back 3 cylinders even numbers 6-4-2
How do you install a water pump on 1964 Oldsmobile 98?
First remove all hoses, then remove the radiator, then remove the bolts of the water pump pulley (the big one in the middle of the engine), then remove all belts, you will see some bolts which fasten the pump to the block (around where thepulley was) take them all out and the water pum will be loose and easy to be removed.
Is there abs on a 1984 Oldsmobile 98?
no, there isn't. The Oldmobile 98 that you have is equipped with front disc brakes and drum rear brakes.
