0
Remote Control Devices
A remote control device is commonly an infrared device used to control electronic devices such as televisions and DVD players. It is usually powered by AA or AAA size batteries.
2,009 Questions
What is the address for Dollar Tree Stores Inc corporate office?
The corporate address is : 500 Volvo Parkway N/A
Chesapeake Va 23320
Phone Number : 757-321-5000
Toll free number 1-800-876-8697
What is the code to program a Philips universal remote for a Direct TV DVR Pus box?
There are several sites that offer Philips remote programming instructions. A link is provided.
Where is the sync button on the wii?
it is on the front when you open up the ds card slot and its the red button
Does an active subwoofer have and rca plug?
It depends on the subwoofer. Every subwoofer is different. Some do and some don't.
Where can you find cheap universal garage door remotes?
When I was looking for one I found a good site. Check it out, in the last few days they've been adding a lot of stuff. See the Related Link shown below.
How do i get the writing off the bottom of the tv screen on direct tv
Zenith remote codes for a symphonic television?
The zenith universal remote codes to program a symphonic television are 0091, 0053, 0155, and 0126. A universal remote can be used to operate a number of brands of one or more electronic devices.
How much does it cost to operate a remote controlled ceiling fan?
Very little. Most electric fan motors of household size use just a trickle of current.
What does bump proof ANSI grade 1 rated deadbolts mean?
Well lets start with what the term Bump means. Bumping is a technique that locksmiths and now criminals are using to open locks instead of the old standard method of picking them. In short a person has a key that the same type as the lock you have i.e. you have a Kwikset lock and key, the person bumping the lock would also use a Kwikset key. They would put their key into your lock and use a small hammer or object to hit the key which causes the pins in the key cylinder to jump out of he way and allows the person to turn your key cylinder and unlock your door. Thus why it is called bumping. So the first part of the Bump Proof means that the lock is not able to be bumped. The second part ANSI grade 1 is a rating used by the American National Standards Institute to determine the amount of wear and tear a lock can handle. Grade one is the highest. So the second part of the question means that you have the highest grade of deadbolt. Typically a Bump proof lock is a keyless lock using a keypad for entrance rather than a key way thus eleminating the ability to be bumped. I am including a link to one I found online at GoKeyless.com http://gokeyless.com/product.php?id=131&main=1 I do not know if it is a grade one or not but it is only one example. You can buy other bump resistant keyway locks and deadbolts but unless there is no keyway at all it is really tough for it to be 100% bump proof.
Is there a battery in a meRcedes C180 remote key?
Yes there is ....you'll need a thin-blade screwdriver (or even a kitchen knife) to slide back the sheath on the back of the key fob to reveal the battery.
How do you program remote for 1997 Acura TL?
Acura Keyless Entry Programming Instructions 1998 2.5TL with factory-installed security system 1996-98 3.2TL with factory-installed security system
Preliminary Information: 1) This system accepts up to two transmitters. 2) Entering the programming mode cancels all learned transmitter codes, so none of the previously programmed transmitters will work. You must reprogram all the transmitters once you're in the programming mode. Programming the Transmitter(s): 1) Sit in the driver's seat and open the driver's door. 2) Push up the driver's door master power door lock to the unlock position. Hold it there for the rest of this procedure. 3) Insert the key in the ignition switch and then remove it. Repeat this four more times within 10 seconds. (Steps 3 and 4 must be completed within 10 seconds, or the system will exit the programming mode.) 4) Insert the key in the ignition switch. Make sure the power door locks cycle to indicate that the system has entered programming mode. 5) Press the "LOCK" or "UNLOCK" button on the transmitter. Make sure the power door locks (all except the driver's door) cycle to indicate that the transmitter has been accepted. 6) To program a second transmitter, press its "LOCK" or "UNLOCK" button within 10 seconds. 7) Release the master power door lock switch to exit the programming mode. 8) Remove the key from the ignition and confirm proper operation of all remotes.
it is leakage in your cp150 120& 114 capacitors located on the flb circuit board should be green capacitors. with gold writing if bulged they are leaking if u can locate them heat them up with hair dryer for a couple minutes then power on t.v. usually works i did then just leave tv on u can buy these capacitors at tv repair world.com along with instructions for about $25.00
What are the codes for living solutions atc 1311 a17g1311?
I need the codes for my universal control remote living solutions Item A17G1311
What is the Difference between traxxas stampede and traxxas rustler?
Traxxas Stampede
The Stampede is a monster truck, more for offroading. It will not go as fast at the Rustler (around 5-10mph difference) but is still a very good truck. Stampede is one of the best truck to start with.
Traxxas Rustler
The Rustler is like a hybrid, it can go offroad and onroad. You can set it up with onroad tires and adjust the suspension setup to your liking. It's very versitile and light. It also very wide so it will not flip over through sharp corners like the Stampede may.
The remote could be in a few different places. Here are some of the most common places to look:
- Couch cushions
- Behind the TV
- Bedside table
- On top of the TV
- Remote storage box
Take a few minutes to search these places and you should be able to find the remote.
Can the music port still be used without a remote on a Panasonic SA-EN26?
No. And don't buy a new remote. Save yourself the trouble and buy a new AUX player.
We all almost use An IR remote controller to use operate a TV OR DTH OR any other electronics Gadgets in out home but ever you think how this process works means when you press any key in front of your TV then it react as per command given by you …..
Lets know how it happen ..in very simple words , no more technical depth..
A IR Remote Controller works in a line of sight “means the operating device must be placed in front of Remote controller” as a Transmitter (means will send signal from itself) and transmit an IR (Infrared) modulated (coded) signal (binary command codes in electronics engineering language) once any keys of the Remote controller pressed by you then a signal corresponding to pressed key will transmit and carrying a command which hit to the IR Receiver of electronics Device which is mounted in the front panel of your TV (mostly hidden not seen in front side of device) or any Device it must be in front of you ( it can be TV, STB , DTH , AC , etc ) and then receiver demodulates (decode) the receiving signal and activate the desired required function/command sent to the receiving device through the inbuilt Programmed microcontroller . All this activity happens in a very short time in micro seconds. you can see a little glass bulb type component in front of every IR remote and that is mainly a IR LED which transmit the signal towards to any receiving device….and rest of the all above said process happened..
What is Air craft control or RCA?
It is the same w/ RCA or remote control aircraft or airplane.It is called RCA because it is controlled by an device called remote or remote control!!!
Comcast remote code for Mitsubishi?
I went to Microsoft Live Search (http://www.live.com) and I typed the question, "What is the Comcast Digital Cable remote code for Mitsubishi?" I clicked on a link, and the following web-page had information about all cable television stations, but I DIDN'T find any information based on the Comcast Digital Cable remote code for Mitsubishi. Hopefully, another WikiAnswers.com registered user, that views this question, will find the, "correct" and, "accurate" answer for this question.
