0
Toyota Highlander
Also known as the Toyota Kluger in Australia and Japan, the Toyota Highlander is a 4-door, midsize crossover sport utility vehicle (SUV) produced by the Japanese auto builder Toyota Motor Corporation since 2000.
1,728 Questions
What is the gross vehicle weight of the 2013 Toyota Highlander-Hybrid?
The gross weight of the 2013 Toyota Highlander-Hybrid is 6150 lbs..
What is the basic warranty on the 2014 Toyota Highlander?
The 2014 Toyota Highlander has a 3 yr./ 36000 mi. basic warranty.
Why didn't your airbags deploy?
It depends on your vehicle. Majority of cars made after 2005 are equipped with the new advanced airbags or aka "3rd generation" airbags. Your car can actually take into effect how far you are from the steering wheel, if you're wearing your seat belt, how much you weigh, etc. and based on those fact decide during an accident if your airbag is needed. Although trust me, the car doesn't always make the right decision.
How do you remove the spare tire from a Toyota Highlander?
First, remove the plastic tool tray (inside the vehicle, at rear , under carpet). You must then loosen the nut with the bar provided.
Toyota Highlander remote programming?
# Start with the key out of the ignition. Open the driver door (all other doors are closed). Driver door is unlocked (other doors don't matter). # Perform these steps within 5 seconds ## Insert the key into the ignition (don't turn it) Pull key out ## Insert the key into the ignition (don't turn it) Pull key out # Perform these steps within 40 seconds ## Close, then open the drivers door. ## Close, then open the drivers door. ## Insert the key into the ignition (don't turn it) and pull it out. # Perform these steps within 40 seconds ## Close, then open the drivers door. ## Close, then open the drivers door. ## Insert the key into the ignition and leave in the ignition. ## Close the drivers door
Turn the ignition to ON (as far as you can go without cranking the engine), then back to off . ## Remove the key from the ignition. # Within 3 seconds, the power door locks should lock then unlock automatically indicating successful entry into programming mode. Return to step 1 if the locks do not cycle at this point. # Perform these steps within 40 seconds ## Press the lock and unlock buttons on the transmitter simultaneously for 1.5 seconds ## Immediately after letting go of the lock and unlock buttons, press the lock button by itself and hold for 2 seconds. Within 3 seconds, the door locks should lock then unlock once indicating successful programming. If the door locks cycle twice, repeat steps 6a and 6b as the remote was not accepted. # Open drivers door
Why is your Brake light not working on 2001 Toyota Highlander?
If none of the three stop lights are working I would first suspect the fuse for the brake light system - but assuming you've already checked that - I would move on to the brake light switch. Look carefully at the suspended brake pedal and follow it up under the dash. Towards the top you should see a push switch with a plastic plunger coming out of it that rests against the pedal rod. It may be out of adjustment or it may have gone bad. Lastly - rare, altho possible, the three bulbs may have failed.
How do you change a 140a Alt fuse on a Toyota Highlander?
steps to change 140a 2004 toyota highlander
How do you change a timing belt on a Mazda 626 1999 6 cylinder?
the easiest way to change the timing belt is to remove the grill, center section of the radiator support, and the radiator and fans. Leave the airconditioner condesor there, it would be more difficult to remove. Once all that has been removed you then have to remove the blelts, the tensioner (completely) and the crack pully. then you have access to the timing chain cover, which you then remove and there it is. A tip when replacing the belt is to also replace the water pump since you already went through the trouble. I just did all this yesterday and the water pump cost 39.99 and belt was 35.00.
Answer1. slow percausion 2. use a menual step by step 3.starting with cam pully 4.work your way in and out 5. ) AnswerNot to be rude, but if you have to ask, you need take it in.A TB is a project for someone with a good mechanical aptitude (and most likely, a shop manual), it is not just a simple fix, like a bulb or radio, etc. If you do it wrong, you'll likely leak coolant, or worse, total the engine.
Most newer engines are 'interference engines' meaning a timing belt that breaks, slips or has some other sort of misalignment causes physical (costly) damage to the engine's internals.
Usually, it is the valves that get bent, which entails about a $750 repair (in addition to the cost of the belt repair). Worse, a piston or cylinder wall gets cracked, which usually means a new engine, that can become a $2000 expense real quick.
Dealers are expensive, usually 30% more than independent shops on a timing belt.
Find a good local independent shop and consult with them, you will likely spend about $150-$200 in parts, and another $300-$400 in labor. Not cheap, but a lot better then the alternative.
HTH, Mark
ANSWER:
Not to be a prick.. but the dude (Mark) that answered above me most likely works for a mechanic shop. I have rebuilt 4 engines and have done it all by trial and error. Ask questions and/or grab a Chilton manual. The best way to save money is to do it yourself. Just keep an eye on what you are doing and be sure to mark what you disconnect so you don't forget where anything goes. EASY AS PIE!!
What does sterile hybrid mean?
It means that a hybrid species will not be able to conceive a child as it is infertile. In other words, if a hybrid is produced between two species of animals, it will not be able to reproduce.
Where is the fuse diagram in a 2001 jetta?
there should be a card on the door of your fuse panel that has symbols for each fuse, matching each fuse number with its function. the fuse panel is on the driver's side of the dash - you have to open the car door to access it.
How do you disable the seatbelt warning beepers on a 2005 Subaru Legacy GT Limited?
There are two ways. The quickest is pull the fuse out. But only if the fuse is for the seat belt warning. I will tell you on the fuse box cover. The second: there are 6 screws from the radio to the driver door. They hold the face plate on the dash. Remove them then the face plate slowly there are connection clipped on the other side. Then you will see 4 screws holding the speedometer and odometer. Remove slowly there are connection clipped on the other side. Once you get that off. On the other side of speedometer/odometer find the seat belt fuselight its both a light and a fuse. If you remove it the warning will stop. Put it back the way it was and you are done.
You don't, unless you're so used to buckling up that you don't need it. And if you're not buckling up, shame on you
to response above, you obviously don't own a new Subaru. The seatbelt warning chime is beyond irritating. Why do I need to be warned when the vehicle is in park? Yesterday, my passenger warning chimed with nothing in the seat but a couple CD cases.
The easliest way to do it is to go to the junk yard. ( make sure to measure the length/width/ and area around the center hole before walking all the way out there !! And don't forget a sharp knife.) I found mine on a Mazda 626. i got all 4 of them for $4.00. Didnt have to take apart dash... Didnt have to disconect any electrics... didnt have to pull any fuses... took me a total of 1 hour including the 30 mins. of driving there and back.
Why does the Highlander maintenance light come on?
This is basically an "oil change reminder" light. Check your manual on how to reset it.
Where is the oil filter located on a 2001 Nissan Pathfinder?
The oil filter is on the engine towards the front bottom side below the fan cam
Is it necessary to have the power steering fluid flushed on a 2004 Toyota Highlander V6?
I don't have immediate access to the exact mileage - but the factory recommends it be done. Nothing lasts forever and eventually the fluid becomes contaminated with microscopic bits of metal and the anti-oxidants in the oil itself degrade.
Where is the instrument panel light bulb located in a 1988 Ford F150 truck?
There are quite a few of light bulbs on the instrument panel. You get to them from the back of the panel. Some instrument panels can be disconnected and pulled forward enough to get to the back, other panels have to be worked on "in place".
Where is the fuse for the power outlets in a 2008 Toyota Highlander?
I have a toyota hylander hybrid 2006. Just in case anyone is looking for its cigarette lighter's fuse box in this thread it is located behind the little pop out storage compartment to the left of the wheel. You have to pull this compartment out and will find the 15amp fuses both there.
What ground clearance does the 2011 Toyota Highlander have?
The ground clearance of the 2011 Toyota Highlander is 0 ft. 7.8 in. (7.8 in.).
What kind of transmission does the 2003 Toyota Highlander have?
The 2003 Toyota Highlander has a 4-speed automatic.
How do you reset the low tire pressure light on 2010 Toyota Highlander?
Turn the key to the "on" position and press the button (the one along the lower edge of the bottom of the dashboard near your left knee). Then hold the button in until the light flashes 3 times. This resets the system. It's described in the owners manual if you have one.
You must also remember top check the air pressure of the spare tire. All the wheels have the same sensor (including the spare) for the warning system.
What is the firing order on a 3.0 Highlander?
A person should know the firing order of the car they are driving. The firing order of a 3.0 Highlander is most commonly 1-2-3-4-5-6.
Where is rear window washer reservoir for Toyota Highlander 2001?
It uses the same resovoir as the windshield.
How do you change the front headlight 2003 Highlander?
Walmart sells the replacement headlight bulb for less than $8.00 (just thought it wise to mention). You open the hood, and at the back of the headlight compartment, you should be able to see the protruding headlight wires. Just turn anti-clockwise and this should then pull off the entire headlight bulb for replacement. Clockwise turn to secure it back to the headlight compartment.
