0
USB Flash Drives
Universal Serial Bus (USB) flash drives are currently the most common form of portable data storage device. Questions about USB drives belong here.
1,651 Questions
What is analyzing requirements?
- when I plug in my pen drive to the computer and when i unplug the pen drive to the computer , how to know?
- When i plug in my pen drive it is not showing any signs of any pen...
You put it into a USB port in the computer, and the computer will recognize it as a drive, for example, the H drive, and you can drag files on or off of them, and they are rewritable so items can be taken on and off without having to buy a new flashdrive, unlike the CD. They must be ejected safely through the computer, or files may be lost on them forever.
How do you put a '91 Jeep Cherokee Sport into 4 wheel drive?
my '91 was a beast to get in to 4WD but by using the following procedure it was fairly easy. with the vehicle running, apply the foot brake and put the transmission in neutral. with your RIGHT hand, pull back on the transfer case handle until it will no longer move easily (its not in 4WD yet). once you get to this point, put the transmission in drive while at the same time pulling the rest of the way on the transfer case handle. the handle should "slip" right in to 4WD. good luck!
Can you install Steam on a USB and if so how?
No you can't. Even if you could, no USB would be large enough to hold it, even if you only had a small amount of games.
Why isn't my psp charging from my USB?
well if you onlu have you computer connected to the psp because its only a data cable you nned that wall charger that you get with it to charge it and then choose usb mode THEN you can start to charge it on your computer
How you connect pen drive to the taperecorder?
I don't think you can. If it's a digital tape recorder, you can always transfer the file to a computer and then from the computer to the pen drive.
(LIFE SAFETY WARNING! [disclaimer]
Electricity is dangerous!
You can be injured or killed!
Improper installations can cause fire, injury and death!
Meanwhile, CALL A LICENSED ELECTRICIAN!
- - - - - - - - - -
Mastery of the art of troubleshooting is the measure of the knowledge and skill of an electrician.
It is the knowledge of how electricity works, and of the methods and materials used to create a functional wiring system, that enables a skilled troubleshooter to locate the problem and repair it.
Where should the "voltage" be, and how does it get there?
When you understand that, you will understand what is keeping it from getting where it should be...
The only reason there is "not enough voltage" somewhere is because there is a partially open connection providing resistance and a location to allow a voltage drop [bad splice, bad switch, bad breaker, broken wire, burned splice, ...].
If five [5] of the six [6] outlets in the room don't work it is because there is an open conductor somewhere!
I expect, since there are 6 outlets, that this is a big, relatively new house. Since it has a master bathroom [I assume this is the root of the reference to a GFCI], it is not an inexpensive starter home.
The bath GFCI is very likely [absolutely in a newer house] on a separate appliance circuit, which is why it still works.
It is possible, but unlikely, that the sixth receptacle is on the same circuit as the five that don't work [most electricians don't wire circuits that way]
You may have a tripped/bad breaker or there is a bad/failed connection at a device [often because a "speed-wire" connection - those little stab hole terminations - in the back of a device has failed]
And remember that it can be the hot OR the neutral that is open!
: IF YOU ARE NOT ALREADY SURE YOU CAN DO THIS JOB
SAFELY AND COMPETENTLY
REFER THIS WORK TO QUALIFIED PROFESSIONALS. If you do this work yourself, always turn off the power
at the breaker box/fuse panel BEFORE you attempt to do any work AND
always use an electrician's test meter having metal-tipped probes
(not a simple proximity voltage indicator)
to insure the circuit is, in fact, de-energized.
As of November 1st, 2009.
PlayStation 3 - 83,486,934
XBOX 360 - 195,399,343
Nintendo Wii - 199,968,657
PlayStation Portable - 78,064,507
Nintendo DS - 207,947,025
What is the best way to change a starter on a 92 S-10 4.3L V6 standard shift?
Get a Haynes Manual, A Chilton Manual. You can get them at Autozone, Advance Auto, or Napa. They Run under $20. And they are very helpful.
How do you remove write protection form E7-00?
To remove write protection from an E7-00 device, you typically need to check for a physical write protection switch or jumper on the device and ensure it's set to the unlocked position. If no physical switch exists, you may need to access the device's settings through its software interface and disable write protection from there. Additionally, ensure that the device is not connected to a host that has write protection enabled. Always consult the manufacturer's documentation for specific instructions related to your model.
Can you put putty exe on a flash-drive?
Yes, putty.exe is a single executable file which requires no install.
Can someone use a flash drive to load an operating system?
Yes, that is possible for an OS that is designed to be compact.
FE Ubuntu can be installed, and DamnSmallLinux (complete OS on a USB-drive) Just set the BIOS to the target drive (switch the C: to the usb-drive) and you are ready to go!
Why is your flash drive not being recognized on your mac?
There are many reasons why your USB flash drive may be not recognised by your Mac, one of the following may apply;
- Incorrectly formatted flash drive
- Damaged flash module
- Corrupted data
- USB flash drive detection disabled on your account
You should try and use your flash drive on another computer to see if the problem lies with the flash drive, or your Mac. If the flash drive works on another computer, you should check your system permissions, contact your system administrator, or check that the actual flash drive isn't being detected using Disk Utility. If the flash drive does not work on another computer (try both Windows and Mac OS computers), the problem most likely lies in the flash drive itself and should probably be repaired and/or replaced.
What do you mean by Electric drives?
elecric drives are basically big electric motors which are used to drive generators
How do you use a flash drive to back up computer using Windows Vista?
* Information Techn How to Back Up Data to a USB Flash Drive *# Insert the Flash drive into a USB port on your computer. *# Click Start in the lower-left corner of the computer's desktop. *# Click My Computer. *# You should see an icon for the Flash drive in the My Computer window. *# Resize the My Computer window so that when you open the location (window) where the files/folders you want to back up are located, the windows do not overlap each other on the desktop. *# Open the location of the files/folders you want to back up. (There are many ways to locate your files-use the procedure you normally use.) *# Move the mouse cursor over the file/folder you want to copy and hold down the left-side button on your mouse to select the file or folder icon. *# Drag the icon over to the Flash drive icon. *# When a small plus sign (+) appears over the Flash drive icon, release the mouse button. A copy of the file or folder will now be located on the Flash drive. *# To verify that the file or folder has been copied to the drive, double-click the Flash drive icon to open it. The file or folder that you copied should be listed. *# Repeat steps 6-9 until you have copied all the files or folders you want to back up. ologies / Help Center • Newark, DE 19716 • USA
Phone: 302-831-6000 • www.udel.edu/help * Comments * Contact Us * Legal Notices
U plug it into one computer or whatever you want to get information out of, then you can view the files and put files or documents onto it and then you can take it out and put it into another computer and put anything from the flash drive onto it. So basically you take info from one machine and put it into another.
To revert and re-enable the drive access for removable USB mass storage device driver, change back the value data for Start to its original default of 3.
The change will take effect immediately to block any USB mass storage device such as USB flash drive, USB key and portable harddisk from been used in the system, while still allowing hardware components to work properly via USB connection. The hack works in most Windows operating system such as Windows Vista, XP, Windows Server 2008, 2003 and 2000.
For user who dare not to modify the registry manually, simply download the following registration entries file to enable or disable the USB drive. Extract the downloaded content in .ZIP format, and then double click on the .REG file to open and apply or merge the registry values to system.
Download DisableUSBDrive.reg
Download EnableUSBDrive.reg
IntelliAdmin also has a free tool named USB Drive Disabler that automatically change the registry key value accordingly to enable or disable the USB drives on Windows 2000, 2003, 2008, XP and Vista system with just one click. In Windows Vista, the program has to be run as administrator.
Select Disable USB Drives or Enable USB Drivers and then click on Apply to set the registry setting accordingly.
Is a 4 GB USB Flash Drive large enough to back up most files from a computer?
It depends upon the size that you backup. Typically it should be enough!
