answersLogoWhite

0

🚗

Cadillac DeVille

This category covers questions about the Cadillac DeVille, a full-size luxury sedan manufactured by General Motors and sold through its Cadillac division. The DeVille was produced from 1949-2005 and was succeeded by the Cadillac DTS.

3,166 Questions

How do you replace the water pump on a 1996 Dodge Ram that has a serpentine-single engine belt?

I would suggest starting by buying a Haynes Repair Manual for the 1994 to 2001 Dodge Ram pickups. This will include fairly straight forward instuctions on how to replace the water pump.

Purchase a Haynes Repair Manual for 1994-2001 Dodge Ram Pickups. This will help with the basics. My problem was getting the screw-on clutch fan separated from the water pump. I found help at the following link: www.pavementsucks.com/tech/fanclutch.php

....

I used a strap wrench or grip wrench to hold the cluch still while I loosened the nut after the serpentine was removed. A auto mechanic friend said that they always use a hammer and punch to loosen the nut by hitting just on the edges of the nut to start it spinning.

Why might a 1992 Chevy Lumina be only blowing heat to the floor on any setting?

there is a vacumm line under the hood on the right side that is most likely disconnected on the drivers side , take the battery out. it has probably leaked acid. look at where it has been leaking acid. find the broken black hard plastic vacume line - slide some rubber tubing over where the break is.

How do you drain the radiator in a 98 Contour?

Looking up from under the car, the drain is located on the bottom right and corner of the radiator. A large flat blade screwdriver will be needed to turn the drain cap and allow fluid to be released. The drain cap can't be fully removed from the radiator so there is no worry that the cap will get lost.

How do you change the serpentine belt for a 1995 Cadillac Sedan Deville?

Use a socket and ratchet and place on the 95 Deville's belt tensioner pulley. Pull to the side to release tension on the belt. Remove the belt and replace it, then lower the pulley back into place.

Have 1989 cadillac deville changed thermo still no heat Heater clunks if left on when car is shut off also ticking noise under glove compartment in fuse box when car is shut off Help?

You may have some MAJOR electrical problems. If left un-checked electrical shorts can cause fires whether you are in the car or not. HAVE IT CHECKED IMMEDIATELY!!!

The emergency brake is stuck how do you get it to release I hit it several times to try to get it to release and it didn't work I don't know what else to do Someone told me it may be the fuse?

The emergency brake is mechanical not electrical. There is no fuse for the emergency brake. It is most likely that the brake cable leading to the rear brakes is stuck. This is quite common in vehicles with automatic transmissions because the e-brake (parking brake) is not used very often. As a result the cables get rusty and stick. It is also possible that the cable needs to be adjusted.

Where is the thermostat located on a 1996 Cadillac eldorado?

It is NOT on the upper radiator hose, it is where the lower hose connects next to the air filter housing. You do not need to disconnect the hose, there are two 10mm bolts that come off and the thermostat is inside this housing.

How do you change the spark plugs on a 2000 catera cadillac?

The spark plugs are under the throttle body on my 1997 Catera, assume they are in the same place on your 2000. Just unplug the hoses and electrical wire clip/connections, unbolt the throttle body and you will be able to access the plugs.

Where is the ac compressor relay located on a 1992 cadillac deville?

It is located in the relay box under the hood. The fuse for the relay is under the right side of the dash behind the kick panel and is a 15 amp fuse.

Were is the Knock sensor in a Cadillac STS 95?

the knock sensor on a 95 eldorado is located underneath the passenger side right above the trans-axel by the vss switch on the back of the motor, if its knot there its underneath the manifold.

Why is the service stability system message on in your 03 Cadillac cts 03 Cadillac stability control message?

The service stability system message on your 2003 Cadillac CTS usually refers to a problem in your braking system. The problem should be addressed immediately.

How do i remove headlight assembly on 2007 dts cadillac?

Remove front wheel. Remove splash apron. remove air deflector. Remove front bumper. Now you can access the headlamp assembly.Can you give me a diagram

Body control module on 1999 deville?

Behind the back seat on the trunk wall behind the battery

Where is all thefuse box on a 2004 cadillac?

There is one (the main breaker box ) under the hood on the front left side and, there are two under the rear seat.

What is the firing order for a 1966 Cadillac?

The book I have show 63 - 66 Cadillac having the same firing order it is 1 8 7 2 6 5 4 3 With a clockwise turning rotor. The # 1 wire on the cap is the first post past the rear hold down screw in a clockwise direction.

How do you change a 1988 Cadillac sedan deville headlight switch connector?

how do you take out a headlight switch's in a 1998 cadillac deville?

Where is the fuse box located on a 1995 cadillac deville?

There are fuses boxes under the hood and in the trunk on the drivers side on a 95 Deville

How change water pump on 96 cadillac north star?

These engins have an odd set up for water pumps----they are belt driven by the front camshaft (drivers end)--removing the old pump is not to difficult but installing the new one rquires a special too to screw it into the housing ----without that tool it can not be done so if you are asking the question you should probably let some one else do it---If you go to a parts store and ask to see the a new pump you will understand

1996 Cadillac trunk will not close?

is it the electric pul down that isn't operating.

If it is and you cant get a new one, remove it from the car, remove electric motor( the gear on the trunk hold down tends to break, it is plastic).

Disassemble from the top metal plate(2 screws) raise it up and inspect the gear, if missing teeth just hold the gear and rotate the trunk hold down it will lower. Re install in car.

You may have to adjust the heigh to get the trunk to shut correctly just raise or lower the hold down(you can do this while it is in the car)