likely thermostat is stuck.
The temp blend door actuator has failed.
How long will a Cadillac engine last?
i brought a 2000 Cadillac Seville sls...it had 85000 miles when i brought it ,now it has 105000..n now i need to replace the head gasket..job will cost 2500 n car cost me 5500..mechanic told me these things r common with Cadillac cars..way before this problem happened i seen a Seville sitting at a shop with the same problem..can't make your Cadillac cars an everyday vehicle
How do you replace front turn signal on 1990 Cadillac eldorado?
1990 Cadillac Eldorado front turn signal light bulb lamp replacement procedure: Purchase the correct replacement turn signal light bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information and full light bulb part numbers list. Then consult your owner's manual for the turn signal light bulb lamp replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).
Where are the grease zerks on 1991 Cadillac?
if im not mistaken those vehicles came with sealed unit and the only serviceable ones are aftermarket.
Where are the spark plugs on a 1995 Cadillac eldorado?
The Eldorado of 1995 contains a Northstar transverse (sideways) mounted V-8 engine. The spark plugs on the forward bank of cylinders are right in front of you when you lift the hood. Look for four black wires coming out from under the engine shield and going down in to four litte holes on the camshaft covers. The rear bank are a little harder to get to, but they're back there, on the opposite side of the engine.
Where is the other fuse box on a 1988 Cadillac eldorado?
one is in the glove box and one is under the hood near the front on the drivers side.
I had the same trouble. Found it to be a short in the front parking light bulbs. I had to take it to a GM dealer and pay over $100 just to find out it was as simple as that. It worked for me.
Good luck.
Where is the air bag module located in a 1997 Cadillac Eldorado?
SHould be under the passenger side front seat
How do you change valve covers on a 1977 Cadillac eldorado 425 engine?
1. If working on the left side , remove the air cleaner , heat duct and crankcase ventilating breather.
2. If working on the right side remove pcv valve and elbow from cover. Remove Alternator wiring harness from clips.
3. Remove spark plug cables clips from studs and move them out of the way.
4. Remove seven bolts and two screw studs holding cover to head and remove cover.
If removal is difficult , use a hammer and a block of wood to loosen. Do not pry on valve cover!!!
Use Rtv when installing the new gasket. Installation is the reverse of removal. Tighten all bolts to 30 inch pounds. Reattach all spark plug wires and everything else that was disconnected. check for leaks.
Where is the ECM located on a 1994 Cadillac Eldorado?
underneath the dash on the passenger side behind the glove box, sometimes the glove box pulls down to get to it.
Where is the water pump located at in a 1999 Cadillac eldorado?
There is a separate belt on the opposite side of the motor from the serpentine belt. that belt runs off the camshaft and drives the water pump
How many quarts of transmission fluid and oil does a 1975 Cadillac Eldorado Chevy 500 hold?
How many quarts in a a 75 Cadillac eldorado transmission
What freon is used for a 1990 Cadillac eldorado?
There is only one type of freon, but before we go further, freon has been banned due to it's hazardousness to the environment.
How many knock sensors on a 1997 Cadillac eldorado and where are they located?
One Sensor.... Removal Procedure 1. Remove the intake manifold. 2. Disconnect the knock sensor electrical connector. 3. Remove the knock sensor. Installation Procedure 1. Install the knock sensor. Tighten the knock sensor to 19 Nm (14 lb ft). 2. Connect the knock sensor electrical connector. 3. Reinstall the intake manifold.
What refrigerant is used in a 1973 eldorado?
The original refrigerant installed at the factory in 1973 was R12 (Freon). If it has not been converted to R134a, I suggest you convert it now, if it is leaking and needs repair. R12 is no longer in production and the dwindling supply is very expensive. Much cheaper to convert it to R134a.
What would cause a 1997 Cadillac Eldorado to overheat?
Internal combustion engines produce a lot of heat, and need to be cooled. There are three things that carry excess heat away from the engine; air, oil, or radiator fluid.
Whenever an engine is overheating, one of these three things is not circulating properly through or around the engine. Check the radiator and make sure that air can get through. Drain and flush the radiator and coolant, and make sure that there is sufficient coolant (water & anti-freeze) and that it is circulating properly. Change the engine oil.
What would drain battery on 97 cadillac?
Happened to my 97. The alternator went out. Had to replace it and get a new battery. No
problems since.
Where the engine computer located in a 89 eldorado?
inside the car on the front right side. down space the cocpit
Where is the headlight fuse for a 1984 caddilac eldorado?
The headlight fuse for a 1984 Cadillac Eldorado is in the fuse box under the hood. It is in the number 17 slot.
How do you replace the alternator on a 1994 Cadillac Seville STS?
There is a plate under the car on passenger side. Remove this plate and you will be able to see the alternator. I think it has three bolts.
Remove blower motor from 94 Cadillac eldorado?
Blower Motor
Removal & Installation
With Air Conditioning
1. Disconnect the battery ground.
> On trucks built for sale in California, remove the emission module located in front of the blower.
2. Disconnect the blower motor wiring at the blower.
3. Disconnect the cooling tube at the blower.
4. Remove the 4 mounting screws and pull the motor from the housing.
To Install
5. Remove the clamp from the blower case and remove the blower cage.
Mount the cage on the replacement motor.
6. Install the blower motor and tighten the 4 mounting screws.
7. Connect the cooling tube and wiring hardness.
8. Connect the negative battery cable. Check the blower motor for proper operation.
9. Cement the cooling tube on the nipple at the housing using Liquid Butyl Sealer
D9AZ-19554-A, or equivalent.
_______________________________________________________________
Blower Motor Resistor
Raise your hood. Look at Right Hand back firewall. (Passenger side)
You can see the rear of blower motor.
Look beside it there is a plug (I believe to the bottom right)
The small rectangle assembly under that plug is your resistor block.
Remove the 2 bolts that hold it to the firewall and pull it out.
Reverse procedure to reinstall.
Then you will be cooking -w- heat again