0
Car Stereos and Speakers
Car stereos and speakers are audio and video system designed for automobiles. They are commonly composed of two speakers and a stereo system but are also expandable depending on the user’s preference or needs.
3,598 Questions
How do you hook up VCR to amp?
To hook up a VCR to an amplifier, first connect the VCR's audio output (usually RCA jacks labeled red and white) to the corresponding audio input on the amplifier. Then, connect the VCR's video output (typically a yellow RCA jack) to your TV for visual output. Make sure to select the correct input on your amplifier to hear the VCR's audio. Finally, power everything on and adjust the volume as needed.
Set the clock on pioneer deh3900mp?
Turn of the unit - press the volume knob and wait until screen turn off. Then press the volume knob again until screnn will shouw INITIAL X:XX (where X is digits). Change time using up/down and left/right buttons.
What is the best combo for subs and a amp?
the best combo for subs and amps would have to be P.G. amps and jl audio subs
Flipy Floppy
How do you change the rear speakers in a 1992 Nissan maxima?
Open the trunk, release all of the white plastic clips holding down the rear dash. Pull up on the rear seat to remove it. Remove the rear dash and unscrew speakers from the top. Factory connections will need to be cut and wire ends will need to be put on them. In most cases a stock clarion amplifier will run the stock speakers. This should not effect the aftermarket speakers.
Try to use the Nissan speaker adapters plugs so you don't need to cut wires and mess up the electric system, you can get those from eBay or amazon.How can you locate the VSS wire on a 2006 Ford E-350 for a navigation head unit?
Ford E-series vans have a pigtail in the wire harness tucked beneath the drip rail
in the engine compartment. There's a marked speed wire there - grey/black, 8000ppm.
How do you set the time on a pioneer deh-305?
turn the key on but have the CD player off. push and hold the audio button until the clock setting displays
What color are the left front speaker speaker wires?
Not enough info to answer. Please ask a new question and include year, make, and model.
What color is positive and negative?
Typically in 12v aftermarket equipment, Red is 12v positive (+) switched, Yellow is 12v constant and Black is negative (-) But there is no standard.
OEM (original equipment Manufacturer) Factory equipment uses different colors for different manufacturers. Red, Yellow and Black have no relationship to + or - and may or may not be power wires. Never wire anything without an installation wiring diagram.
I have recently purchased 2 10" Kicker Comp 8-ohm subs for the simple reason that I already had an amp that matched the power rating for the subs at a 4-ohm load (amps rating). The amp will put out about 800w @ 2-ohm and 400w @ 4-ohm load (rms values). By running 2 single voice coil 8-ohm subs wired in parallel you are effectively cutting the impedance in half (8 + 8 = 4-ohm in parallel). To do this you simply connect the positive terminal of one sub to the positive of the other sub and then to the positive of the speaker output on the amp. Same with the negatives, sub to sub then to amp. Had I purchased the more common 4-ohm single voice coil subs my load to the amp would have been 2-ohms and too much power would be getting to the subs (100 watts more rms power than the peak power the subs could handle). I did this because of the space I had available and also because the Kicker Comp has performed well for me in the past as an entry-level woofer.
Hope this helps!
How do you find a 9 navigation CD for your 2001 Infinity QX4?
i want to no how i can oprate my nvigation system on my qx4 2001 ples how i can play the navigation system on my qx4 2001 infinti car
How do you unlock a jvc home stereo?
To unlock a JVC home stereo, first try entering the correct password or code if you set one previously. If you don't have a code, unplug the stereo for a few minutes, then plug it back in to reset it. If these steps don't work, consult the user manual for specific instructions for your model or contact JVC customer support for assistance.
How do you enter a radio code on a cd30 radio?
2. If radio turned on, turn it off.
3. Press AS button in, and hold it in while turning radio on.
4. Wait approx 10 seconds (do not release AS button).
5. Radio should beep, and display should now read 10 - - - - (assuming no tries have been made in the past with the wrong code)
6. use pre-set button "1" to scroll the first digit in the display to the number you want (it goes 0,1,2,3,4,5,6,7,8,9 then back to 0)
7. Use pre-set "2" for second digit, etc.
8. Once display reads 10 followed by the four digit security code press and hold AS button for about 10 seconds, until the radio beeps.
9. If correct code entered display will now read "code" briefly, followed by"memory-U" briefly, then radio will reprogram it self.
10. If radio goes back to "safe" the code number is incorrect, or you mis-keyed it.
Note: entering the code incorrectly 10 times will render the radio useless.
After the first 3 tries you need to leave the radio on and the ignition on for increasingly long periods of time before it will let you try again. 7 safe need you to wait at least 30 mins, and more like 1 hour.
How do you set the clock on a jvc kd r200 CD player?
Yes they all can be repaired but its a case of what it will cost verse cost of a new one.
Who said two twelves can not fit in a lumina trunk i have two fifteens and last year i had four twelves.
How do you reset the radio on a 1991 BMW 525I?
Resetting the radio unlocks it and restores it to its normal operating condition. Follow the below procedure to reset the radio.
1) Turn the ignition switch to the "II" position without starting the engine and press the radio power button to turn it on. Wait for "CODE" to appear on the radio display.
2) Press the radio station preset buttons to enter the security code. The radio turns off and resets when the last digit of the code is entered.
3) Turn the radio on. The radio now functions normally.
How do you know which side is positive to hook the green wire too?
Your question is too vague. Please tell us what your trying to wire.
yes, they will be really loud. right now i have only a 250 watt amp pushing bothof mine and they are pretty loud for my small sunfire. even if you have a big suburban or something they will be pretty loud
How can you determine if your 2002 Dodge Intrepid has a factory amplifier?
If it has one, it'll be in your trunk, most likely mounted to the DaffleBoard (The area your speakers are mounted)
Where can you find the make and model number of the stereo in a 1999 Nissan Quest GLE?
The owners manual will list the standard model number that comes with the car. You can gently remove the stereo and look on the back. The model number will be on there. The make should be on the front.
