How much does a Chevy Cavalier weigh?
The curb weight of the 1990 Chevrolet Cavalier base sedan is 2,444 pounds. The fuel tank holds 13.6 gallons, and it uses regular unleaded gas.
What does check gauges light mean 2003 Chevy cavalier?
It means that the hydraulics which operate your fuel and temperature gauges may be leaking or damaged.
One or more of the gauges is out of the normal operating range when engine is running. It could be the oil pressure gauge is reading to low, the temperature gauge is reading to high or the voltmeter is reading to low so, check the gauges.
How do you remove the windshield washer fluid reservoir on a 2004 Chevy cavalier?
2004 Chevy Cavalier windshield washer fluid reservoir retaining bolts. Remove the windshield washer fluid supply tube. The windshield washer fluid reservoir will come free.
Where are the governors on a 49cc engine and how do you take them out?
if this is on a 2stroke the governors are on the throttle handle and the exhaust take the exhaust off at the head and there should be a washer in the exhaust remove the washer. on the throttle there is a screw that stops the throttle from going full throttle remove that screw. there usually by the throttle & to take out just a few screws
How do you replace Chevy Cavalier door?
there are four nuts located on the hinges
disconnect the wiring harness from the door....and remove those nuts.
you might need some help with this.
Where is the idle air control valve located for 2001 Chevrolet cavalier 2.2ohv engine?
Should be right by the throttle body.
What does it mean when a Chevy Cavalier's back tire makes a humming sound?
Bad wheel bearing or there is a problem with the tire itself.
Packet Form
Network+ Guide to Networks
pg. 537
Where is your fuse box in your cavalier?
Open your drivr door and the exposed part of the dash has a removable door where the fuses are located
What is the firing order for a 2003 Chevrolet Cavalier?
1-3-4-2 Number 1 is on the far left standing in front of the car looking at the engine.
Why wont my 99 Chevy Cavalier start?
There are three reason's a car will not start One: it is not getting spark to the spark plugs this can be checked by removing the wire at the spark plug and seeing if it arch's to ground by placing it near a ground object such as the engine block or using a spark tester available at your local parts store if you find no spark at the wires remove the wire at the ignition coil and see if you are getting spark from the coil by the same process. Two: the vehicle is not getting fuel find a friend with a fuel pressure tester and verify that the vehicle has the proper fuel pressure if it does make sure there are no fuses blown to the injectors and that the injectors are getting a pulsed signal if there are no fuses blown if you have your pulsed signal you may have bad injectors but this will more likely cause a miss than a no start. Third: you may not have compression this comes from many problems broken timing chain, bent or burnt valves, worn piston rings etc, to check this get a compression tester remove a spark plug and test for the specified value usually 130-190 depending on the engine best to consult a manual for that well that's it once you find your problem you get into the wonderful world of diagnosis why does it not have what it does not that's why they pay people to fix them for example your computer could be bad it controls fuel and spark you could have a bad sensor if it has a check engine lamp that will lead you to a less vast field of problems but without a trouble code which you can get from a cheap scanner it is wide open
Chevy Cavalier stuck in first gear?
your transmission is stuck in what we call limp mode. Take it to a transmission shop and have an electrical scan done. Does your speedometer work or not ? If not then it could be as simple as a output speed sensor or broken wire
How do you replace brake booster on 1998 Chevy cavalier?
Get ready for some work.you need to remove the master cylinder nuts that hold master cylinder to brake booster.once you remove nuts you have 2 choices remove master cylinder to remove booster. to keep from bending brake lines.or you can leave master cylinder in pull it toward you easily careful dont bend lines .disconnect vacuum line at booster .go inside vechicle to floor on driver side loosen four nuts on floor to booster .disconnect power brake push rod from brake pedal .dont force pushrod to the sides when disconnecting it.remove four booster nuts then remove booster.when in stalling the new booster loosely install four nuts then connect the push rod to the brake pedal .install new clip tighten the booster unit .if you decide to remove master cylinder use inline wrenches on master cylinder to remove lines.also plug the master cylinder brake line holes to keep from losing all brake fluid. Also don't forget to bleed the brakes
Why would the battery light flash in a 1997 Chevy cavalier?
From what I have found there are a few different reasons.
1. Loose connection to the battery.
2. Loose or bad serpentine belt.
3. Alternator is bad / going bad.
4. Your batter is needing replaced.
How old is the battery? If the case is that the battery is dead, then you are going to want to check the alternator also. Since it is trying to charge a dead or dieing battery, it is going to put a lot of wear on it and burn out the diodes inside the alternator.
I would say check the battery with a digital meter, and see what voltage you are getting with the car NOT running... and then check with it with the car running, this is when the alternator is charging or attempting to charge the battery. With the car running running should be some where around12.4-13.6 +/-
yes aftermarket kits are available the electrical components are already in the door
How do you replace a Windshield washer tank on a 2003 Chevrolet Cavalier?
Remove head light, tire, inner liner of fender & than good luck.