answersLogoWhite

0

Chevy Corvette

Launched in 1953, Chevy Corvette is a sports car manufactured by General Motor’s Chevrolet division. Harley Earl designed its first model, a convertible. It is Commonwealth of Kentucky’s official sports car.

4,587 Questions

How do you get to the gears in the headlights on a 95 firebird?

Check out this link for comprehensive information regarding the 4th generation firebird headlight fix. http://www.bfranker.badz28.com/headlightfix/

I am 6'5 and want to know if i can fit in a c6 corvette?

Yes you can! One of the members at www.smokinvette.com that goes by the name of "captnemo" is right at that height and almost 300 lbs and drives a C6!

Where is the spare tire for a 1987 Corvette and the jack.?

Where is the spare tire located on a 1987 Corvette?

Under the back of the car below the CORVETTE, use the lug wrench to lower it the jack is on top of the tire.

1984 corvette diagram of spark plug order?

Firing order is: 1-8-4-3-6-5-7-2

Left side (drivers side) of motor starts at the #1 cylinder (front of motor) and is ordered 1-3-5-7

Right side (passenger side) of motor starts at the #2 cylinder (front of motor) and is ordered 2-4-6-8

Diagram is here:

http://autorepair.about.com/library/firing_orders/bl-fo-13525.htm

How do you replace the fog light bulb on a 1998 Corvette?

Answer

I believe its a 893 bulb. You need to remove the headlight shroud that covers the headlight.(3 Screws) This will have to be done when you turn on your headlights. You can either leave the headlights on and perform the replacement. Or you can turn on your headlights and disconnect them so they stay in the open position. The connector is located just behind of the headlight. Once the shroud is removed you will be able to gain access to the fog lights. To remove the bulb, simply twist the socket counter clockwise and inspect the bulb. It just takes a little time but it can be done.

You will have to have the hood up in order to get your hand in to disconnect the old bulb once you remove the headlight shroud. Also, I hope your hand is "small" enough to fit into the tight space. Good luck! It took me about 5 minutes to replace the bulb.

Whose Faster 66' 427 Corvette or 66' 427 Cobra?

If you have to ask that question you know very little about the Cobra. The Cobra out handled the vette, beat it to 60 and in the quarter mile and had it on top end. Course you could get power windows and A/C in the Vette.

How do you remove shift knob on intrigue?

At the bottom of the knob where it meets the shaft, on the side towards the dash, there is a pin which is shaped like a staple.

Use a small screwdriver to pry the pin out towards the dash, then pull the knob up while twisting it slightly back and forth.

Why were people branded with a fleur-de-lis?

It was a brand-mark on a criminal," done by the French.. it would have been a sign that the person was "owned" by the monarchy.

What engine does the 50th anniversary Corvette stingray have?

The 50th anniversary Corvette came with a Maroon exterior and shale interior in both coupe and convertible. It had the standard or base engine - a 5.7 liter V8 with 350 hp. It often felt like it had more power.

BTW, it did not carry the nameplate "Sting Ray".

How much does a stingray cost?

Kinda depends on the specs but just as an example, 1966 stingray w/ 10k and 4 speed , 400hp - $43,900. But they can run well up to $90,000 depending on the car its self.

Why does my 1991 Corvette idle rough?

A rough idle on the 91 vette could be from a variety of reasons. Bad, worn out, or loose spark plugs. Worn out or damaged spark plug wires could be the cause. It could also be the optispark (Distributor for these cars). I have also seen fuel injectors create a rough running condition on these cars as well. Start simple, and don't go to deep in the beginning look at the surface issues and look deeper as you rule out the most obvious culprits. There are many things on these cars that will cause a rough idle but it is better to rule out the cheap and easy to fix causes first. Check the plugs, do a compression test, test the wires, coil, and injectors and what not before you start throwing parts at it. The compression test is a good thing only because these cars run really hot, and some don't engage the cooling fans until 240+ degrees, so it is possible to see a crack in the head, head gasket leak, ect on these especially if the cooling system has not had a good maintenance record.

Answer

You won't find an Optispark distributor on a 1991 Corvette. The 91 vette has the L98 engine, which uses a more traditional distributor. 1992 was the first year of the Generation 2 LT1 engine that uses the Optispark. It is true that many issues can cause rough idle. Rough idle can often be caused by a vacuum leak. Check for leaks, including a ruptured bladder in the EGR valve, which will act as a vacuum leak. So, that is something else to consider.

What are the timing specs on a 1968 Corvette?

Factory stock ignition timing for the Corvette 327 ci 350 HP is 4 degrees BTDC.

Why dont the lights go down on your 1977 corvette?

The headlights require a vacuum to operate down. If there is no vacuum they remain in the up position. You may have a vacuum leak such as a disconnected or broken vacuum line. I have also seen the vacuum reservoir can rotted out and unable to hold a vacuum.

How do you replace a power antenna on a 2000 Pathfinder?

I replaced my 95. I pulled the front right wheel and inner wheel well (plastic). It is above that on a small bracket. You'll need to remove the special nut on top to lower the ant down. I used (carefully) a pair of vice grips....No problem job.

Where is the horn fuse on a 2002 Suburban?

Under hood. Open fuse box. There are small relays and big relays. It is the big relay fuse closest to the outside of the vehicle. There should be a map under the fuse cover.