Chevy Corvette

The shifting linkage gets worn over a period of time. There are many Corvette supply companies that offer rebuild kits for the stock linkage. The other thing that could be causing the trouble is just plain adjustment. Check your manual and adjust accordingly. Also, I solved the problem on my 68 by changing the linkage arms to the "quick-shift" mode, which is a second set of holes for the linkage to fit into. This came stock on my 68 and I would think it would be the same for 69. It solved the problem and reduced the travel of the stock shifter by about 50%. So, if you want to maintain stock parts, the above would be my recommendation. Check it out, it's worth the time. Good Luck! You don't say if it's four speed with a hurst shifter. I had a 68 and with a hurst and the shifter gates were worn to the point that the shifter would move to third but the tranny sayed in second. First I had to park in such a way that I could get under the car. Then I put the shifter in neutral. I then had to crawl under the car with a hammer and force the tranny into neutral. Once I did that, I could shift it again but if I shifted slowly, it would jam in second, again. Finally had to put a new shifter in. Have fun! j

== ==

I never had a C4 Corvette. I went from a C3 to a C5 so I can't help you but I knwo a great place to get the info you need. I use it all the time anytime I have tech questions. I

driver side of the trans tail shaft.the cable unscrews and it is inside it will be colored.

You have a fuse box under the carpet in the front passenger's front floor board and another fuse box under the hood in front of the passenger's side.

To properly answer this question, one would need to know in what year model Z06 are you referring? I do know that in 2004, Corvette came out with a Commemorative model to Commemorate the two back to back LeMans wins. There were 2025 of these produced. The window sticker price from the dealer was listed at $57,485.00. This figure includes an amount of $4,500.00 for added options, plus $800.00 for shipment to the dealership.

So for a 2004 Z06, a basic Corvette from the factory would cost $52,185.00. Hope this helps.

The 2011 Chevrolet Corvette is 6 ft. 0.6 in. (72.6 in.)12V front power outlet(s) wide.

A 1982 Corvette gets approximately 15 miles per gallon in the city and 25 miles per gallon on the highway. Quality of the engine and gas can also contribute to the mileage per gallon.

no camino has a straight rear vette has independent rear

I cannot tell you the number, however, if you contact the factory in Bowling Green Kentucy, they will be able to tell you. I do know that it was a rare color. We were only allowed one in Reno, and I sold it. It was a convertible, with a black top.

The First Corvette rolled off the Production line In My Hometown Flint Michigan.

Price depends on condition, equipment, engine, and mileage. For instance a fully loaded Coupe can be worth as much as $30,000 in excellent condition with very low mileage, Or it can also be worth one third that is not loaded in poor condition. Click the link and check the equipment and mileage for an appraisal.

well they say it reaches up to 210 but what do you yhink is faster ford gt or corvette .its corvette . wrong .ford gt is so ford gt40 would rip it.

well

The full rune armour set was 300-400k but now its less then 200k.

A rune platebody cost about 60-80k but you can buy it from Oziazh for around 65k but only after dragon slayer.

Go to http://www.corvettefever.com/howto/33098/index.html.

This gives full description for rebuilding C4 headlght drives.

Ecklers has the replacement cable and "Installation instructions" which show how to get the hood open so you can relace the cable. Tried to attach the diagram, but no attachment tool here.

None that were ever released for sale. There were some show cars way back in the day--the original ""Nomad" wagon, for example. But no Corvette offered for sale by the factory ever came with more than two seats.

It takes 5qt engine oil and about 4 gallons of coolant 50% antifreeze and 50% distilled water

It varies, depending on driving habits, conditions, maintenance, and how frequently the car is driven. You can drive one off the lot and if you drive it hard without breaking it in it won't last 10,000 miles. If the car is well maintained, driven easily, not modified, and not left to sit for long enough to dry out the seals, the engine may last as long as 200,000 miles.

There is a slot in the glove compartment that you can put the remote in and leave it there for 30 seconds to program it. Feel free to go to Smokinvette.com and get the full step by step instructions. Good luck!

HEI should have heat sink grease to help remove heat from the brain and usually comes with the kit, some of the aftermarket brains are JUNK right out of the box GM used something called rare earth porcelain that is used in the resistor portion of the brain and made these a very durable distributor, the only other thing I can think of is a bad coil. or a shorted pickup coil (RARE )check the resistance with a new one. jay

six cylinder engine This is a description of an internal combustion engine, the type used to power cars. There are 6 cylinders, arranged in a "v" three on a side and connected at the bottom.

== ==

Passenger side, raise the vette, remove the wheel slip under and you will see it right before the transmission oil pan