answersLogoWhite

0

Chrysler Sebring

The Chrysler Sebring is a range of middle-sized cars manufactured by American carmaker Chrysler between 1995 and 2010. It is one of the few practically priced automobiles available in sedan and convertible body styles.

2,284 Questions

Where is the Horn relay located in a 2005 Sebring Sedan?

It should be plugged into the fuse panel on the lower left corner. There should be two relays there, the upper one is the turn signal relay and the lower one is the horn relay. Hope this helps!!

What are signs of a belt jumping time on a 2003 Chrysler Sebring?

Check engine light, low power, no start, runs rough, bent valves,

Check engine light, low power, no start, runs rough, bent valves,

Where is the ac high pressure switch located in the 2002 Chrysler Sebring LX?

The high pressure AC switch on a 2002 Chrysler Sebring is located on the passenger side of the engine bay. It is paired with the low pressure hose and is mounted near the coolant and power steering reservoirs.

How do you remove the headlight on a 1996 Chrysler Sebring convertible?

Under the hood right above the head lamp are 2 torx screws - 1 on each side. Remove each screw then pull the entire headlamp assembly out. Twist and pull the bulb sockets to remove them.

Does the battery in a 2004 Chrysler Sebring have the capability to recharge itself?

No, a battery cannot recharge itself. The alternator converts some of the engine's energy into electrical energy which is then stored in the battery. If a battery is not getting recharged under normal driving conditions, you either have a problem with the charging system or a failed battery. You can't know without testing. On the other hand, sometimes a dead battery can get what's called a "surface charge". A surface charge just means that when you were cranking last time, you depleated all of the readily available electrical charge. By letting the battery sit for a while, "entropy" has allowed some of the chemical reaction to spread out over all of the battery plates... but the battery cannot "create" electrical energy.

What causes transmission fluid in the coolant holding tank of 2000 Chrysler Sebring if the radiator has already been changed?

When you changed the Radiator did you flush the engine to remove the transmission fluid that the already mixed with your water in the engine block. If not that would explain the presence of the fluid in the coolant holding tank.

What will a Sebring convertible top replacement cost?

Unfortunately the top will cost you around $300 if that's all that is wrong. If you lost the latches or if they are bad you will have to replace those and they will be another $20 or so.

What size tire for 97' Chrysler sebring convertable?

It is listed in your owners manual and on the drivers door post. The correct size is 205/65-15 on the JX

215/55-16 on the JXi

Where is the horn relay located in a 2000 sebring convertible?

Open the driver side door. Remove the fuse access panel by pulling outward. The horn relay is the bottom most black rectangular box closest to the firewall (front).

Where is the radiator cap on a 2002 Chrysler Sebring?

Try as you might to find it, there isn't one. Chrysler put the pressure cap on top of the plastic overflow tank! You need to make sure that cap has a good rubber seal on it when you remove it. [ you DO allow the engine to cool down before removing that cap don't you? ] When removing the cap, you should hear a short "hiss" sound which is pressure escaping from the cooling system (if the system is warm and not cold). Under these conditions, if there is no "hiss" you most likely have a bad cap so replace it! Only $4.80 at Auto Zone. Just do it. Good luck!

How do you get to the brake light bulb on a 2002 Chrysler Sebring?

peel back the trunk liner.....should be two or three screws. unscrew and pull the entire light assembly out its a pain in the but!

Where is a crank sensor located for a chrysler sebring 1996 2.5?

It is on the top rear of the transmission bell housing.

It is on the top rear of the transmission bell housing.

How do you replace the left Multifunction switch on a 2007 Chrysler sebring?

Under the steering wheel column there is a plastic plate with three torx T-15 screws. Remove these then gently pry the top plate from the bottom. Now holding back the top plastic plate you will see a wire harness with four wires which you will want to remove. Next there is a Philips screw on the left located on the switch itself remove this and it should slide straight out. Remove the wire harness with the yellow wires and there you go.

How do you disable the seat belt chime on a 2008 Chrysler Sebring?

Look in you owners manual for enhanced warning system. The instructions are there. Other than that, wear your seat belt, it is the law.

What does p0446 code means on a 2001 silverado?

Trouble code P0446 means:Evaporative emission control system vent control circuit malfunction

Where is a 2006 sebring fuse diagram?

if you were able to look through the driver side door it would be underneath the side mirror. its a plastic panel that has a grip to allow you to pull the cover off and see the fuses. the diagram is on the back of that plastic cover. for the fuses under the hood there is a diagram in the car manual.