Is alter bridge a christian group?
No, Alter Bridge Is A Alternative/Metal Band. Alter Bridge Is Made Up Of Members From Creed And The Mayfield Four So If You Have Ever Heard Those Bands You Know That Alter Bridge Is Not A Christian Band. They Are Just A Bit Soft.
What is the average Train stopping distance?
This question is complicated to answer. It depends on a number of factors. For one, it depends on what type of train it is. A freight train, for example, can take over 2 miles to completely stop. It also depends on what speed the train is going.
Green issues and environmental concerns?
There are a number of important green issues in today's world. For example, environmentalists are concerned about climate change, air pollution, reducing carbon footprints, and recycling, among other things.
What should you do if the lap for steel reinforcement is to short but is already in concerete?
Drill out the edge of the slab and add some dowels.
...or cut the slab back.
Why were bridges and tunnels important to rail roads?
Due to the weights of the vehicles and the low coefficient of friction between a smooth steel rail and wheel, railroads are limited in the sharpness of curves they can follow and the amount of grade, or slope, they can climb.
Is the Quebec Bridge a cantilever bridge?
Yes. The Quebec Bridge, which crosses the lower Saint Lawrence River in Canada, is the largest cantilever bridge in the world. Each cantilever spans 177m, and the total length of the bridge is 987m.
Cement is made , not found. Portland cement, for instance, is made by heating limestone and clay to high temperature (1500 degrees Celsius) and crushing the result to a powder for sale.
The effect of impurity a freezing point of substance?
in polar substances, such as water, ionic impurities usually decrease the freezing point, requiring a lower temperature since bonds between molecules (intermolecular bonding) are disrupted more and more at higher salt concentrations. Organic substances also expereinece a decreaesed melting point when impure, due to one substance dissolving the other and vice versa. In general, freezing points are decreased by impurities if the impurities are miscible in the substance.
Who was the designer of the Eiffel Tower?
The builder, engineer Gustav Eiffel, used a structural design by Maurice Koechlin.
What is an accommodation bridge?
In the UK, an accommodation bridge is a bridge across a canal that was built when a canal was dug across a right of way.
What is the density of most of construction materials?
Does it float or does it not float? If it floats it is lense dense than water, 62.4 lbs/cubic ft. Wood is about 40 lbs/ cu.ft.--it floats. Concrete is 150 lbs. / cu.ft. -- it does not float.
Where is the worlds highest suspension bridge?
8 miles west of Canon City (pronounced Canyon City) Colorado.
What are some structures that may be subjected to fatigue?
Bridges, hydraulic presses, burners.trains
There is no flat conversion from volume to weight; it all depends on the material you need to weigh. Based on some quick searches, it looks like a gallon of sand is approximately 200 oz, or 12.5 pounds. So based on that measurement, it would be about 62.5 pounds. However, not all sand is created equal, and the sand you're using may be coarser or finer or made of an entirely different material. I would take a smaller measurement of 1 or 2 cups, weigh that in ounces, then make your conversion.
Can holes be drilled in a Microlam beam that is 25' long x 3 thick X 16 high?
As a roof truss/I-joist/beam designer, I can tell you that you should not cut ANY holes in a microlam beam without consulting an I-joist/beam designer first. Microlam beams are not calculated to have holes cut in them. This requires special engineering.
Depending on the size of the hole and it's placement, and the load that the beam is carrying you may not be able to cut a hole in it at all. Considering the 25' length (if this is a clear-spanning beam) I can warn you that abeam designer is probably going to tell you to find a different solution for this issue.
Hope this helps!
What is the recommended concrete strength for a basketball court?
A concrete strength of 3500 PSI should be just right for a basketball court.
Why are the main support cables of the suspension cables designed to sag?
They can't be designed not to. Large cables and ropes are extremely different to stretch straight, because of their high weight-to-length ratio.
How does the strength compare between a steel rod and a steel cable of the same weight?
the rod will be stronger, but will break, the cable will bend under force, but not break. the rod has more tensile and shear strength.
Are fire rated doors required on residential elevators in OR?
Yes, the elevator door and shaft needs to be fire rated if it is to be accessed through a garage or if the elevator is to be categorized as a form of egress. Always contact your township official in the design phase as every township may have specific ordinance guidelines.
When did the Lusitania leave port the final time?
The Lusitania departed Pier 54 in New York on May 1, 1915.
In which year was the Dubai tower built?
Why did farmers need to develop a system to contol their water supply?
Because it's VERY unlikely that you have enough water. You're far more likely to sometimes have too much water, and sometimes not enough. If you can control the water supply by storing water when there's too much and using the stored water when there's not enough, you can try to make sure that your crops have the proper amount of water.
The first civil engineering project on Earth was the Egyptian irrigation systems that would collect the floodwaters of the Nile and store them for the dry times later on.
What is the purpose of the box girder?
It is a technique in civil engineering. Parts of a construction are prefabricated it box sections, transported to the site and added to the existing sections. It is particularly useful in bridge building.
What advantages do Fastfoot footing forms offer?
The biggest advantage to the use of Fastfoot boards is that they are environmentally friendly, as far more lumber must be used to form concrete than an equivalent amount of Fastfoot. Additionally, Fastfoot prevents damage to additional equipment, adapts to uneven ground, and prevents water damage and contamination of concrete.