Where can I purchase the J-43651 Saturn 2.2 ecotec water pump tool on-line?
The essential SPX Kent Moore Specialty tool (J-43651) can be purchased at DenlorsTools.com, also a less expensive but very high quality alternative made by Sealy is also available at DenLors (for expedited shipping 1.800.524.9783). See the Related Links for "DenLors - GM Ecotec Water Pump Job" and the J-43651 specialty tool below for more information. In Canada call 1-877-928-0737, it's available for $149.95 or gmail me at georgiansupply@gmail.com
What do you need to change from electronic ignition to points?
There would be a steel resistance wire or some sort of ballast resistor to limit incoming voltage from the key to the hot side of the coil. That would need to be eliminated when switching to HEI. Also, HEI requires minimum 8MM spark plug wires. Then just switch distributors or install the HEI module in the original distributor, and you're good to go.
How can you replace a starter on a 2001 Daewoo Nubira?
Find a Korean and hold a gun to his head and pull the trigger.
We have a 2001 Daewoo Lanos 4dr and had a similar problem ever since we owned it. We had it in for service a lot of times, but the only thing that ever showed was a misfire in the cylinder. They even paid to have the heads re-machined at one point which never helped. Finally, we decided to start using 5W/30 synthetic oil on the oil changes which seemed to have worked. Prior we were concerned about driving the car too far from home, but we've driven it as much as 2 hours away. It costs a little more, but it's worth a try.
Daewoo nubira transmission problems can changing transmission filter fix this?
yes change the filter & the fuel can solve your problem
What does the drum look like on a Daewoo Nubira?
The Nubira has no brake drums, it has disc brakes on all 4 wheels.
What causes Daewoo Nubira OBD-II code P1618?
Trouble code P1618 means: PCM/ECM Internal SPI Communications Diagnostics
How do you fix a power window on the front passenger side of a 2000 Daewoo Nubira wagon?
First, you have to remove the door's interior panel. This is achieved by removing the plastic screws on the sides of the door and the metal screw inside the small tray on the instrument panel. Mostly everything is clipped in, so the best way to continue, is to use a small flat head screwdriver to pry the panel, door handle shroud, and instrument panel away from the door. You must then carefully disconnect all cables and wires attached to the panel. There should be a plastic film covering all the access holes in the door, but if not, just continue to remove the necessary pieces to see inside the door. Take a close look (preferably with a flashlight) at the interior of the door. You should see your window motor, window track, and window regulator. If the issue is your regulator (the pully assembly: looks like a small winch), then the problem should be apparent, because when these parts fail, the cable is usually twisted, frayed, or tangled in itself. The only way to fix the regulator is to replace it. To replace the regulator, remove the four small nuts attaching its track to the door. Then remove the two Phillips head screws attaching the plastic sled to the glass window. Just jimmy the thing out from there. Any of the other problems are relatively easy to diagnose. If it it the motor, replace it. This is achieved by removing the three screws from it that anchor it to the regulator. The other possibility is that the window may be off track. Simply reposition the window's sled back into the track to fix (if possible). The final possibility is that of the switch. Always check and clean the switch first! Cleaning the switch may resolve the issue, but if not, simply replace. I hope this answer has solved your problem! If not, I hope it has at least provided you with a starting point for further diagnosis!
Mine spark plug wells are full of oil in a daEwoo nubira 2000?
The inside cover seal on your Valve cover gasket needs replacing. It's an easy fix. Just be sure to mop up the oil around the spark plugs. It's a good time to change your plugs also.
Where is the water pump on a Daewoo Nubira?
The water pumb is driven by the timing belt. When looking at the front of the car, the front of the engine is on the left. The water pump is located at the bottom left of the engine.
How do you replace coolant water in a Daewoo matiz?
Place a pan below the vehicle to catch the draining coolant.
Remove the surge tank cap.
Disconnect the lower radiator hose.
Drain the coolant.
Reconnect the lower radiator hose.
Fill the cooling system through the surge tank with a
mixture of ethylene glycol antifreeze and water. The
mixture must be at least 50 percent antifreeze, but
not more than 60 percent antifreeze for cold weather
operation.
possible turn signal switch failure common on gm cars
What is the firing order for a 2000 Daewoo nubira?
firing order?
like for starting the car, the firing of the pistons? redefine the question...
Daewoo leganza brake warning light?
This either means that your emergency brake (hand brake) is on, the light switch needs to be fixed, OR (most common) you need to add more brake fluid. Always check your brake fluid first!
Since your question was posted under two categories, (Lincoln LS and Saturn L series) it's difficult to tell you exactly what you should do.
So... the simple answer would be, refer to your owners manual for instructions.
Saturn's usually have a red oil reset button inside the main fuse box (next to the battery). Turn the key on (don't start the engine) then press and hold the button for 10 seconds until you hear the dashboard 'chime', indicating that the oil reset was successful.
Where is the crankshaft sensor located in a dtec engine Daewoo Nubira 2000?
Pull aff ac bracket and the wire will lead you there
Left side tail light isn't working-light bulb is OK it's fuse keeps blowing where is the problem?
Somewhere between the fuse and the bulb
How much to replace the valves in a Daewoo nubira?
Well, you should be looking at $400 to $500 for labor.Then, you're going to spend a few hundred in parts. This would include a new water pump ($50), idler pulleys ($20 or so) and a tensioner (can be $100) (all of these might as well be replaced so the belt doesn't break again).
You'll also need a new head gasket set, valve cover gasket, and crankshaft and camshaft seals (2 if it's dual overhead cam). These will run another $150 perhaps.
Ok, then you'll pay for the replacement valves (5-10 bucks a piece for 16 valves, or just replace the ones that are damaged) and you'll have to get them machined for another $200-300.
Easily $1000 total. Walk away. Car ain't worth it. Or get a mechanic you love.
How do you tell if tappet cover gasket needs replacing?
If your tappet cover is perished, you will clearly see leaking oil coming from the join of the head to the block. If you clean the area thoroughly, you will notice with a day or so of normal running if you have a leak.
Is a doewoo nubira a good car?
my 2003 nubira has 90000 k's on it so far i have had no real problems so yes if you look after your car it will serve you well.
Where is the iat sensor on a Daewoo nubira?
Go to this website. http://www.daewootech.net/how_to_11.htm