0
Ford Taurus
The Taurus is a vehicle manufactured by the Ford Motor Company. Introduced in 1986, it was initially offered as a mid-size vehicle. The Taurus is now offered as a full-size all-wheel drive vehicle.
5,283 Questions
What kind of brake fluid do you use for a Ford Taurus - Mercury Sable?
Per the Owners Manual, DOT 3 type brake fluid.
See "Related Questions" below for more
DOT 3 brake fluid
YES, connect pin 2 of the large conetor to the test plug, turn on the key but do not start it and the check engine light will flash once followed by the codes.
my 92 tempo had a yellow light service engine soon, i had a small computer under the hood replaced, that meters fuel to the car and was shutting off allowing to much fuel into the engine. the cost WA $245 usd but the problem was cured.
AnswerThere is a way to get trouble codes, but it's not like otheres. I know Doge had cars/trucks you could access codes using the light & turning key to 'accessory' twice & then off. With the Tempo/Topaz, there is a 'pin' located in a small plastic box (diagnostic label) under the hood. With a multimeter, +lead, on pin, -lead to ground. But you'll still need a manual to be sure the right pin,(I can't describe it for sure), and to know what the codes mean. I guess the answer to the question is......'sort of'. AnswerOn the firewall, near the strut tower - depending on year and engine depends if it is on the passenger side or driver's side - you will find a connector that looks like a trapezoid. It should have a smaller connector (ground) next to it. It may also say "Self Test". There are six terminals on the larger and the smaller has only one. If you use a sweep hand (analog) multimeter for this procedure, use a piece of wire to connect pin 2 on the larger connector to the negative side of the voltmeter and then use the probe of the multimeter to connect to pin 4 of the large terminal. Make sure you set the voltimeter between 15 and 20 volts. Put the key on the ignition, turn the switch to on (but do not start) and watch the sweep hand do its thing. If everything works correctly it will sweep once pause and then sweep again. This is a Code 11. That means everything is good to go.You can also purchase at most autoparts stores, small engine analyzers that do the same thing without the hastle of pesky wires. It also comes with a book that has all of the trouble codes. But the best thing is it covers most Ford vehicles from 1984-1994, at which time Ford changed from the EEC-IV electronic engine control system to a newer system. The cost for this analyzer is about $30.00. It is truly a must have in your tool collection. It will tell you exactly what is wrong with any electronic engine control problem on your vehicle.
How do you replace cv half shaft Ford Taurus sho?
Take the tier off ondo the center hub bolt unbolt the lower ball joint pop it out move the strut tower over then pry the cv shaft out be carful then ounce out pop the new one in and boult it back together
Cruse control does not work on 2002 ford escape what would it be?
Check fuses
Check Vacuum dump switch located at the upper end of the brake pedal (similar to brake light switch) for alignment and adjustment
Check the center stop light ( I don't know why, but they tell me if center brake does not work cruise will not work.) neither seem to have power but the fuses are all in good condition but no cruse ot traction control please help
What type of antifreeze do you use in a 97 Ford Taurus?
According to the 1997 Ford Taurus Owner Guide :
It came from the factory with a 50 / 50 mix of distilled water and GREEN
color antifreeze ( meeting Ford specification ESE-M97B44-A )
How do you program a keyless entry remote on a 1993-1995 Ford Taurus and Mercury Sable?
All of these instructions are also found in the respective Owners Manuals - See "Related Questions"
This applies to the OEM 4-button remotes.
For Taurus models, 93 - 95:
Locate the programming connector in the left rear quarter panel area inside the trunk. You'll have to pull back the fabric liner to access it. Look for a little black boot about the size of a grown man's thumb. -See Related Links Below-
- Turn ignition to RUN or ACC. Do NOT start the car.
- Momentarily jump pins in programming connector. I just used a kitchen knife. It's very low voltage and the jump occurs directly between the pins so don't worry about any shock. -See link to closeup view in Related Links below-
- All doors will lock then unlock to confirm programming mode.
- Press any button on 1st transmitter.
- Door locks will cycle to confirm programming.
- Press any button on 2nd transmitter (up to 4 transmitters total possible).
- Turn ignition to OFF.
- Locks will again cycle to indicate end of programming mode.
For Taurus models 96 - 97:
- Cycle ignition from OFF to RUN 5 times within 10 seconds, ending in RUN. (this may take 8 times - I'm not sure)
- All doors will lock then unlock to confirm programming mode.
- Press any button on 1st transmitter.
- Door locks will cycle to confirm programming.
- Press any button on 2nd transmitter (up to 4 transmitters total possible).
- Turn ignition to OFF.
- Locks will again cycle to indicate end of programming mode.
Why would a 2000 cougar start but wont idle?
soudns like it is not getting enough fuel, try replacing the fuel filter, if that does not work check the fuel pump
there is a possibility that it may be a vaccum leak aswell. check all you lines.
Where is the button to turn off the overdrive on a 1999 Ford Taurus?
Your transmission gear selector has a " D " next to the " 1 " , if you select
that position it does not shift into overdrive . It just uses the first 3 gears
What is the firing order for a 95 Ford Taurus 3.0 liter?
For the 1995 Ford Taurus , 3.0 Vulcan V6 engine :
1 - 4 - 2 - 5 - 3 - 6
Check engine light stays on what causes it?
The Check Engine Light (CEL) lights up when the Engine Control Module (ECM) detects a problem related to emissions or performance.
Could be a problem with the engine cooling fan , water pump , restricted radiator ,
any body else have any ideas ?
Where is water pump located on a Taurus duratec?
On the driver side of the engine, it is the only thing run by a short belt under the plastic cover which has the 24 valve duratec v6 logo on it.
Oil capcity for Ford 3.0L V6 Duratec?
Pretty safe to say 5.5 quarts, and many owners say the engine readily handles 6 quarts.
What would cause gas gauge to stay on empty when its full 1993 ford Taurus 3.8L engine?
don't know but my 95 Taurus gauge is dead except after putting some clean burn gas additive in the tank. guage worked a little then went dead again. deposits?
What type of brake fluide for a 1998 Taurus?
For a 1998 Ford Taurus :
( DOT 3 brake fluid meeting Ford specification ESA-M6C25-A )
Where is the oil pan for your Ford Taurus?
Bolted on the very bottom of the engine. It is the large pan with lots of bolts around the edge holding it on. I will have one drain plug.
What causes a 1991 Tord Taurus S H O to just cut off while driving?
The cause for a 1991 Ford Taurus to just cut off while driving is probably a problem with the computer. If the car will start again after about 90 minutes, then check the computer module for code errors.
Hmmmm... Coincidence or cause... Interesting question.
See "Related Questions" below for specifics on firing order and plug wires, and then some discussion regarding the check engine light.
Nothing happens, except your wallet will be lighter.
What are the symptoms of a bad speed sensor?
Some symptoms of a bad speed sensor are a speedometer that does not work or stops, a vehicle losing power unexpectedly, rumbling or idling of the vehicle, and transmission problems when trying to shift gears. The sensor has many functions in a vehicle, including ignition timing, fuel regulation, and the operation of cruise control.
How many liters of oil does a 1999 Ford Taurus se 3.0 take?
According to the 1999 Ford Taurus Owner Guide :
With engine oil filter change :
The 3.0 " Duratec " Dual Over Head Cam , V6 engine takes :
( 5.2 litres of 5W-30 engine oil )
