0
GMC Yukon
The GMC Yukon is a full-size sport utility vehicle manufactured by General Motors from 1992 to the present. The car is available as either a two-door or a four-door model. It features a front engine and a rear/four-wheel drive.
1,653 Questions
How do you replace an ignition key cylinder on a GMC?
You have to remove the steering wheel and the turn signal switch. but move to the side. It should be empty. There should be a screw where the cylinder is. Just unscrew that and the cylinder should slide out. And make sure not to push the shaft where the steering wheel attaches too. Its a pain to get if you push it in.
----------------------
There are other concerns....you probably have an airbag in the steering wheel. You MUST disconnect the battery for at least 15 minutes to power down the airbag or it can go off. I usually wait 30 minutes.
You will need a special tool to compress the steering wheel lock plate to remove the snap ring.
You will need a steering wheel puller. Also a Torx drive bit to remove the key cylinder pin/bolt combo.
Just take your time and pay close attention where all the parts go. I wish i could be there to help.. I've done a TON of GM steering columns.
One last thing...NEVER have someone in the drivers seat when you re-connect the battery. If the air bag is going to blow that is the time that it will go.
Best of luck...
Yeah I didnt think of that. Was thinking of an older model truck. Thanks other dude for your input.
What would be the problem with 1999 Yukon when it shows misfire on the computer code?
On my 1999 Chev Suburban the answer is the fuel filter. It appears when going uphill and trying to give it a lot of gas the engine is not get enough and misfires. I replace the fuel filter and the light goes away. It comes back after a while and I just change the fuel filter. I have 227,000 miles on my suburban
how do u change a crankshaft sensor on a Oldsmoilbe alero 2001 2.4L twin cam?
Where is the camshaft position sensor located on a 99 gmc Yukon Denali?
It is located behind the intake on top of the engine. It is not the same thing as a Crankshaft Position sensor. Don't get the 2 confused. The Crankshaft position sensor is located behind the starter on the housing for the torque converter. The camshaft position sensor is harder to get at which is why many mechanics will try everything else before they check this sensor. In some cases the engine may have to be removed, especially if a unskilled mechanic tries to remove it and breaks it off. Make sure to use extreme care when removing it.
Two of them are the pyloric valve, which opens and closes to let the contents of the stomach enter the small intestine, and the sphincter valve which opens to let the contents of the sigmoid colon move to the "outside world".
Actually, "sphincter" is the general word for any such muscular ringlike valve.
What is the drag coefficient of the 2008 GMC Yukon-Hybrid?
The 2008 GMC Yukon-Hybrid has a drag coefficient of .34 Cd.
What is the little speaker for on the headliner above the drivers seat on my 2002 Yukon XL?
Onstar and/or hands free cell phone speaker.
How do you remove the rear doors on a 1995 through 1999 GMC Yukon or Tahoe?
Pull the door Hinges and disconect all electrical lines running through door and remove
How long should a well maintained 2002 Yukon last mileage?
I have a 2003 Yukon with 211,000 miles, the only thing I have reoplaced is the battery and the alternator.
What is the maximum towing capacity of the 2012 GMC Yukon-XL?
The maximum tosing capacity of the 2012 GMC Yukon-XL is 8100 lbs..
Where is the door switch located on a 2000 Yukon?
I went crazy looking for the door jamb switch on my 2001 Denali. It's attached to the locking mechanism inside the door. The latch has a gear which drives a mating gear that activates the switch. When you pull the door handle, the latch opens and the gear moves.
Do you program the GM keyless transmitters the same way you do the Chevy?
as long as they are the same year p.u or SUV ,yes they program the same i.e--2000 Yukon and 2000 Tahoe are the same programs
What could cause dash lights stop working on a 2001 GMC Yukon Denali XL?
i have the same problem my dash light turns on when i turn on the interior lights but when i turn on only ........the dash light they wont turn on but they work when the interior lights are on ........so they do work .,...is there a separate fuse ?
What ground clearance does the 2001 GMC Yukon-XL have?
The ground clearance of the 2001 GMC Yukon-XL is 0 ft. 8.4 in. (8.4 in.).
How many lbs of freon in a 1999 Yukon?
A 1999 GMC Yukon typically uses about 2 to 2.5 pounds of R-134a refrigerant (commonly referred to as Freon) in its air conditioning system. It's always best to check the vehicle's specifications or the label under the hood for the exact amount. If you're unsure or need to recharge the system, it's advisable to consult a professional.
A noid light is a test light that plugs into your harness of the fuel injectors to test for electrical pulses.
What causes steering clicking on a 2004 GMC Yukon?
JUST HAD THI SPROBLEM FIXED BY TAKING IT TO A LOCAL DEALERSHIP. I AM DRIVING A 04 GMC YUKON XL DENALI. THE "KLUCKING" NOISE COMES FROM THE INTERMEDIATE STEERING SHAFT. IT IS APPARENTLY A WELL KNOWN SICKNESS OF GMC LIGHT AND HEAVY DUTY TRUCKS AS WELL AS SUV'S OF THE YEARS 2000 TO 2006. GMC REEFUSES TO MAKE IT A RECALL AS IT DOESN'T REALLY POSE A SAFETY HAZARD INSTEAD THEIR RECOMMENDATION UP UNTIL 2006 WAS A SIMPLE $ 20.00 LUBE KIT THAT YOUR DEALER WILL HAVE. THEY PACK GREASE INTO THE LOWER CHAMBERS OF THE INTERMEDIATE SHAFT AND THE NOISE GOES AWAY..IT WILL HOWEVER RETURN AFTER ABOUT 06 MONTHS (THAT PARTICULAR PORTION OF THE SHAFT IS GETTING TO HOT WHICH CAUSES THE GREASE MELT OFF I GUESS, AT LEAST THAT'S WHAT I AM TOLD). - IN 2006 GMC INTRODUCED A NEW STEERING SHAFT THAT NO LONGER HAS TO BE LUBED OR RE-PACKED WITH GREASE - THAT'S WHAT I HAD PUT IN AND AFTER A BIT OF COMPLAINING THE DEALER ACTUALLY REPLACED IT FREE OF CHARGE AND PUT IT AS "WARRANTY" EVEN THOUGH I AM OVER.
GOOD LUCK
Denali is just the name given by General Motors to the top end trim on several GMC vehicles, including the Sierra, Yukon, and Envoy. So I would say it was "invented by General Motors.
