Jeep Wrangler Rubicon

No passenger vehicle (that is not for flight or underwater use) is completely airtight. If they were, you would asphyxiate in your own carbon dioxide.

No, the bolt pattern for the 2007+ is 5 on 5.5; the bolt pattern on 1986-1995 is 5 on 4.5.

The 1994 Jeep Wrangler dash pad is secured with eight retaining clips. Pry outward on each retaining clip and the dash pad will come off.

You have to unbolt the winshield from the roll cage, then fold down the windshield. Most models are similar but some do varry. Owners manual is detailed.

The shoulder stock will, but the fore stock may not. The magazine tube and barrel are pretty big on the .410. You could make it fit but it will take a lot of careful sanding. You'll need patience.

between 86 and 87. jeep stopped making the cj7's in 86

1) remove side rear windows. 2) pull out flaps that tuck into the door frame at the top. 3) release latches on the inside top of the windshield.

That should work, they are the same model. The only changes I have seen are in the zipper size. This would be between aftermarket and OEM tops, but if its OEM to OEM they should match.

Let it run and get hot. cut it off and let sit for a few.

wipe stick clean, stick it in but do not screw in.

check it...

oil should between the 2 lines on the dip stick.

search your local jeep clubs classified section or craigslist. someone who just lifter theres might sell the stock stuff.

Of course, synthetic oil is a better choice of oil in all vehicles.

5 X 114.3

Most likely from the roman river named the same.

The 2007 Rubicon wheels/tires will fit. You will have to have the computer reprogrammed to compensate for the larger tire size. Definitely worth the investment because it really gives the Jeep a beefier appearance.

yes

4 pints.

You should get a manual before you start, removing the shoes will require the disassembly of the brake hardware and it all needs to go back together the way it came apart, if you do not get a manual at least do them one at a time so you can refer to the other side if you forget. jack it up, block the wheels, use jack stands, remove wheel, loosen adjusters and remove drum, remove springs at the bottom of the shoes and at the top, then pull one shoe away as you disconnect the parking brake and other hardware in the center, then remove the other shoe, clean the brake area with brake cleaner and reassemble with new shoes, I recommend buying the new hardware kit, its less than $20 and you'll thank me later. pay close attention to the routing of the cables and placement of the pieces, last thing to go on would be the adjuster, have it screwed all the way in, and make sure the adjustment wheel matches up with the self adjuster tab, then screw it out a bit, test the drum, screw the adjuster out until you can barely get the shoe on and reinstall the tire, now adjust the brakes until you hear juse a faint bit of contact.

75w140 synthetic with limited slip additive.

With motor off unplug the battery. Then remove the wires from the starter. Undo the 2 bolts holding the starter in place and remove. Reverse procedure for installation.

The 2006 Jeep Wrangler has a 7 ft. 9.4 in. (93.4 in.) wheel base.

jk and those are just what Chrysler uses for the name of the chassis

This also happenned on my Liberty. It was not in the switch or in the fuse box, a part needed to be replaced by the dealership.

Addendum: That might have been the fan speed resistor block that they replaced.

Ninety-eight per cent chance that was the fan speed resistor. I bought one on eBay for $27 and replaced it in about 10 minutes. You need to drop the glove box by pushing in the holder clips. Inside you'll see a part with several wires held to the heater housing by two bolts. Remove the bolts, turn around the assembly, and there's your resistor, ready for replacment. Piece of cake.

Jeep Wrangler wheel lug patterns years 1987-2006 are 5X4.5

Jeep Wrangler wheel lug patterns years 2007-2014 are 5X5

No, different bolt pattern.

Jeep Wrangler wheel lug patterns years 1987-2006 are 5X4.5

Jeep Wrangler wheel lug patterns years 2007-2014 are 5X5