0
Mitsubishi Trucks
Mitsubishi trucks consist of the light trucks produced by Mitsubishi Motors, and the trucks produced by Mitsubishi Fuso Truck and Bus Corporation. Mitsubishi trucks come in a variety of models including the top-of-the-line heavy-duty commercial hauler Fuso Super Great.
459 Questions
If you have led lights when the brake light warning switch is closed (foot on brake) because it has a predetermined voltage and the rig is change to led's there is a different voltage used, hence an error warning light. can get around it by adding the original lamp in series with the brake circuit out of the way somewhere say under the dash.
How do you deactivate the alarm system of your Mitsubishi 3000GT when key doesn't work?
Why would you want to do deactivate it. Does the key not deactivate it from the drivers door? If so First try deactivating it from the passenger door by unlocking that door.
Attached is a link to Locating the alarm module. Ray http://www.stealth316.com/2-qtr-panel.htm
How do you replace the starter on 1991 mighty max?
there are a few ways you can reach the two bolts holding it on. the head of the bolts are facing towards the rear of the truck and i believe they were 14 mm. you can access them from the underside, through the left wheel well(if you remove the tire) or you can remove the entire intake manifold and its right there in front of you. hope this helps
How do you reset the maint req light in your 94 mighty max?
It is located in the right side of the gauges of the dash it has a small pop out plastic rectangle that removes with a small flat screw driver
Would 23's size rims fit in a 1992 Mitsubishi mighty max truck if i lift it high?
I am positive you can run 22's with 235/30/r22 tires no mods to suspension at all if you use the nitto neo tires, Not sure about 23's though.
Montero sport popping noise around the torsion bar.?
most popping sounds from the front end of these vehicles happens when you make a sharp turn and hit a bump and that's most commonly control arm bushings
Where I can get Mitsubishi l200 wiring diagram?
The answer to this and many other L200 related technical help and advice questions can be found at:
www.L200.org.uk
How do you change a throwout bearing in a 91 mighty max truck?
U must drop tranny it would be a good time to inspect clucth for wear or hot spots or worn fingers
The OBD code p1221 indicates a bad throttle position sensor. Sometimes cleaning the throttle body will clear this code. If that does not work the sensor will need to be replaced.
Where do you find the relay location on a 1997 Mitsubishi Chariot thanks?
What relay? There are more than one.
am looking for the ac relay location on a 1997 Mitsubishi galant
What should you do if you keys locked your keys in your Mitsubishi Pagero 56?
If you do not have a spare key then it would be best to call a locksmith. He will not damage anything inside of the door.
How do you read trouble codes 1991 Mitsubishi mighty max pickup?
Under the dash, behind where the fuse box is, is a large connector with 3 male pins inside.. there are two in opposite corners and a third next to one of the previous two... what you want is the two in the corners ( one is to the computer, the other is a ground).. Get a 12volt LED with built in resistor and (mine has 2 insulated wires and is made to mount in a panel) at Radio Shack . Also get a pack of small alligator clips.. crimp a clip on each wire , then hook to the two aforementioned pins in the connector with the key off... Turn on the key... The LED will flash a code to you- a long flash= "10".. a short flash= "1"..So, two longs followed by 3 shorts would be 10+10+1+1+1= 23 (example) then look up fault code 23 ( possibly even call the dealer, autozone,etc...)
i am having the same problem i thought there was a cut off switch too there is a relay behind the kick panel on the passenger side im trin to find what will interchange with that relay it controls the voltage going to the pump to kick it on
Two screws at the top of dash and one screw each behind the flasher switch and a cover plate on the other side from the flasher switch. Reset switch in at the bottem right of the gauges after removing trim. Slide swith to reset.
Why is my Mitsubishi L200 Diesel engine hard to start?
L200, 2000, crew cab, hard to start, here are my findings after a lot of work !!
Replace fuel pump , still the same
Fit electronic switch to stop fuel running back to tank !!....didnt work
Changed all filters....didnt work
changed heater plugs....didnt work
RESULT.....................was this , in the top of the tank is a rubber pipe into fuel tank, remove this and replace with plastic type fuel pipe and use silicone sealer on top of the tank, works a treat !!
The problem is that the rubber pipe after time becomes Pourus and lets air into the fuel line feed, replace it and all was well
you sort out your problem
I had the same problem. The starter brushes looked like good but they were not. Replaced the brushes and now start like new. There was no problem on cold starting. When hot starter don't crank fast and that was the problem.
What is the firing order for a 1991 Mitsubishi mighty max 3.0 v6?
The firing order for a 1991 Mitsubishi mighty max 3.0 v6 is 1, 2, 3, 4, 5, 6. The number 1 cylinder is on the front left.
Where can you find a Wiring and vacuum hose diagram for an 1987 Mitzubishi Mighty Max?
When making any changes to a car, it is important to have a diagram to help. A 1987 Mitsubishi Mighty Max wiring and vacuum hose diagram can be found in its maintenance manual.
