answersLogoWhite

0

Nissan Maxima

The Nissan Maxima is a large four-door sports sedan manufactured by Nissan. It was launched in July 1976 as an upgrade version of the Nissan Bluebird. The car’s model is also called Nissan Laurel or Nissan Cefiro in other markets.

2,931 Questions

Why does your Nissan Maxima stall when cold but fine when warmed up?

i asked you.

If there are check engine light codes, take it to AutoZone for a free analysis.

If there are no check engine codes, the main suspect is the Mass Air Flow (MAF) sensor. Go to AutoZone, buy CRC brand MAF cleaner in a gray spraycan. Remove the MAF connector. Remove the MAF. Do not touch the internal parts of the MAF with anything! This is important, no brushes, no fingers, nothing (if you touch it, you break it). So with MAF out, you'll see a silver area or a thin wire. Spray well, then let dry for about 2 hours or so (let dry really well). reassemble everything. Start up and stalling should not happen anymore.

So, if the MAF cleaning does not solve it. You might try removing and cleaning the IACV.

Sometimes cold stalling can be caused by a vacuum leak. Take a really close look at any hoses that may be cracked and leaking air. I once found a pin size hole which kept causing my engine to stall, I cut the end with the pin hole off, reattached the hose and all was well.

Good luck, reply back whether the advice worked or not.

Why does your 1993 Maxima clutch feel soft and does not engage?

it might not have any hydrolic fluid in the clutch master cylinder to engage the cluth or your clutch might me shot and just won't engage at all meaning you need a new one (was there a smell in the car right before you couldn't use clutch? that might of been the clutch burning up). don't quote me on all that I'm just telling you what you can check.

Code 305 maxima 1999?

Trouble code P0305 means:Cylinder No.5 misfire detected

How do you run a sub wire through the firewall of a 95 maxima?

Look for an exhisting hole that you can piggy back on. If there is no hole, then you will have to drill one. Be sure and use extreme caution and do not drill into something or another wire. After drilling the hole, be sure and install a rubber grommet around the wire to prevent the wire from shorting out on the sharp metal, and to seal the hole.

Where is the egr valve on 1977 for f150 351m?

I don't know if it is the same but the EGR valve on my 1977 Ford 302 was

underneath the carburetor at the back of a spacer

Differentiate a positive catalyst from a negative catalyst?

A positive catalyst is a catalyst which speeds up the rate of a chemical reaction by lowering its activation energy. A negative catalysts slows the rate of a chemical reaction or makes it less likely to occur.

How do you replace a water pump 97 Maxima?

The water pump is driven off the timing chain. I would recommend purchasing a repair manual for that vehicle if you are going to DIY.

P0430 on 2001 Nissan Maxima?

That code means catalyst system fault (left bank)

What color interior comes standard on a Nissan Maxima?

There are two standard interior colors on a Nossan Maxima depending on the exterior color you choose. They are a gray called charcoal cloth and a light beige called cafe latte cloth.

What does the GLE in gle Maxima stand for?

GLE, mean luxuary edition, GXE means standard edition. SE mean sport edition, SER means sport edition racing. GTR grand turismo racing.

Where is the egr valve located in 1996 Nissan Maxima se?

see the egr valve location on the 1999 Nissan Maxima-it should be very similar.

Where is the code reader plug in on a 2001 maxima?

The OBD II connection port is located underneath the steering column. On the driver side there is a small rectangular opening with a white 16 pin connector at the bottom of the molded plastic of the console.

Where is the PCV valve located on a 1989 Crown Vic 50?

you are going to have to get under the hood and reach behind the intake phlem and the firewall. {its a tight squeeze small hands are helpful}. when u get the pcv valve out you need a 3 or 4 inch screw to screw into the wad of screen and pull it out so u can clean it or maybe even leave it out. be careful not to lose the grommet that the pcv valve sits in.

How do you trun off the alarm on a 1988 Nissan maxima?

The control box is located in the trunk area, were the rear speaker are located. Just left of center is the control box for the security system. Remove the multi-wire plug, this should disarm the alarm system. You don't have to remove the anti-theft relays under the hood, you only need to disconnect the anti-theft unit in the back as instructed above.

What does ABS code 12 mean for a 1998 Nissan Maxima?

  1. The indication begins with the start code 12. After that a maximum of three code numbers appear in the order of the latest one first. The indication then returns to the start code 12 to repeat (the indication will stay on for five minutes at the most).

In other words it will display code 12 to let you know that you are in diagnostic mode.

Where is the Location of the modulator valve on a 93 Nissan Maxima?

where is the location of the modulator on Nissan maxima transmission

How can you tell if a 2002 Nissan Maxima is leaking oil into the cylinders?

is there blue smoke coming out of your exhaust? if there is then there is probably oil leaking into the cylinders.

Where is the fuel filter on 2001 Nissan maxima?

The fuel filter is an integral part of the fuel pump in the gas tank Same location as in 2002-Maxima.

Where_is_the_Fuel_Filter_on_a_2002_Nissan_Maxima