0
Oldsmobile Cutlass
The Oldsmobile Cutlass was a compact/mid-size car produced by General Motors from 1961 to 1999. The Cutlass was one of the most popular nameplates in the vehicle industry during the 1970s.
1,158 Questions
What size tires are for 1983 Oldsmobile cutlass supreme?
The standard sized tires for a 1983 Olds Cutlass Supreme are 195/75/14. However, the car can also handle 215/65/15, 205/65/15, 205/75/14.
Will a 1969 cutlass dashbord fit in a 1968 cutlass?
it will fit but you will need to drill out an ignition switch hole unless you also transfer over the 69 steering column.
You may want to go to a car parts store, and get a repair manual for your car. They cost about $16.00 Or, go to a Public Library.
How do you change the AC compressor on a Cutlass Supreme?
I have a 95 3.4 and it's on the passenger side of the engine, first you have to remove the belt, best to also remove the radiator fan, disconnect the negative side battery cable, remove the connection to the a/c hose, remove the wire plug attached to the condenser, then remove the 3 bolts on the flywheel side of the compressor. you should also replace the accumulator, all the o-rings and add 4 oz. of pag 150 a/c oil, 4 oz. in the accumulator and 4oz in the compressor, turn the compressor 10 times. Change the orifice which is right after the high side service plug. reconnect everything while changing the o-rings and adding oil to them. Vacuum pump the system for about 45 minutes, reconnect the battery terminal. then add freon at the service plug while the ac is set high and car is running. 37 lbs for my car. Hope this helps you and check your service manual for your particular cutless supreme
Where is oxygen sensor located in 1984 cutlass?
The 1984 Cutlass is a model of car produced by the company Oldsmobile. The oxygen sensor is typically located near or on the engine block.
Where is the vacuum line for ac vent in 1979 cutlass salon?
Runs from the passenger fender (vacuum reservoir) back to the firewall and comes through a rubber plug below the dash (glove box side)
Grey and purple are the two colors that i had to replace to fix mine.
Is the 3.1L the only engine that the 1998 Oldsmobile cutlass can have in it?
No, You may if you like replace it with a 3.4. OVH It will bolt up just fine. Make sure that you replace the harness aswell. The 3.1 harness on the 3.4 will read out trouble codes and turn engine light on.
Why would the needle on the gas gauge of a 1995 Olds Cutlass Supreme move while driving?
As you accelerate and decelerate, the fuel in the tank sloshes around a bit like water in a bucket. Sometimes the fuel moves toward the sensor (showing more fuel) or away from it (showing less).
Where do you find the VIN on a cutlass ciera?
Forward end of the dash on the driver's side underneath the windshield
How do you replace a starter on a 1995 olds cutlass supreme V6?
The best way to find out is go to your local auto parts store, ask for a haynes or chiltons manual on your vehicle. This will tell you everything you need to know about working on your vehicle.
Where do you put the power steering fluid in a 1997 Oldsmobile Delta Eighty-Eight?
There's a cap on the top of the power steering unit, remove it and put it in there, it might even have a little dip stick.
How do i cut off my roof on your Oldsmobile cutlass?
Wait, MY roof on YOUR Cutlass, what?
I find for this sort of work, the reciprocating saw is by far the best choice. Grinder cutoff tools also work well, but make sparks. Sparks induce fire.
The battery powered DeWalt recip saw is hard to beat. Many other brands are also similar in quality and ability. Bosch, makita, Milwaukee. Cheap "Shipwreck Tools" versions- not so much...
http://www.amazon.com/DEWALT-Bare-Tool-DC385B-Cordless-Reciprocating/dp/B002RT7K5K/ref=sr_1_2?ie=UTF8&qid=1359928671&sr=8-2&keywords=dewalt+recip*
How do you replace a transmission vacuum modulator on a 1972 Olds Cutlass 350350?
Disconnect the battery (always disconnect the battery when working under the car!!!) Unplug the vacuum hose. Remove the retaining bolt. Pull out the old modulator. Slide in the new one. Replace the bolt and vacuum line. That's about it.
Where can you find a vacuum diagram for a 1982 Oldsmobile Cutlass Supreme with the 3.8L 2bbl V6?
I have a 1982 cutlass supreme and the diagram in under the hood on a front panel, If not someone may have removed it.
How do you change the brake lights on an Oldsmobile cutlass 1998?
Open trunk and pull carpeting back from the rear lights and you will see wing nuts, take the wing nuts off and pull the complete light assembly out to change the bulbs.
What size windshield wipers on a 1984 Oldsmobile cutlass supreme use?
The 1984 Oldsmobile Cutlass Supreme takes 18" replacement windshield wiper blades on both sides front. Note, when buying wipers be sure to always lookup your vehicle make, model and year in the application guide book at the store, or now-a-days you can Google 'lookup wiper size'.
You want to look this up because correct wiper fit is more than correct length, it's also proper attachment. Not all attachments fit all arms. Using the application guide or looking up wiper size online will avoid headaches of buying the right lengths with the wrong attachments.
How do you do a tune up on a 1991 Oldsmobile cutlass supreme?
With money take it to someone who knows.
How do i add freon to a 1999 cutlass?
Freon is added through the low side ac pressure port. Connect the hose from the gauge and Freon and allow Freon to fill the system until the gauge shows full. The engine and ac need to be running during this process. Make sure to follow all directions on the Freon can.
What should the oil pressure be in 1987 Oldsmobile cutlass ciera?
General rule is that you need 10psi for every 1,000 rpm's of the engine.
How do you find out how many 1994 trans am coupes without t-tops were made?
3852 TA's were made in 94, but only 1432 were hard top coupes
Where is the starter on a 1991 Olds Cutlass Cierra?
Follow the pos battery cable and it is at the engine end.
