0
Oldsmobile Cutlass
The Oldsmobile Cutlass was a compact/mid-size car produced by General Motors from 1961 to 1999. The Cutlass was one of the most popular nameplates in the vehicle industry during the 1970s.
1,158 Questions
Is there a 1972 Oldsmobile cutlass cs map light on the mirror option?
Yes,
My 72 Olds Cutlass convertible came with the light option package which included a map light in the rear view mirror.
What type of transmission is a 1983 Oldsmobile cutlass supreme v6?
More than likely a metric TH200. Maybe a TH350 if you're lucky.
check the bulbs on the side that does not flash, it's quite possible one is burnt out
Where is the Crank shaft sensor 1989 cutlass ciera?
Behind the harmonic balancer. You will need to remove the right front tire, remove the access panel to the engine (through the wheel well), remove engine belt, remove harmonic balancer & pulley with a puller. Remove & replace crank sensor, align sensor with an alignment tool, replace balancer with an installer tool.. BE VERY careful with the balancer, the backside of it has a hall effect style blades. bending these blades will junk the balancer.
How do you change the rear spark plugs in a 1998 Cutlass?
No special tools needed, Spark plug socket and ratchet wrench is all you need. Granted, the access is very tight and it is not possible to see the spark plug or the spark plug hole without a mirror and flash light. You should be able to do this by feel. Beware! Make absolutely sure that you thread the new spark plug in by hand because if you do it with the new plug in the socket and try to thread it in with the ratchet you will more than likely cross thread the plug in the engine. Be patient, it will work. I have had my 98 cutlass since new and have done all the maintenance myself. Hope this helps.
How do you go about disconnecting a water pump from a 1994 3.1 Oldsmobile Cutlass Supreme?
GO TO WWW.AUTOZONE.COM AND YOU'LL NEED TO PUT IN YOU CAR INFO AND WHAT NOT AND IT WILL TELL YOU HOW TO GO ABOUT REMOVIN THEN INSTALLING YOUR WATER PUMP, IT ALSO SHOW'S A PICTURE TO HELP YOU AS WELL. YOU OUT. GOOD LUCK.
New HeadlineCrack loose (don't remove) the water pump pulley bolts then use a 10 inch adjustable wrench and rotate the idler pulley arm CCW to relieve the tension on the belt. The tensioner arm has a boss on the casting that can be used to seat the wrench. I have seen some arms with a 3/8" square hole cast into the arm to accomodate a breaker bar drive instead of having a boss with flats. Relieving the tesnion will allow the belt to slip off the grooved pulley.Remove the belt, remove the pulley nuts. This will allow access to the pump mounting bolts. I think there are 3 or 4 10mmm bolts.
How do you replace the exterior door handles on a 1994 Oldsmobile Cutlass Supreme?
You need to pop the whole plate off. The part is fairly expensive, but I had the handle on mine sheer off during off during the winter, and I needed to get underneath the entire door handle and pop it off. It comes off and comes back together fairly easily. Check on eBay, the complete door handle assemblies are selling for between $20 - $30.
Where is the orifice tube located on a 1995 cutlass ciera?
its located on the lower left side of the condenser ,, drivers side. its in the tube with the brass connecter nut ,... if you seperate the connector you can look up into the top tube and pull it out with needle nose pliers.... yes
Where is the fusebox in 1 1993 Oldsmobile cutlass supreme?
The fuse box is located behind glove box. Open glove box and remove tray inside (no tools, just pulls out). You will find it right away against the firewall. Also look in the lid of glove box and you will find spare fuses and fuse puller. Hope this helps.
How do you change the headlights on a 1999 Oldsmobile Cutlass?
look for the adjuster screws that are vertical for the headlight adjustment and follow them to where the turn horizontal "where they push on the headlight to change the direction." and where that meet's the clip which is black there's 2. look closely at it on top there's 2 pieces to each they overlap and snap together. take a flat head and lift the lip of the top piece and lightly pry it up and once there both up pull the headlight assembly out. there u go. i racked my brain so much then i was like oooohhh. stupid... it's simple.. good luck.
How do you replace the head gasket located on a 1994 Oldsmobile Cutlass?
What size engine? 3.1 or 3100? yes there is a difference. j1taylor@twcny.rr.com
To recharge the air conditioning on a 1993 Oldsmobile Cutlass ciera do you use r12 or 134a?
It came from the factory with R12. Due to the cost of R12 I suggest you have it converted to run on R134. Have the leak fixed and convert it to R134 and save yourself some big money. R12 is no longer in production, and is very, very, expensive.
How do you adjust the reclining part of the front seats of a 1991 Oldsmobile Cutlass Ciera S?
Are they power seats in the front? My 1993 Ciera S has power recline - each switch is located at the front corner of the seat (near the door on the seat itself). Good luck!
What body parts on a 1993 Cutlass Ciera will interchange with other GM cars?
The body was basically the same on the Ciera from 1989-1996, so any parts from one of those years should work
Where can you find a vacuum line diagram for a 1986 Olds cutlass?
the diagram you are looking for is on the fan guard connected to your radiator
How do you install headlight warning 86 olds cutlass?
remove steering column and check this link. the buzzer is the red box on back of instrument panel.
http://www.oldspower.com/vb/showthread.php?t=47536&highlight=chime+module
Where is the fuel pump on a 1992 cutlass ciera?
in the gas tank . or if it has a carberater on the front of the engine.or like my 86 celeberity both.
Where is the brake light switch on a 1995 Chevrolet Silverado 4wd?
UNDER the dash, on the steering column and it makes contact with the brake pedal It looks like a bracket, that wraps around the brake pedal arm, and it has a cylinder type switch that makes contact with the brake pedal arm. When the brake pedal is pressed down it pushes the cylinder switch together which closes the circuit and makes you brake lights come on. It may be a fuse or wires but start with the switch.
Where is the fuel relay on a 1993 Oldsmobile Cutlass Cierra 3.3L?
No relay on this model. You may have a plugged fuel filter or a fuel pump that is getting weak.
