0
Oldsmobile Cutlass
The Oldsmobile Cutlass was a compact/mid-size car produced by General Motors from 1961 to 1999. The Cutlass was one of the most popular nameplates in the vehicle industry during the 1970s.
1,158 Questions
What is the torque for headers for a 350 rocket?
Factory spec for exhaust manifold to head is 25 ft-lbs.
What would make a 1988 Olds Cutlass Ciera hard to start?
prob a bad battery if it doesn't get enough charge from altenater to resupply cold cranking amps iniatal cranking will be hard so get your altenater and battery checked Sometimes it can be the oil. Some people don
What other GM cars will interchange body parts with a 1990 Chevy Corsica?
depends what parts u need but the Pontiac tempest is almost thE SAME.
What does the remote wire hook up to on the back of a CD player?
It is most likely for a remote control accesssory that allows you to perform normal CD playback functions with a controller wired to the player. For example, you can sit in your chair and adjust the volume or skip songs without getting up and going to the player.
The remote wire goes to the amp. its the turn on switch from your deck to your amp. if your not running an amp, then put electrical tape around the wire , so it doesn't touch any metal and ground out.
Show pictures off 91 cutlass ciera?
If you wanted to see pictures of cars that people change stuff then go to Cardomain.com, For basic pictures the just use Google images.
Where is the reset switch for a fuel pump on Oldsmobile cutlass cierra 1994?
The reset switch for the fuel pump is generally located in the trunk of the car although some are under the dash on the drivers side of the car . Check your owners manual for a specific location .
What is a 82 cutlass bolt pattern?
Bolt pattern for what? Nearly everything that has more than one bolt has a bolt pattern. Are you looking for the wheel bolt pattern? Or the torque pattern for say, the intake manifold bolts?
Where is voltage regulator on 1974 cutlass?
There are two options. It may be on the inside fender. It would be a square black metal box with at least four wires coming out of it. The other is it has an internal regulator in the alternator. If the plug on your alternator has two wires side by side coming out (II), it wil have an external regulator. If they are facing each other long ways (--) then it's internal.
How do you hook up a CD player to an 1985 Oldsmobile Cutlass?
first you pull the factory plate from the concole, all you need to do that is a flat head screw driver. after the plate is pulled you remove the factory radio, and unplug the wiring from the harness. ensure that you have a wiring harness to match the car, you can buy it at canadiantire for $13. wire your new CD player to this wiring harness and plug the harness into the factory wiring. you will also need a mounting kit that you buy at Canadian tire for $20. install the CD player in the mounting kit and bracket into the dash. now you can reinstall the plate and now the CD player is installed. process takes 20 minutes to an hour.
How much transmission fluid do you need to properly fill an 1987 Olds Cutlass Ciera transmission?
The total capacity of the transmission is 10 qts. If you are just doing a pan service, use 6.5 qts. Macs Transmissions Houston, TX 281-743-1000
What 1989 cutlass spark plug gap?
This would be easier to answer if you told us what engine you have. It should be printed on the VECI label. The VECI label, if destroyed, can be purchased from your local GM dealer. It usuaslly costs about $12, but sometimes they give it to you for free.
Failing that, it's probably .035 but might be .042. Go with .035 and it'll ride up with wear.
If you buy AC Rapidfire plugs or any good brand of platinum plugs, they will be pre-gapped. Bosch is not a good brand of plugs unless you like to burn wires and coil boots. Instead, go for Autolite, NGK, Denso, Motorcraft, AC, or even Champion first.
Hand cramping can be a result of dehydration or overuse of the hands. If it is not, it could be a result of diabetes, kidney diseases, or thyroid disorders and should be looked at by a doctor.
How do you change the door speakers in an 1996 Olds Cutlass Supreme Sedan?
i believe the 95 olds is the same as the 96. you have to take the door panel off. by taking out your window control [if auto windows] you will see a screw inside, take it out and under the door handle there is a screw to take out. once you take those 2 screws out take out the screw for your door open handle. after that you need to take a screwdriver and pry to door panel, starting from the bottom and work around pulling the panel off, they are only push pens that is it. from there you should be able to get to your speakers
*There are 5 replaceable / one time use, plastic retainers that you can cut with a wood chisel. Auto parts have them. Large head screws into panel, smaller side pushes into door to attach the trim panel. Take retainer for matching at parts place.
Where is the relay switch on a 1993 Cutlass Ciera S Oldsmobile four door?
The Relay for what - door locks or something else?
How do you change rear shocks in Mercedes 1989 560sel?
Jack up the car. Unscrew two bolts in the rear bearing arms, then unscrew the top bolts. You will need to take out the back of the rear seat in order to get to these. Then the shocks can be taken out and new installed.
Whats causes a 1992 Oldsmobile cutlass ciera to idle high and overheat?
The high idle may be caused by old spark plugs and wires. As far as the temperature problem there are several things that may cause this, but the thermostat is the easiest and cheapest thing to check.
Where is the speed sensor located on a 1996 Oldsmobile cutlass ciera?
It should Be located on the top of the transmission.
What is a Oldsmobile cutlass hubcap key?
Very Simple. This can be one of two things used on that model car. It can be the tool used either to remove the wire wheel covers or possible used for unlocking the lug nut on wheel. ALL DONE> Brought to you by Hubcaps Unlimited www.hubcapnation http://www.hubcapnation.com
1999 olds cutlass check engine light is on What are the problems that turn on this light?
I've had problems with the Intake Manafold and also with the spark plug towers burning out setting off the check engine light. I know there are more but this is just my personal experience with my 1999 cutlass.
How do you change an intake manifold on a 99 jetta diesel?
Go to this site and download the PDF will give you all the instructions and pictures. Good Luck, Carol
How do you remove hubcaps for 1989 Oldsmobile Cutlas Sierra?
Try using the lug wrench. If the car has wire wheel caps, you will need an adapter tool to pry off the center caps and unscrew the cap from the wheel
How do you remove front shocks on a 1996 Olds Cutlass Supreme?
I'm pretty sure that it does not use shocks, but instead it uses struts. Struts are usually enclosed in the coil spring tower and can be a tough job unless you have speciality tools such as a Spring Compressor. I would seriously consider paying Sears, Firestone, or some similar store to do the job. -------------------------------------------------------------------------------------------------------- First the main thing to remember is not to jack the vehicle up or take the front tires off. The weight of the vehicle in this design actually supports the coil spring up in the coil tower inside fender well. You will need to rent a special tool to remove the gland nut underneath the covers inside the hood compartment. If this is a do it yourself project, I highly recommend getting a repair manual available at Pep Boys, Auto Zone, etc., these places usually rent that special tool. The job is fairly easy with basic hand tools, just be careful, usually the parts salesmen will give you advice and encouragement.
Where is the fuel pump located on a 1991 Oldsmobile Cutlass Ciera?
In the tank, the following is a run down of how to replace it..
This is actually a pretty involved repair. You have to have the car jacked up on all 4 corners, or up on a car lift. Disconnected battery, and it is recommended you have as much gas as possible drained from the tank. Then underneath the car you will find the tank with 2 staps holding it in place. Those staps should be taken off or at least out of the way while the tank is being supported. There are vacume lines, the fuel fill and vent lines, and the wiring harness that all have to be unhooked. Once you are sure that all lines are disconnected, drop the tank and pull to the side. Wash the top of the tank off, there will be dirt and rocks on top of it, and you need to get all of these out of the way. You will see where the wiring harness goes into the fuel sending unit. Around that peice is a slide ring that has to be gently hammered counter clockwise. Once it is free from its retaining clips, the fuel sending unit will have to be wiggled out very carefully. Once out, you will see the fuel pump mounted in line on the fuel sending unit. You will have to work out how its mounted in line, and get it off and unplugged. Reinstall the new fuel pump and reverse the procedure.
Parts needed:
Fuel Strainer
Fuel pump
Lock ring O-ring
Posibly the fuel sending unit if you were having problems with your gas gauge.
How do you fix the 1997 Oldsmobile cutlass fuel gauge which is turned upside down and stuck below E?
Stick a peace of wire threw the hole of the mileage reset button and push it over.
