0
Oldsmobile Cutlass
The Oldsmobile Cutlass was a compact/mid-size car produced by General Motors from 1961 to 1999. The Cutlass was one of the most popular nameplates in the vehicle industry during the 1970s.
1,158 Questions
How do you open back trunk no key trunk release cable broken?
To open a trunk when there is no key and the cable release is broken, it is necessary to remove the back part of the rear seat. In some vehicles there is a small part of the bench seat back that will pull down to access the trunk.
How many Oldsmobile 442 were made in 1969?
Model Units Sports coupe 2475 Hardtop coupe 19587 Convertible 4295 Total 26357 These are total production figures from yearone for 1969 Olds 442
How do you get the convertible top down on a 1990 corvette?
First look under the visors, pull the latch handles away from the window. The lid will open slightly. Then push forward the drivers seat and look under the lid, you will find a spot to pull a cable which will release the top from the rear clips. After that pull up on the rear of the top and hold upward while you push one of the yellow buttons to lift the lid. One of these buttons is also located under the lid and there is also one inside the door jam. Once it raises you simply lower the back section and pull the front section up and back, it will seat itself in place. Then close the lid. It is quick and simple
Where is the turn signal flasher located on a 1985 cutlass supreme?
I had a heck of a time finding mine also. This car uses two. One mounted in the fuse box is for the emergency flashers. The other is mounted just under the dash next to the steering column....just to the right of it. There's a small bracket it snaps into.
The 2.8, 3.1 and 3.4 are all the same block throughout all years. The only thing that really changed was the style of head, the intake, and a roller camshaft. It should be a direct swap for what you are wanting to do however.
Were is the location of the orifice tube for a 1996 Oldsmobile cutlass?
it is in the high side line towards the bottom of radiator on drivers side
Where is the flasher unit on a 1996 Oldsmobile Ciera?
The turn signal Flasher Relay is located front seating area, driver side, under dash, passenger side of steering column, mounted behind instrument panel. The Hazard Flasher Relay is located front seating area, driver side, under dash, passenger side of steering column, mounted in fuse block.
Where is idle air valve on 1993 olds cutlass cierra s?
On top at the front or rear of the throttle body after the black hose connects from the air filter box. I would go to a parts store to see what one for your car looks like and go from there. It's prob called a sensor. Or an idle control valve, Air sensor, throttle position sensor, o2 sensor on the motor and the outlet pipe next to your cat. converter.
Get some throttle body creaner take the hose from the air cleaner off get someone to hold the gas to the floor, (WITH OUT IT RUNNING) spray the heck out of it, It's ok if it runs all over the motor, befor buying anything. Good Luck!
Where is the fuse box on a 1990 olds cutlass?
On my '95, you open the passenger door and look at the outward side of the dash. There is a panel there with the fuses under it. Cindy my 1990 cutlass fuse box is in the left side of the glove box
Where is the fuel pump located on an Olds Cutlass?
The fuel pump in bothmy 1988 and 1989 olds cutlass supreme sl are in the fuel tank they're ALWAYS in the fuel tank!! haha
Fuel pump replacement instructions and type on 1983 Oldsmobile cutlass?
Mechanical engine mount? Remove old one Install new making sure cam is under lever to activate replace mounting gasket and fuel lines Mechanical engine mount? Remove old one Install new making sure cam is under lever to activate replace mounting gasket and fuel lines
How do you determine if fuel pump is bad in a 1989 olds cutlass ciera?
Check fuel pressure with a gauge Engine running at idle 13-20 psi Key on engine off 23-30 psi
Your 94 cutlass ciera 3.1 bogs down when accelerated sometimes stalls what could this be?
Lots of things. Bad plugs/wires, clogged air filter, clogged fuel filter, clogged fuel injectors, faulty fuel pressure regulator...
Replace the plugs & wires, change the air and fuel filter, and run a bottle of GM Top Engine cleaner through it.
Where is the heater core on a 2001 Oldsmobile aurora?
It is located underneath the dashboard right behind the center console. 11/16/2011
-Dennis.S.-
Replace the radiator on 1993 Oldsmobile cutlass supreme sl?
After you remove top plate, hoses,trans lines, fan & shroud it should lift straight up.
What kind of lift is needed to lift a 1987 cutlass to fit 22 tires?
if its a coupe not much ....some knuckles and lifters from auto zone will do the job something like 25 bux jack the front up get about 4 knuckles in each spring they twist on with a ratchet and extension or tire iron ..........the rear springs you d use lifters on those they use nuts and bolts on a plat form that jams itself between you coils and as you turn the nuts they stretchas a result you car goes higher they are kind of tricky but if you can follow directions your good and presto!!! your clear for deuces on the cutty....i have a cutty on deuces and they work fine
How much do the rotors cost on a 95 Oldsmobile cutlass?
The 1995 Oldsmobile Cutlass brake rotors will cost approximately $40 per wheel. The rotors can be as cheap as $25 at some discount auto-parts stores.
Yes, if there are two cooling fans one operates off of engine coolant temp. and the other operates off the A/C. The one that operates off of coolant temp will run for a while then shut off, then run again and continue to cycle. This is to keep engine at operating temperature. The other one runs when the A/C is on because when the compressor engages it puts a load on the engine, which will create heat beacuase the engine works harder. as long as both fans operate your okay.
Why does your 94 Oldsmobile cutlass supreme over heat?
There are 2 reasons that I've heard of that may cause a car to overheat: 1. You need a new thermostat--the engine coolant is not getting into the engine 2. You need to replace the head gasket on the engine--this can be thousands of dollars, so maybe have the thermostat checked out first. If the radiator only comes on when the A/C is turned on, the Radiator coolant switch may need changing
How do you bleed brakes on a 1978 Oldsmobile cutlass?
There's a simple way to do it...especially if you don't have an assistant. Start at the passenger side rear. Loosen the bleeder screw. It will gravity bleed. Loosen the master cylinder cap while doing this. Keep the fluid level topped off and allow it to bleed until you feel that it has bled enough fluid to fill the line from the master cylinder to the rear. Next the driver side rear. This won't take as much as the passenger side as you are only needing to bleed it from the T intersection. Next passenger side front then driver side. That's it. You should have a good solid pedal now....assuming everything else is in good shape.
Check the fuel pressure regulator or the vaccum line to it If you have to have the gas peddle pushed all the way to the floor to start it that is a for sure sign
Can you open a 1994 Cutlass with power door locks with a slim Jim?
That's easy. Of course you can. But the trick is not a slim jim. It is a coat hanger. I locked my keys in my car once outside of my work place. So I took a coat hanger, brought it down towards the sliding lock mechanism itself, and then poked up and down until I figured out where the mechanism was. Then simply slide it to the left, try not push too much of the hanger in otherwise you won't have the necessary leverage and the hanger will bend.
