0
Peugeot 106
The 106 was a front-wheel drive sub-compact vehicle manufactured by French car maker Peugeot from 1991 to 2004. In 1993, Peugeot 106 was the 11th most popular new vehicle in the United Kingdom.
617 Questions
How do you fit a new clutch on a Peugot 106 Mark 2?
To replace the clutch on a 106 you will need to remove the air box, battery, wheels and starter motor and disconnect the gear linkages. Before you remove the drive shafts drain the gearbox vie a 3/4 square drive plug located on the bottom of the gearbox (then remove the shafts).
After this you will need to support the engine and remove the engine mount from the gearbox.
Once this is done the electrical cables connectors and associated clips will have to removed from the gearbox.
Once you are sure that there is nothing left fastened to the box remove the gearbox bolts including the bolt located under the engine that secures the front pipe to the engine/gearbox.
The gearbox should then be removed by sliding it slightly to the N/S of the car to extract the input shaft from the crank and then lowering to the floor,
The clutch is then visible and can be replaced ensuring that the clutch is tightened evenly and properly aligned using the appropriate aligning tool (sometimes supplied with the new clutch).
Before refitting the gearbox it is always worth replacing the driveshaft oil seals on the gearbox as these can be a pain if they leak once the job is complete.
Refit the box and reassemble the components in reverse order remembering to refill the box with fresh gearbox oil
How do you disable a Peugeot air bag?
there is a connection under each seat if you undo this then the air bag light will flash for 5 mins after you start the engine then stay on.
I had the same problem with mine if the light stays on the airbag will not work
Where is the windscreen wiper relay on a 1997 Peugeot 106?
the relay is in behind the glove compartment behind a rubber flap,beside the enternal fuse box,orange in colour.
To change door pins on most vehicles, the old pin needs to be cut off with a blow torch. Then, the new door pin is welded in its place.
Can yoy help Peugeot 106 XN Fuel Pump is not pumping fuel any ideas?
have you tried the doulbe action relay under the ecu or to the left hand side of the engine bay its a brown relay i
Will a mk1 106 bonnet fit a mk2 106?
yes if you change the slam panal front wings headlights and the bonnet lol
The answer is in your question,
Fog lights are just that, lights that can be switched on in the fog,
Driving lights are lights used to assist the driver when thay need more light (when full beam is selected).
Answerive got the same model & the fog lights are switched on using full beam...i just wired in my own 12v feed & attached a switch ;)
An induction kit is generally an aftermarket add-on for an air filter on a car. Most comprise of an air filter and tube/ducting pipe allowing a rich flow of air to the filter.
These are said to increase air flow into the engine allowing more air and fuel to mix, in turn, increasing power. They also add a really nice rumble or 'induction roar' when accelerating.
Pipercross and K&N filter kits are probably the best value for money. I own a K&N one and i wont look at any others...but that's my opinion anyway.
*Sorry for the plugs :/
Where is the central locking module located on pug 106 1997?
behind the glove box
it is a long grey box behind the relay panel thats behind the glove box
2 pins slide out and release the glove box and its easy to get to then
Where do you top up gearbox oil on peugeot 106?
first you take the wheel of then you go under the car and lossen the brakes and then go shove it up your a#$.
Where is the thermostat on a 1.1 Peugeot 106 engine?
Open the bonnet,
Follow the top coolant hose (On the passanger side of the car) from the radiator to the point where it connects to the engine,
The housing that this hose connects too is the housing for the thermostat.
Remove the two retaining bolts and the thermostat will be accessible.
My peugeot 106 drivers door does not lock the key turns the lock goes down but door doesnt lock?
I had the same problem.
Removed lock mechanism, cleaned, oiled and replaced. A fiddly job as bits fell off - it had seen better days. Once all back together it locks if I do the following:
Get out. Close door. Lock door. Open door. Close door.
On my 1992 Toyota Corolla, the key stopped opening the trunk lid but worked on the doors. I went to a locksmith to get the trunk opened. He made a new key that then worked on all the locks. He said that a worn key may fail to open only one of the locks on a car.
