0
Pontiac Trans Am
The Pontiac Trans Am, also known as the Pontiac Firebird, is a two-door muscle car produced by General Motors in 1969, 1971, and later in 1990 to 2002. It is powered by a V8 engine.
1,212 Questions
What was cost of an automobile in 1977?
That would depend on what make, model, automobile you are referring to. Some examples are: Alfa Romeo GTV $5,750 California 1974
American Motors Ambassador SST Sedan $3,722 1970
AMC Pacer $3,100 California 1979
BMW 3.0CSL $12,250 1974
Buick Le Sabre $3,337 1970
Buick Station Wagon $4,371 1974
Buick Electra 225 $7.033 1977
Buick Skyhawk $4.778 1979
Cadillac De Ville $6,168 1972
Cadillac Elderado $9,935 1975
Cadillac De Ville $11,728 1979
Chevrolet Camero Z28 $6,326 1978
What is a automatic transmission modulator?
An automatic transmission modulator is the device that decides when your vehicle should shift. It basically controls and regulates pressure for smooth operation of the automatic transmission.
What is the wiring diagram for a 1986 Pontiac Trans Am?
http://92b4crs.tripod.com/86wiring/86wiringindex.html this website helped me figure out how to put the wiring on my 86 TA
What is the difference in a TH 350 and 350 turbo trans?
None, TH stands for turbo-hydromatic, hence th350 or 350 turbo.
Brake problems Pontiac trans am GTA?
Ii might be the way the brakes was bled. The brakes has to be bled with the car running and in this order: right rear, left front, left rear, right front. The computer wont recognize any other way.
All but a very few rare SD Pontiacs are equipped with the PCV valve located in the valley pan. It would be just ahead of the carb in your car.
Can a Turbo 350 Transmission bolt onto an Oldsmobile 455?
yes you can... would not recommend doing so... if the motor is stock it may work fine. when you start to add horses you need to move up to a Turbo 400. but to answer your question you can put a 350 tranny on a olds 455
How do you remove the steering wheel from a 1994 Firebird after removing the airbag?
Use a basic steering wheel puller. It should come with three different sets of bolts one will match up and then tighten the center bolt until steering wheel comes off.
How do you reset the brake light on the dash on a 1995 Pontiac trans am?
Make sure the brake fluid is topped off first as that will set off the light if it's low and if it's full try disconnecting the battery for about a minute to reset the light, if the light comes back on you need to see a mechanic.
Replace fuel injecters 1987 trans am?
This is assuming you have a TPI engine, and an above average tool set, and good mechanical ability. First you need to disconnect the intake duct from the throttle body, then take the four 10mm bolts out of the throttle body. Next take the bolts out of each side of the intake plenum, unplug the MAT sensor from underneith the plenum, and the vacuum lines. Then remove the plenum, then take the 4 10mm bolts out of the fuel rail. You now have to unlock the factory clips at the top of the injectors, do this by rotating them clockwise until the hook is positioned to the left of the injector. Bleed off the fuel pressure by using the shrader valve on the fuel rail. Carefully using a prybar, lift the fuel rail one corner at a time, using WD-40 to lube the injector o-rings at the intake. Once the rail is lifted to obtain clearance to remove injectors, pry injectors out of the fuel rail, one at a time, don't try to take them all out before replacing. One at a time lube both o-rings on the new injector, and install into rail, repeat this until all are done. Then reinstall the rail and injector onto the intake manifold. This is not an easy task, requires a little patience and finess. Good Luck
How much oil and trans fluid does a 1993 Toyota Tercel take?
A '93 Tercel will take very close to four quarts of oil. Now I am not 100% sure but i think that the tranny will hold close to four quarts of gear oil.
How many 1973 trans ams were made with automatic coloum shift?
none, the trans am package came with a console shifter
How many quarts does a 2002 5.7l v8 trans am take?
It should be the same as a 98 5.7L which takes 4 1/2 quarts, but I'm not positive.
How do you change spark plugs on a Pontiac Trans Sport?
I haven't got to the back row of sparks plugs yet, however make sue you have either a swivel extention(I used a 3/8 Drive Universal Joint) or something shorter than 6 inches for your rachet. I tried removing the spark plug and with the extention on I kept hitting the AC tubing going across the front... I am going to start on the back row and was told by a friend to undo that motor mount in front and then while in park move the car forward a little and place a brick or wheel chock behind the tire. By doing this the motor will tilt downwards and towards the front giving you just a little more room to get to the back three wires and plugs.. . hope this helps and hoepfully I can get this done with out having to call the mobile mechanic!
Partial AnswerOf couse, the front plugs are no problem. The problem seems to be in the back 3. I have found online and from some mechanics, that you need to undo the motor mounts and rotate the engine. I have never tried that, and have replaced the back 3 going on two times now. First and foremost, you REALLY need to let the engine completely cool down. Your hand and arm are going to be touching extremly hot surfaces. I have a medium size hand, and i say that, because i don't know if that helps me, or if anyone's hand will fit. You can reach the back three with the van jacked up, and patience. It will take some time to manuver the plugs in and out. However, it is possible. Trust me, i have done it. GOOD LUCK!Going by what I have read, the book says to remove the fender. I did it myself laying on the engine and going by feel. It was a real bear but I did not have to undo the motor mounts, fender, anything, but I was sore for a couple days.
Where is idle air control valve located on Pontiac grand prix?
On the 2.4 liter engine it is located on the front of the engine just left of center. It has a set of wires plugged into it and it has two star head nuts holding it to the engine block.
1978 Pontiac trans am an you wont to do a engine swap what motor will fit in it?
As far as going in the engine compartment and bolting to the transmission, and Pontiac, Oldsmobile, Buick engine will work. You may have a duel pattern transmission which would allow you to use Chevy also. You would have to look to know. Where the trans. bolts to the engine there will be two holes side by side. Al GM except Chevy are the same as far as bolt pattern. Any motor will work, it's just a matter of running the plumbing, electrical and exhaust.
How much horsepower does a stock 2000 Pontiac trans am have?
it should have around 310 hp at the rear wheels.
