0
Saturn L-Series
The Saturn L-Series was a range of vehicles produced in 2000 to 2005 by Saturn Corporation. Based on the Opel Vectra B, these mid-size sedans and station wagons were offered with straight-4 and V6 engines with 5-speed manual/4-speed automatic transmissions.
976 Questions
Why is your Saturn l200 leaking oil?
That depends on WHERE it's leaking oi.
Internal combustion engines (not just Saturn's) tend to leak at a few favorite places, such as:
- Rocker cover gasket.
- Rear main seal
- Oil pan gasket
- Front main seal
- Oil filter
and if it's NOT one of the above, you may want to check the power steering pump.
How much should wheel bearing cost to be replaced on a 99 Saturn?
Cost me $50 for both sides. Bought the bearings off eBay and replaced them myself.
How hard is it to replace the rear struts on a Saturn 2002 L200?
how to replace rear struts on a 2002 saturn L 300
Why would you hear a ticking noise in your Saturn 2001 L300 v6 after changing the ERG valve?
The Saturn V6 has always been a little "vocal". A little valve noise is quite common and most likely, if it's valve noise, you probably just didn't notice it before the repair. Many people become hyper-aware of sounds after the vehicle has been repaired. The Eco-Tech engine is well designed and can be expected to last a long time if properly maintained. It's economical, reliable and powerful.
However, if it's NOT valve noise, there could be some other problems.
Try to isolate the source of the sound to see which component is responsible.
Where is the cranskshaft position sensor located on a 2002 Saturn L200 series?
The crankshaft position sensor on a 2002 Saturn L200 is typically located near the bottom of the engine, mounted on the engine block. It is positioned near the crankshaft pulley, often on the passenger side of the vehicle. To access it, you may need to remove the engine cover and possibly other components for better visibility. Always consult the vehicle's service manual for specific details and steps.
Do you have a ac bypass pulley for a 2000 Saturn LS sedan 3.0l v6?
Yes, an AC bypass pulley for a 2000 Saturn LS sedan with a 3.0L V6 engine is available. This pulley can be used to replace the AC compressor if it's not functioning, allowing the engine to run without the air conditioning system. You can find it through auto parts retailers or online marketplaces that specialize in automotive parts.
In 2000, the ECM (Electromagnetic Cassini Magnetometer) was part of the Cassini spacecraft, which was launched to study Saturn and its moons. During its mission, Cassini entered orbit around Saturn in July 2004, allowing it to closely investigate the planet's magnetic field and other phenomena. By 2000, however, the spacecraft was still in its early development and preparation stages, as it had not yet launched.
How do you remove the wiper blade on a Saturn L200 2001?
To remove the wiper blade on a 2001 Saturn L200, first lift the wiper arm away from the windshield. Locate the small tab or lever where the wiper blade connects to the arm, press or pull it to release the blade. Slide the blade off the wiper arm, and then simply attach the new blade by sliding it onto the arm until it clicks into place. Lower the wiper arm back onto the windshield once the new blade is secured.
Intermittent turn signals on 2003 jeep?
Intermittent turn signals on a 2003 Jeep can be caused by several issues, including a faulty turn signal switch, a bad flasher relay, or a poor connection in the wiring. First, check the flasher relay, as it is responsible for the blinking action; replacing it may resolve the problem. If the issue persists, inspect the turn signal switch and wiring for any signs of damage or corrosion. Additionally, ensure that the bulbs are functioning properly, as a burned-out bulb can also affect the signal operation.
How do you replace the air pump in a 2001 Saturn L200 serie?
To replace the air pump in a 2001 Saturn L200, first ensure the vehicle is turned off and disconnected from the battery. Remove any components obstructing access to the air pump, typically located near the engine. Disconnect the electrical connector and the hoses from the old pump, then remove the mounting bolts to take it out. Install the new air pump by reversing the process: secure it with bolts, reconnect the hoses and electrical connector, and reassemble any components that were removed.
What is the head bolt torque specs for a 2003 Saturn L200?
The head bolt torque specification for a 2003 Saturn L200 is typically 70 ft-lbs (95 Nm) for the initial torque, followed by an additional 90 degrees of rotation. It's important to follow the correct sequence and procedure outlined in the service manual to ensure proper sealing and avoid warping the cylinder head. Always double-check with the manufacturer's specifications for any updates or variations.
