answersLogoWhite

0

Subaru Outback

The Subaru Outback is a crossover car manufactured by Japanese carmaker Subaru since 1995 to present. Produced in four generations, all Outbacks come with all wheel drive as standard equipment.

1,587 Questions

When you pull the lever to pop open the gas cap cover on your 2005 Subaru Outback the door doesn't pop open how do you repair it before you run out of gas?

Solved the problem myself. Have to disassemble rear panels inside rear hatch until you find cable leading to gas tank door. About a hour or two. Replug plastic unit that opens gas door. Later glued it in place so this may not happen again.

How do you replace turn signal bulb on 1996 Subaru Outback?

See page 10-52 & 10-53 of your "Owner's Manual", under Section - 10: Maintenance and Service - Replacing Bulbs.....

Where is the fuse 16 location on 1997 subaru legacy outback?

In the Fuse Panel located under the Dashboard. See "Fuses and Circuits" on page 6 under "Specifications" in chapter 11 of your "OWNER'S MANUAL".....

Is it necessary to go to the dealer to replenish coolant on a 2000 Subaru outback or can you simply use coolant from any auto parts store?

Answer
There are brands of antifreeze out there that will work in "ANY" car, "ANY" antifreeze...A good parts store will carry it...Don't waste your money at the dealer....



Actually - you want to be careful with what brand you choose. Modern cars have specific requirements, many require long life anti silicon anti boron anti everything low phosphorous, etc. For instance, using non Dexcool in a GM product may void a warranty, likewise using Dexcool in a Toyota may void it also. Using the wrong antifreeze in modern cars can potentially cause consequences (eating up gaskets, etc) and void warranties. Do your homework on the right antifreeze to buy and when in doubt, consult your manual, your dealer and for the few extra bucks it cost, get it from your dealer. Since it sounds like you are servicing it yourself with the $50 - $75 you will save you can easily spend a few extra bucks at the dealer. Adding conditioner is also important when either recommended or required.
Answer
Subaru does recommend a conditioner that I think is put in with the coolant to help prevent a blown head gasket. Look into this if you're doing it yourself.

What ground clearance does the 2004 Subaru Outback have?

The ground clearance of the 2004 Subaru Outback is 0 ft. 7.3 in. (7.3 in.).

How do you take the Brake Rotor off a 2004 Subaru Outback?

Remove the wheels

Remove the caliper mounting bolts

Slide caliper off rotor

Rotor should slide of center hub

What is a easy way to get the underside bolt off to remove the starter of your 2002 subaru outback legacy?

I just had to remove my stater after it broke it's top mouting stud and cracked the bottom mount. I hand to crawl under and attach the new starter from underneath. This is a must have a ratchet otherwise there is no space for you to get leverage. Took me about 10-15 mins due to not haveing a lot of room and my hand cramping. If you have access to ramps or a lift I suggest using them to speed up your work time. Past that it was an easy fix.

How do you replace the cabin air filter in 2010 Subaru Outback?

See "Replacing an Air Filter" under "Air Filtration System" on page 15 of chapter 4 "Climate Control" in your "OWNER'S MANUAL".....

How do you change headlight bulb on a 2005 outback?

See your user manual, its great for basic maintenance info

How do you replace a cv joint on a 2000 Subaru Outback?

how do you replace the drivers side drive shaft and cv joint?

Can you get a turbo kit for your 2003 Subaru Outback?

"It's a station wagon...why would you?" Ever heard of a sleeper? Or better yet a Chevy Nomad? Why? Because Station Wagons Rock! To have the room and some capabilities of an SUV with handling and mpg of a car...a fast car. That's why. Yes, there are for the 2.5 liter engine. The same ones for the Impreza. $3,000-$4,500 kits from Ultimate-Racing .com add 200+hp!

How do you replace a timing belt on a 1998 Subaru Outback?

This is not your average timing belt replacement due to being a double overhead cam that is also an interferance fit.First remove cooling fans.2-Loosen drive belts and remove.3-Remove crank pully.4-Remove timing covers.You will see 4 cam sprockets.Theses sprockets contain single and double referance marks.You will be using the double referance marks.Rotate engine until the double referance marks are facing each other.This is to be done the same way that the American autos timing Chain systems are done but you will have 2 small double lines to line up not dots.The next step is the most important step and is of utmost imortance.THE CAMSHAFT HAVE TO BE LOCKED IN PLACE--FAILURE TO DO SO CAN RESULT IN BENT VALVES.The cam sprocket holders can be bought or rented.You can make your own as well by making 2 wedges with bolt through the middle.Slip in between sprockets and tighten enough to hold sprockets.Do not use excessive torque while tightening wedges sprockets are not made of steel but rather a composite material.Next you will have to remove the tenioner.The tensioner has to be retracted and pin istalled to hold in retracted position.The tension device has to be retracted with care or will be damaged.You can not exceed 50 pounds pressure on the plunger.The simplest method is to reract while still in vehicle, it takes 15 minutes to properly retract the plunger.By pulling up on the tensioner by hand with about 18 pounds of force --50 will be exerted at the plunger.When fully retracted insert pin to hold in reracted position.Next check to make sure that cam wedges are holding and no sprocket are trying to move,when satisfied remove one of the rollers at the bottom on the side where you left hand would be standing in front.Pull off belt.Replacement belt will have referance marksone line will go to crank sprocket face up others will line up with other sprocket marks.Reinstall roller followed by tensioner then pull pin you have holding tenioner retracted.Remove wedges.Reinstall covers fans belts.Do not be intimitaded by this replacement.Everything is very easy to get to.Be sure cams are locked and that damage is not done to tensioner and it is straight forward.

Why does your Subaru Outback fan keep running after the engine is off?

Since the advent of electric fans 30 or more years ago there has always been a warning on the fan shroud that the fan may start running at any time even with the engine off. However, reading between the lines of your question, you may be experiencing a stuck fan relay. There are three relays in the electrical schematic for my 2007. I don't know what year yours is. If mine did run continuously I would suspect the first main fan relay that just happens to be in the main fuse box.

How do you program alarm remote transmitter of Subaru Outback 05?

See "Sounding a Panic Alarm" on page 15 in Chapter 2 "Keys and Doors" of your "OWNER'S MANUAL".....

What is Spark plug gap for Subaru 98 2.5 l?

The spark plug gap for a 1998 Subaru Impreza/Legacy with the 2.5L DOHC engine is .044".

How do you disarm the alarm of a Subaru?

On older models you either need to use the remote or place the key in the ignition and turn it 3 times. It won't start because of the ignition kill until you disarm the alarm. On newer models you only have to turn the key once.

What country are Subaura Outback made?

Subaru Outbacks sold in the US are made in Lafayette Indiana.

How can a 2001 subaru outback impreza sport all wheel drive be converted to a front wheel drive?

on my 98 outback impreza sport: under the hood, flip open the fuse box, check diagram on underside of lid, match up with outlay of fuses. Slip a 15A fuse into the slot designated "FWD". This will disengage the AWD, and FWD should show up on on your driver side dashboard.

Hope that helps!

What could cause Subaru Outback acceleration problems?

Lots of things. You have not given enough information to answer the question. First please describe what you mean by "acceleration problems".

On the 2005 Outback when you change the brightness of the dash lights it shows on the odometer like ill 5 ill 6 well mine shows this while driving and I am not changing the dash lights what can I do?

"ILL.1" through "ILL.6" displayed in the odometer field indicate the level of the dash light dimmer setting. These messages will be displayed briefly when the dash light dimmer setting is adjusted. In the '05 Subaru Outbacks, dash light dimmers are known to fail. When they fail, the "ILL.n" message will appear sporadically in the odometer display without changing the dimmer setting. Replacing the dimmer will correct the problem.

What transmission fluid for manual trans 2001 outback?

Subaru recommends to use GL-5 (75W-90) Transmission Gear Oil.....

Will a purolator oil filter L 14460 fit a 2012 Subaru outback 2.5l?

The Owner's Manual calls for JDM black #15208AA100 or SOA Blue #15208AA12A, both number cross-ref to Purolator L14612. Your Purolator L14460 cross-ref to Subaru OEM 15208AA060. I got tired of all those darn part no. changes about the blue one, the black one, the short one, the long one. Do yourself a favor and do like me: Go to the nearest Subaru stealership and ask them to give you a filter that fits on your car. A filter change sure cost less than an engine change anyway.....

How do you replace the low beam headlights on a 2006 Subaru Outback Wagon?

There are total of three metal/plactic screws/brackets. All of them are on top, two are visible, one is semiidden under the grill edge. Start with removing the grill and it will be obvious.