0
Toyota Matrix
Also known as the Toyota Corolla Matrix in some markets, the Toyota Matrix is a 5-door compact hatchback produced by Toyota in Canada since 2002. This compact car is sold in the US, Mexico and Canada.
705 Questions
How do you remove the middle console bezel on a 2007 Sportage?
This is what I just did. First remove the 6 screws from both sides of the console. Next, remove the bottom rubber plate of the rear glove box of the console. It has a small grove that you can use a screw driver to pop it out. . Then remove the 2 screws you will see. Next, using a strong grip around the small grove (doesn't look like there is actually one there) , pull the rear cupholder/ashtray straight back. Inside you will see 2 bolts and 2 nuts holding the rear of the console to the floor. Remove them. Next, there is a wire plug you can see from the rear that goes up toward the passenger. This is for the front cigarette lighter on the console. Unplug it and remove the holder from the brace. This is the only wire disconnection. Next take the nut off of the emergency brake that pulls the cables, then raise the brake handle completely up. The console is now ready for removal, but first you must put the transmission in drive. Make sure the engine is OFF and the brake is set so it won't move. Lift up on the rear of the console (seems pretty high) and pull backwards. Pulling rearward pulls the 2 front pins out of their holders. Lift it out and you are done.
What is the cargo capacity of the 2004 Toyota Matrix with all seats in place?
The 2004 Toyota Matrix has 21.8 cu.ft. of cargo capacity with all of its seats in place.
You may have a leak in the radiator or radiator hoses, but first check to see if the drain plug under the radiator is tight. have you checked your coolant lines to and from engine and rad?
Good place to start, however... Most vehicles emit more coolant as they cool.Most conjoined parts made of dissimilar materials cool/contract at different rates, therefore becoming leak prone. Sometimesthey may not leak until the car is almost completely cool and then seal back up when it begins to warm after running for a few minutes. Sometimes what happens is you will get a collection of coolant(aka antifreeze)in an area overnight and when the vehicle is started and begins to warm, the coolant stops leaking, what is there burns off (hence the smell) and then the whole cycle begins itself when the vehicle is parked again. If you provide the vehicle make/model I may be able to pinpoint it a little better for you.
What is the base engine size of the 2009 Toyota Matrix?
The 2009 Toyota Matrix has a 1.8 L base engine size.
Where is dash fuse box in 2003 Toyota matrix?
under the steering wheel. there is also one ion the engine compartment next to the battery
Write a matrix to display the information x equals -10?
It is [x] = [-10]where [x] and [-10] are 1x1 matrices. Hardly worth the effort!
How do you remove the center console on a 1993 Jeep Cherokee?
Just pop it out :). There are little clips along the side of the bezle. BE CAREFUL they'll break extremely easy, but you can gradually just pop out one by one
Does the 2003 Toyota Matrix have rear differential?
No, a 2003 Matrix is front wheel drive with power getting to the wheels via CV joints.
How do you replace a serpentine belt on a 2000 Infiniti QX4?
On the 2000 QX4 you will have 3 belts. Starting from the fan blade back to the engine block, look to the left of the fan blade. There will be a tension pulley which looks like a smooth wheel with no pump or motor behind it. Release the lock on it by loosening the bolt in the center of the wheel (just until the bolt becomes loose or can be turned by hand). Above and slightly behind it is a bolt facing down that moves the wheel up or down, creating the belt tension. Loosen this bolt until the belt can be slid out. Next is a similar set up to the right of the fan blade. This will control the pulley for the 2nd belt. Finally, crawl underneath for the power steering belt (the last belt). Remove the black splash-guard to get access. Looking up on the pump, there will be 2 bolts. The one on the left, conveniently placed against the firewall, and one on the right, which mounts the p/s pump bracket to the engine. Break the tension on the right bolt so the bracket can move up and down, then tighten the bolt on the left (which commonly can be turned about 1/16 of a turn because of it's location - be patient!) Tightening will push the pump towards the engine, allowing the belt to be slid off. Replace the belts and manipulate the nuts in the reverse order of removing, inspecting that they're on the pulley correctly and in the correct place. Replace the splash-guard.
Note: When removing the belts, many of the bolts may be very hard to begin turning. Once you have broke the tension on them, they should turn relatively easy. Once you've broke the tension on the binding bolt (the center of the two pulley wheels and the bolt closest to the engine on the p/s bracket), the belt tension bolts should turn easily. If the belt tension bolts become difficult to turn, consider loosening a bit more to the opposing bolt which might be putting tension on the bracket you're moving or checking that you're not tightening the belt.
Tools required: You can complete the entire job with a metric 10,12,14 standard depth socket with a couple extensions. Also have a 12 and 14 open end wrench.
What kind of transmission does the 2005 Toyota Matrix have?
The 2005 Toyota Matrix has a 5-speed manual.
How do you remove the center console in a 1995 Ford Taurus?
See instructions found at http://www.autozone.com/az/cds/en_us/0900823d/80/0c/18/4e/0900823d800c184e/repairInfoPages.htm
The console finish panel retaining screw is found under the cup holder. Once you remove that you can pry the entire top panel off (labeled number 2 in the diagram). Tilt it up starting from the back. It will take some force, but it is just held on by clips.
It depends on the type of matrices you want to know. There are different ways to do different types.
How do I grease a timing belt?
The last thing you want to do is apply grease to a timing belt. If the belt is noisy it needs replacing or the tension-er needs replacing.
How do you replace the serpentine belt on a Chrysler 300M?
On a 2001 300M you use and 18" ratchet extension, or combination of extensions, to loosen the tensioner. You can loosen it by loosening the center pulley bolt from the top. Then from under the car, use your ratchet and extension and turn counterclockwise in the tensioner bolt. This will allow you to remove the old belt. Do the reverse to replace the belt. I also remove the bolts from the crossmember body piece, like you do to replace your headlights.
What size wipers on a 2007 Toyota matrix?
The 2007 Toyota Matrix takes a 21" drivers side, 18" passenger side and a fairly specialized 11" rear wiper that is difficult to find in the stores. See sources and related links below for more information. Since there are currently over 22 different wiper arm attachments, do not buy wipers just by length only - be sure to lookup exact wiper blade part numbers by vehicle make, model and year for the brand wiper you decide to purchase. This ensures correct length AND correct attachment.
