VW Beetle Type 1

yes they did, and so did the Canadian S13s. You can also take the manual S14 seatbelts but it will not be a 100% exact fit, but pretty close. The Canadian S13 and the JDM S13 seatbelts will replace your auto lapbelts with no problem.

need diagram for wiring for 1986 transam

When standing at the back of the car looking at the engine, the oil pressure switch is located on the left of the engine case at the top and near the rear of the car, not far from the distributor. It should be easy to locate because it should have a wire coming out of it.

There are a few things to look at, look at the windshield first, in a super beetle it will be curved, also on a super beetle if you look at the front suspension you will see struts (springs instead of shocks) and if you open the hood you will see a circular depression for the spare tire to lay down, and the last way to tell is to look at that dashboard, a super beetle has a dashboard that is big enough to throw a pack of cigarettes on to whereas a standard bug has no dashboard.


Actually, in a 1971 and 1972 beetle you can get a super beetle with a flat window and a flat dash. I own a 1971 Super beetle. It looks like a standard beetle in every way but it is slightly larger. The only way to tell is by looking for a spare tire that lays flat (only true in the Super) and the suspension. I suggest looking at the spare. If it is angled vertically it is standard - laying flat means it's a super.

Turbo models get up to 200hp

If it is an air cooled engine then it will not have a radiator cap.

yuo ned a scaner....or the diler a frehd traied end distroi the program.

94.5 inches

2500 ml. Two and a half quarts is all you should use unless you have a measuring cup.

Anything but DOT 5...DOT 3 is what was in it at the factory, DOT 4 is better and Synthetic Brake Fluid is also good. DOT 5 is Silicone Brake Fluid; it was invented for the Army and they're the only ones who should use it.

Stock they came with a 15 inch diameter and usually a 4 to 5 inch width.

firing order of a 1996 VW Golf?

Pull the turn signal switch toward you. First pull switches from low to high, second switches back to low.

0.016

the baja has the fenders and the back end cut off and fiberglass put in.

Jack the car up and put it on jackstands, then unhook the battery.

Next, open the hood and look behind the fan shroud on the right side of the car. There's a 17mm nut. Remove it, that's the top bolt holding the starter in.


Crawl under, find the starter (it's above the CV halfshaft on the right side) and remove the bottom nut holding it in. Pull it back, lower it as far as you can and unhook the two wires coming out of it. One is a push-on, the other uses a 13mm nut.

1967

vw transmission 002301103 what year did it fit?

Yes. But make sure you use the pressure plate made for your year car/tranny. The later cars used a different pressure plate.

A 1976 beetle (super or standard) is a Type I.

Ferdinand Piech Porsche designed the Volkswagen beetle.
Ferdinand Porsche discovered volkswagen beetle

The timing is very far off.

If someone has cut out and welded in new steel over the air ventsit was done on a one time custom basis and the repair can either be difficult or easy depending on what they did. At the very least you would need a donor junkyard vehicle to cut out new vents to replace yours with. A qualified body shop would be the best bet if you don't do welding and body repair.

Since the 10th didget is D it would be a 1984 model because in 1980 they started using a 17 didget VIN # and using the 10th didget for the year 1980 was A, 81 B, 83 C, 84 D and so on they did not use all the letters in the alphabet I cant remember all of them but I know the important ones. hope it helps

The firing order for all vintage beetles is 1-4-3-2 clockwise.

Carlos - Bugalooshrimp