Cadillac Fleetwood

Get ready to work........... There are two Phillips screws set on either side of all the sockets for the tail/brake lights, and back up lights. These are all stuck, believe me. The ONLY way to access these and get them out is to remove the rear bumper of the car. Remove the plastic fillers between the body and the top of the rear bumper and unplug the harness that leads to the lights.There are two nuts inside the trunk, one on either side of the car at the top of the rear fender, and four bolts that hold the bumper to the frame. Get help to hold it as it comes down. Replace EVERY bulb while you have it down, you don't want to do this often !!!!

I have a 1978 coupdiville cadillac my blower quit working and there is a relay above your fuse box and if it goes bad your heater wont turn on. I had to replace it with a after market heavy duty relay away from where it is originally plugged in. Also my ground wire connection was dirty and wouldn't turn on until I cleaned the connection so try that and see if it works or you might need to replace the motor.

First you need a ratchet with 3 socket sizes. 7,10, 15...Empty out gas tank as much as possible first........there is two size ten bolts behind the license plate on the side on the gas cap, remove. Go under the car jack up from both sides near passenger doors. Right behind the gas tank closes to back of the car there is a wire connection take off. Behind the back end of the fuel tank closes to front of the car there is two covers each has 4 bolts size 7, remove. If you look up at the fuel lines there is 3 wiith a brace bracket holding them in place remove bracket by hand. After that you will see two bolts which are size 15. One on each side. Slowly remove and have a helper unless you can with hold the weight. by than you will have thank on the floor.If you look at the top of the tank you will see 6 bolts hold down where your fuel pump is. remove bolts but remember how the holes are align. slowly take fuel pump out replace fuel filter n pump and fuel sending unit if necessary. I would either way. now reassemble. Also make sure to take off the battery terminals and fuel fuse which is number 13 under your fuse block under the hood. I did this too my 94 fleetwood today alone. Simple job but make sure you have block or anything to help level the tank to align fuel pump back in.

There are two coolant temperature sensors. One is located near the water pump and the other on the head above the starter.

I have a rearend that has a bolt pattern that is less than 4 in. Any idea full time pos.

Under the hood neat the top of the radiator on the right as you look at it.

Only 8,336 Cadillac Fleetwood Brougham coupe's were produced in 1985 and was also the last year of the coupe body style. If you look hard enough there's always one for sale but be ready to spend $$$$. ;)

1980-1984 Coupe Devilles will also fit and I tell u what, if u find the doors, they are very very expensive.... I got a pair of solid one's from 1981 Coupe Deville that i paid back in 04 for 700 bucks that Im planing to put on my 1985 Brougham

if the fan turns on but no air is blowing there is a vacuume pod on the heater box in the engine compartment that is not working or a leak in the hose.

the fan does not activate; check ground wire in engine compartment. the fan can be tAKEN OFF OR REPired by removing a few screws in engine bay, same fan was used upto 1970

open tire you see up down sensor change (junk yard 20 dollar ). and reset program If you have different sensor check 4 wire and plug cut and plug same position . you will working fine

change over to air shocks on rear end

radiator

check the body fuse or cig ltr fuse

THE HORN DOED NOT HAVE A FUSE IT HAS A RELAY !!!!!!!!!!!!!!!!! I STILL NEED THE HORN WHILE DRIVING THE CAR> I shall try the dealer. Remove the fuse. The first responder was not referring to the horn fuse, they were referring to the alarm fuse.

counter-clockwise on the cap

The fuel filter is on the drivers side in front of the rear wheel along the frame.

You can bypass the a/c compressor on the 1989 cadillac fleetwood by simply using a smaller accessory belt. I have found that a 77 inch belt works perfectly. There is no need for a bypass pulley and you won't find one for this model anyway.

they are fuel injected, there is a filter located on the frame rail on the passenger side . it is under a slight amount of pressure. it would be wise to have a rag around the fitting as you loosen it.

If you are asking about just the top pad you will need to pop of the wood grain strips under the dash. Do this by getting in behind the strip with a small flat head screw driver and pop it loose as you work your way down strip. Be carefull as these will crack. Once off you will see screws along the dash I believe they are 7mm. Take these out then pop out the vent in the center of the dash close to the windshield. There you will find I believe 2 more screws take these out. Then all you have to do is simply pull the dash toward you as you lift up. There are clips where it meets the windshield that it will pop out of. This is very easy just be carefull of the wood grain. Hope this helps and good luck.

The lug pattern for a Cadillac Fleetwood is 5x127. On the other hand the lug pattern for a Cadillac Fleetwood FWD is 5x115.

sensor for water temp is in water pump on front of engine, has two wire plug going to it.

if you look at the front grill there should be a missing section at the top off the grill. somewher near the center.. you will need to feel through the grill for a release handle and push it up.. hood should open right up..

Yes

in fuse box under dash

no the you would have to alter the suspension about 2 to 4 inches to fit correctly to prevent rubbing