0
Chevy Camaro RS
This category covers questions about the RS custom option for the first generation (1966-1969) Chevrolet Camaro. The RS package included hidden headlights, revised taillights, RS badging, and exterior rocker trim.
2,274 Questions
If the low beams are not working on a Peugeot 306, it is possible that the low beam headlights are burned out. If the high beam headlamps are part of the same bulb, perhaps the wrong bulbs are in the sockets. Some older cars have both the high and low beams running off the same bulb and the low beam can burn out both sides at the same time.
How many can sit in an 2010 Camaro?
The 2010 Camaro can fit up to 4 people but if you have larger people in the front seats then I would say only small children will fit in the back seats. Larger people would be defined as over 6' and 200lbs.
How much horsepower does a 2010 Chevy Camaro have?
V6 - 304hp
V8 (auto trans) - 400hp
V8 (manual trans) - 426hp
http://www.caranddriver.com/reviews/car/09q1/2010_chevrolet_camaro_ss_v8-short_take_road_test
What would cause the clock to reset every time you turn on and off the car?
the Clock is probably wired to the ignition and power is turned off every time you turn off the Car there fore you have to reset the clock.
What is the knocking noise from the back of my car?
what a stupid question you have given no info about anything or what the car is and expect an answer go smoke another joint or something because this is a waste of time
first answer is just someone iggnorant the knocking could be your rear end going out caused by gears slipping if your brake pads are bad your calipers could knock and then so destroy your brake system if your car vibrates at high speed (60<) you could have a drive shaft issue which could cause wear on your rear end and could be causing the knock then again it could be the dead body you forgot to take out
How do you take the cooling fan off a 1994 Ford F-150 6-cylinder?
F-150 6CYL, MOST OF THE LATE MODEL FORDS AND CHEVYS INCLUDING THE DIESELS,"SCREW" THE FAN CLUTCH ONTO THE WATER PUMP. THIS ONLY REQUIRES YOU GOING TO YOU LOCAL AUTO PARTS STORE AND BUYING A "FAN WRENCH SET". PAY ATTENTION, THERE ARE 2 OR 3 DIFFERENT SIZES. THE COUNTER MAN SHOULD BE ABLE TO LOOK IT UP FOR YOURS. IF YOUR IN POSSESION OF A LARGE CRESENT WRENCH, IT WILL ALSO WORK, BUT, YOU'LL HAVE TO FIND SOMEWAY TO STOP THE WATER PUMP PULLEY FROM TURNING. THAT'S WHAT ONE OF THE 2 WRENCHS IN THE WRENCH KIT DOES. HAPPY MOTORING
What are the symptoms of an ICP sensor problem?
Rough idle, low injector pressure
Sputtering stalling. lack of power
How much horsepower dose a camaro ss 2010 have?
426 hp (manual transmission)
400 hp (automatic transmission)
What does acc on the fues box stand for on a 1989 camaro rs?
Accessory. Essentially it's the first position when you move the key.
it goes ACC (accessory), then ON, finally start (crank)
The fuse box is just letting you know when the fuse will have power when your down there testing for it.
How much do you charge to put new headers in a 1996 Chevy Camaro?
sawzall and trash entire existing exhaust $50
remove AIR system $50
remove left manifold $50
remove right manifold $100
Install long tubes $100
Install ORY $25
Install CatBack $100
Call it $500
plus 500 for the headers
200 for the ORY
350 for the CatBack
Call it $1500
Easy way to remove gas tank from a 88 Camaro?
gas tanks are usually strapped in with wo straps. there are nuts that have to be turned, counter-clockwise of course, or you could get a hold od someone from craigslist, there ARE mechanics on that site looking to fix jalopies all the time, 88? probably a jalopy, 350 car i hope
What year did they start making the camaro?
1967 was the first model year. So the answer to the question is 1966.
Why is your 97 camaro v6 running hot?
Could be a number of reasons - you may be low on coolant, you may have a defective cooling system, or you may have a blown head gasket (or all of the above).
What is a 1987 RS Camaro worth?
As usual it depends on the overall condition, mileage, options, etc...
How do you remove the cover of the dome light in a 2001 Ford Focus?
Use a small screw driver or somthing that you can use to pry of the lense. Once you have done that you can change the light.
Change oil pan gasket 98 olds intrigue?
Do you mean "how to change the oil pan gasket?", or "should I change the oil pan gasket?". I assume you have a leak around the pan and need to change the gasket. If so, be sure that it is indeed a gasket leak by cleaning off the engine and pan and checking it again after an hour of driving. The 3.5L are notorious for using oil (about 1 qt every 1000 mi is considered average). Don't just assume this oil is leaking out.
To change the gasket is a lot of labor but is fairly straightforward. Drain the oil, remove the dozen or so bolts from the pan, and pry it off being as careful as possible to not gouge the block or bend the pan lip. Remove the old gasket with a scraper, again being careful to not scratch up the block or the pan. Install a new gasket (they come in a kit with the proper sealant, I believe (never done an Olds myself)). Bolt it back on and retorque the bolts to the level and in the order specified in the kit. The pan on the 3.5L includes the oil filter carrier, which may need replacement if it is worn. These can leak as well.
Where is the fuse for the trunk release button on a 95 roadmaster?
Open the driver's side door...there's a small door on the side of the dashboard that opens up. The fuses are inside there. There is also a fuse box under the hood on the passenger side at the top of the firewall so you could check there, too, for the trunk release but it should be on the fuse box inside the driver's door.
