What can cause a bcm to go bad in rendezvous?
I had to have my bcm replaced. I was told that it was due to car being jumpstarted which is another issue. I had to take it to the dealer with a cost of replacement being $600
1970 Monte Carlo ss 454 what shows if it is a real one?
The best way to verify if the car is an actual SS model is to find a copy of the build sheet. I found mine between the springs and the foam of the drivers seat. I have heard there may be another build sheet on top of the gas tank, but that is obviously harder to reach. Most SS models will have a factory tachometer, an automatic leveling compressor under the hood with air shcks in the rear, bucket seats, and a console shifter.
How to reprogram ignition key xsara Picasso?
hi Philip north London n4 here
The BSI unit is basically a computer which
handles a multitude of functions such as
odometer value, central locking, lights and
immobiliser. Some later Bsi units are liable
to corrupt their own software program if
not "woken up" in a specific way after
programming keys or battery disconnection.
The details of this are explored
thoroughly in a Peugeot TSB but I will
summarise for you briefly.
Procedure for Initialising the BSI after key learning
1. Disconnect the diagnostic tool.If being used.
2. Put the driver's window down, lift the bonnet and ensure all
equipment is switched off.
3. Ensure all doors are closed and remove key from the
ignition.
4. Wait for 3 minutes, disconnect the vehicle battery and wait
15 seconds.
5. Reconnect the vehicle battery, wait a further 10 seconds (do
not open doors.)
6. Switch on the side lights through the driver's window.
7. Switch on the ignition and check system's functionality.
8. Hold lock button on key down for 10 seconds.
9.remove key open & close door test c entral locking system
10. Start the engine and complete the system's check.
Failure to follow this procedure could result in incorrect operation of many
BSI related items.
It did take three attempts following this procedure before it worked.
How do you turn on automatatic door lock on a citroen picasso
Keep the the lock botton pressed for several seconds (2sec). A message will appear on the screen to confirm the new settings
Will a cold air intake from a 2004 Monte Carlo ss fit a 2006 Monte Carlo ss?
No the are not interchangeable the 06 has a 5.3l v8 and the 04 is a 3.8L Try getting a K & N SYSTEM.
When was the first Monte Carlo car made?
The first model of the Monte Carlo car was made by Chevrolet in 1970 and was billed as a luxury Coupe. It has since been synonymous with luxury and style.
Is a 1974 Chevy Monte Carlo a classic?
While a 74 Monte might be considered a "classic", such a car is not considered collectible and likely never will be.
What do you do if a 1992 Buick LeSabre Security Light came on and you can't start the car?
Wait 3 minutes until the security light goes off, the try it again. It should fire right up! It's a bit inconvenient, but if it's the worst problem you get from a 17 yr old car, be thankful for it. TAke it ot the dealer as they have check out charts. If it has the MAT security system installed, there is a "valet" switch (that may or may not be installed in your particular vehicle). On my 1992 LeSabre, it was a brown and gray wire pair plugged into the last 2 pins on the wiring block. Turn the ignition switch to "Run" - and connect the two wires (or turn on the valet switch if you can find it). If you don't have a valet switch, or there are no wires attached to the pins, you may have to get creative and use a wire to connect the two pins. This disables the starter interlock feature. The red LED should turn on and stay on solid, and your car should start. At least that's how my problem was solved. Best of luck! When my 1994 LaSabre had a problem recognizing the chip in the key (due to the contacts in the lock not working), I managed to bypass the system by locating the two wires (clear tube with two smaller wires in it exiting the steerin column, unlike any other wiring), cutting the cable, and soldering a resistor across the two wires that go to the hidden module thet in turn controlls the starter and sends a signal to the engine computer. Use a resistor of the same resistamce value as in one of the keys for the car (measure resistors with a digital meter). There are a dozen or so values used. You loose the extra protection of the chip, but the fix is low cost.
How do you change the transmission fluid on a 1995 Chevy Monte Carlo?
drop the oil pan and put in new screen and filter then put the pan the same way you took it off
What does the ss mean in Monte Carlo?
Super sport, basically the higher end Monte Carlo. Ls is luxury sport. Typically SS models have a sportier look like spoiler etc with all the power accessories and a better motor but personally I like the ls models from 86-88 better...has 10x more chrome
your flasher is bad i had the same problem and replaced the flasher .it is located behind your e brake lever in dash there are 2 one emergency and one for turning the top one is turning
there are to wires that run from the security system to the eginition switch that's break i beleave they are orange and white you cut the to wires that run from to the switch take your key to a lock smith and have the resition measured it will be between one and fifteen go to radio shack and buy u a ressitor that match your key and solder it between the wire and the cac will run but u wont have no security or some web sites have a thing that u can can buy called passed key that will fix it
How much does a 2003 Chevy Monte Carlo weigh?
The Chevrolet Monte Carlo LS coupe has a curb weight of 3,340 pounds. General Motors produced the Monte Carlo from 1970-1988 and again from 1995-2007.
Replace evaporator core on 2001 Chevy Monte carlos ss how much labor?
a shop is costing me 1100.00 to replace little to much i think.
Reset the change oil light on 1997 Monte Carlo?
everyone should have a manual for their vehicle, and the library should have a professional shop manual available in the REFERENCE section...make copies of the right sections...good luck :) To reset your change oil light, GM uses the "3-step" method:
I have a 1997 and here is what the manual says to do:
With the ignition key in the RUN position, but the engine off, fully push and release the accelerator pedal three times within five seconds. If the CHANGE OIL SOON light flashes two times, the system is reset. However, if the light comes on and stays on for five seconds, it did not reset. You'll need to reset the system again. ...Good Luck!
How do you add freon to Monte Carlo?
The Funny Side.
I don't think the population of Monte Carlo would be very impressed if you sprayed them with freon.
Where is the Fuse box diagram for a 1997 Monte Carlo Z34?
The fuse box diagram of this car can be found in its owners manual. It can also be found on the inside of the cover of the fuse box.
Do you need to bleed all 4 brakes after I install new rotors and front pads?
no, it's not necessary unless your pedal fades or it's spongy.
Will the check engine light ALWAYS come on if the oxygen sensor is bad?
No not always,But it will correct problem 99% of the time. Brett
Where are the blower motor resistor located on a 2002 Monte Carlo SS car?
Just below the heater on the passenger side. Remove the cover from beneath the glove box and it is just below the cowling for the fan - on the bottom. It is a little difficult to get to and in held in by 3 screws. Remove the top screw and loosen the bottom 2 screws, disconnect the wire clip and lift up and tilt the top towards the back of the car. ... VE5SF-VETTE
Where is the freeze-plug located at on a 1997 Chevy Monte Carlo?
the car is smoking on the left side is it the freeze plug?
How do you turbo charge a 1980 Monte Carlo with a 3.8 V6?
Chevrolet actually made a Turbo 3.8L V6 Monte Carlo in 1980. Finding one would be alot cheaper prospect than trying to do it yourself.