Chevy Tracker

To install a roof rack on a 2002 Chevy Tracker with a soft top, first ensure you have a compatible roof rack system designed for soft tops. Begin by attaching the rack's mounting hardware to the vehicle’s fixed points, usually located above the doors. Use the provided straps or clamps to secure the rack to the soft top, ensuring it's tight and stable without damaging the fabric. Finally, double-check all connections for security and stability before loading any gear.

To replace the heater fan on a 1999 Chevy Tracker, first disconnect the negative battery cable to ensure safety. Remove the passenger side dashboard panel to access the heater assembly. Disconnect the electrical connector from the heater fan, then unbolt the fan motor from its housing. Replace the old fan with the new one, reattach the bolts and connector, and reassemble the dashboard panel before reconnecting the battery.

To change the main rear oil seal on a 1998 Dodge Ram 1500, you'll need to start by lifting the vehicle and supporting it securely. Remove the driveshaft, then unbolt the transmission from the engine and lower it slightly to access the rear main seal. Carefully pry out the old seal, clean the sealing surface, and install the new seal using a seal installer or a suitable tool to ensure it fits evenly. Reassemble the transmission, driveshaft, and any other components, making sure to refill any lost fluids.

You can find used 1998 Tracker hard tops on various online marketplaces such as eBay, Craigslist, and Facebook Marketplace, where individuals often sell automotive parts. Additionally, check specialty automotive forums and websites dedicated to classic car parts, as they may have listings or connections to sellers. Local salvage yards or junkyards might also have hard tops available for purchase. Lastly, consider visiting automotive swap meets or car shows, where enthusiasts often buy and sell parts.

To change the rear brakes on a 2001 Infiniti I30, start by safely lifting the vehicle and removing the rear wheels. Then, remove the caliper by loosening the caliper bolts, slide it off, and support it without stressing the brake line. Take out the old brake pads and replace them with new ones, ensuring the caliper piston is compressed to accommodate the thicker new pads. Finally, reattach the caliper, put the wheels back on, and lower the vehicle before testing the brakes.

Your vechile is equipped with 'Senteniel Lighting' which means, after you shut your vehicle off, the lights will remain on, for the duration you have it set for. If your lights fail to shut off, even with senteniel disabled i would have the switch, or the headlight relay examined.

YOU WILL DIE! have you check your IAC ??

take the front grill support off if the engine is in the car. then remove the plate covering the cam. then remove the cam?. it is alot easier with the engine on a stand.

If it's running, then it couldn't be raw gas. You are seeing water dripping from the accumulation of the water vapor. Absolutely normal.

ac or exhuast

Hyundai has an unbeatable warranty which allows you to drive them without worry due to guaranteed reliability.

1st thing to check is the spark. Remove a spark plug from the engine and plug it to the spark plug boot. Touch the plug to the cylinder head and crack the engine. Should see spark at the tip of the plug. If no spark, 2nd thing I would check is the crank position switch. It is located on the transaxle bell housing.

Try wiggling the starter solenoid wire. My 91 after so many random starts did/does this and cleaning/tightning the terminal clip works every time.