0
Chrysler 300 Series
The 300 “letter series” are high-performance cars manufactured in the US by Chrysler Corporation from 1955 to 1965. The cars are available as a two-door coupe and a two-door convertible.
1,224 Questions
What is the curb weight of the 2013 Chrysler 300?
The curb weight of the 2013 Chrysler 300 is 4029 lbs..
How to remove windshield washer pump Chrysler concord?
Take the car apart as you would to get to the front driver headlight. It involves taking out a few screws, headlight, plastic bottom coverlike under the bumper. It has one bolt that ties the plastic to the fender and it is hidden in a hole in the wheel well. You will se a plastic cover, oval in shape about two inchs long to remove. You will need a long extention tow get to the bolt. I found that on my 99 Concorde I just needed to remove bolts on one side of the car to be able to pull the plastic out far enough to expose and remove the front headlight. That exposes the windshield washer tank. three bolts and a coupl of wires and hoses and its out of there. The pump is attached to the tank. It pulls out of a rubber grommet. The hard part is the first part in locating the bolts to remove the plastic bumper if you will. That drove me nuts for awhile but it was an easy task and after that you know how to change the light bulbs too. Tim
How do you change the camshaft position sensor?
Before you change the sensor which is down on the front of the engine you need to see if the magnet is still in place inside the timing chain cover. On our 2000 ford escort zx2 the camshaft position sensor was located right below the oil cap. All it took was a 8mm ratchet. On a dodge neon the sensor is on the trans side of the head and is held on with either 2 or 4 screws. On other vehicles it is held in by one bolt.
What are toe in alignment specs for 2005 Chrysler 300?
{| ! align="middle" | FRONT WHEEL ALIGNMENT |} {| ! align="middle" | PREFERRED SETTING |} {| ! align="middle" | ACCEPTABLE RANGE |} CAMBER - LEFT +0.15° -0.50° to +0.80° CAMBER - RIGHT -0.25° -0.90° to +0.04° CROSS-CAMBER (Maximum side-to-side difference) +0.40° -0.10° to +1.15° CASTER - LEFT +9.40° +8.40° to +10.40° CASTER - RIGHT +10.40° +9.40° to +11.40° CROSS-CASTER (Maximum side-to-side difference) -1.00°-1.60° to -0.40° TOE - INDIVIDUAL +0.10° -0.05° to +0.15° TOE - TOTAL* +0.20° -0.10° to +0.30° Maximum side-to-side difference 0.00° 0.06° REAR WHEEL ALIGNMENTPREFERRED SETTINGACCEPTABLE RANGE CAMBER -0.55° -1.20° to +0.10° CROSS-CAMBER (Maximum side-to-side difference) 0.00°-0.80° to +0.80° TOE - INDIVIDUAL LEFT +0.17° +0.02° to +0.32° TOE - INDIVIDUAL RIGHT +0.03° -0.12° to +0.18° THRUST ANGLE +0.07° -0.08° to +0.22° Notes: * TOTAL TOE is the sum of both left and right wheel toe settings. TOTAL TOE must be equally split between each wheel on the same axle to ensure the steering wheel is centered after setting toe. Positive toe is toe-in and negative toe is toe-out
Where is the radio fuse at in a Chrysler 300m 1999?
When you open the driver's side door you'll see the fuses. They're the below the steering wheel on the left hand side if your sitting in the car. There should be a list of all the different fuses engraved on the inside of the plastic cover that encloses all the fuses. Either way #4 is the radio fuse.
What is the average gas mileage for a Chrysler 300?
The gas millage is directly dependent on how you drive the car. If you take off and stop suddenly, you gas millage will run between 15.3 and 17.2 mpg. If you take off and stop slowly and you don't force the car and engine to do a lot of work, i have seen up to 21.2 mpg. Mind you this in on the 1999 to 2004 models. I believe the 2005 to 2007 is about the same though.
Do you have to remove the front passenger tire to replace the battery for a 1999 Chrysler 300 m?
No, but it is much easier to do with the tire off.
Do mufflers go in back or front of car?
Normally, the muffler will be in the back of the car. If you are looking towards the front, or upstream from the muffler, then you should see 1 or possibly 2 catalytic converter(s).
The air intack on most vehicles is located outside the car, mostly found in the "cowl" area. This is the area between the hood and windshield, usually a vent or similar. I am not familar with the 300, but most cars are set up like this. If the smell only happens on "recirculate" you might check the recirculation intake for your A/C and heater. It is normally located under the dash between the driver and passenger or under the front seats. Some accidents in these areas will cause an odor every time you put on Max A/C, but not (or at least not as noticable) on vent.
Why does a 2013 Chrysler 300 V6 get stuck in park?
Set the parking brake before you put the shift in park when parking.Take shift out of park before releasing the parking brake when driving.
What does a error code P0430 mean on a 2006 Chrysler 300?
Bank 2 catalytic converter efficiency failure.
Bank 2 catalytic converter efficiency failure.
How do you program the remote key for a 2008 Chrysler 300?
read the manual-but follow the instructions closley- it is very easy
actually the "key" needs to be programed at the dealer or by a locksmith. The Fobik keyless key control actually only uses a real key as a backup and the car is started by the keyfob itself
Why is your airbag light on in a 2006 chrysler 300?
The light stays on when the airbag computer detects a malfunction and sets a code.
Where can you find the speed sense wire on a Chrysler 300?
GREEN/BROWN WIRE IN A 2 PIN CONNECTOR AT THE REAR OF THE TRANSMISSION OR PIN 32 AT THE PCM PLUG PASSENGER SIDE FIREWALL
Where is the fuse box for a 2004 Chrysler crossfire?
As you're sitting in your Crossfire, the fuse box is on the "side" of the dashboard near the driver's side door.
How do you reset the airbag light on your 2007 Chrysler 300?
You will need to have the computer checked for codes. The light can not be "reset" until the cause of the trouble code has been repaired. When the cause has been repaired, the light will actually shut itself off.
You will need to have the computer checked for codes. The light can not be "reset" until the cause of the trouble code has been repaired. When the cause has been repaired, the light will actually shut itself off.
Was the slant six motor originally a truck motor?
The SLANT 6 was introduced as the 6 cylinder engine in Chrysler corporation's 1960 automotive year model line. It was used in the compact 1960 Valiant, and the 1960 Dodge Dart. The Dart was a mid sized car. The engine replaced the venerable L head 6 that Chrysler had used since it introduction in 1930. The L head engine in fact continued to be the engine in the truck line for several additonal years. I believe the Slant 6 made it into the Dodge A 100 series of vans and cab forward Pickups, then into the standard pickup in 1963. The Plymouth Full size car line also had the /6 in 1960. Dodge introduced a compact similar to the Valiant know as the Lancer it also had a /6. The engines were available in two displacemets in 1960 the 170 for the Valiant and the 225 for the larger Dodge. The Lancer got both versions by customer selection. Later a 198 cubic inch was introduced as well. An Aluminum blocked version was experimented with but never made it to full production. Some were released unnanounced to the public in random production cars. The aluminum block had head to block sealing porblems which were never corrected satisfactorily for total introduction. So the simple answer is no, the /6 was introduced in cars before trucks. When it made it into trucks it was a very flexable and dependable powerplant in all it applications. It was also used for industrial and marine applications.
