Faulty fuel pump
How much does a tune up cost for a V6 97 Chrysler Sebring?
about 350.00 just for the fact some of the wires are in a bad place. to wear they have to take apart some of the engine to get to it.
Where is the oil signal sending or pressure switch on a 1997 Chrysler Sebring 2.5L V6?
right above the oil filter there is a wire leading to it. it wont be possible to get to the sending unit without taking the oil filter off.
My 1998 Chrysler sebring turns over but wont start and has no spark?
check to see if the cam is turning. check coil by turning on and off the switch. have someone hold on to the big wire out of the coil.
Where is the oxygen sensor bank 1 sensor 2 located on a 1997 Chrysler Sebring lxi?
It is behind the engine, after the catalyst.
Oh yeah, these crank sensors break off if you live in a rust-prone region such as NJ or the Midwest US. If this is likely to be a problem, follow this procedure:
1) Get a fire extinguisher handy. You shouldn't need it, but safety is a concern.
2) Unplug the crank sensor and get the wires away from the immediate area. Remove the bolt from the sensor.
3) Get a hot flame about 4 inches and bright blue ready. Hold it to the sensor for about 45 seconds. Remove the flame, the sensor should produce a small yellow flame. If the sensor is burning, blow it out and go to 4, otherwise heat it up some more.
4) Pull the sensor out. The outer layer of plastic is melted, allowing safe removal of the sensor.
AnswerCheck for failure of crank or cam sensor. If you haven't got access to a lab scope, just replace both. It's probably the crank sensor though.On some applications, removal of the cam sensor may require moving the upper intake. A new gasket should not be required, but check for vacuum leaks after you're done.
Where are the spark plugs in a 97 Chrysler Sebring Does this apply to 2000 convertible too?
there should be 4-8 black wires about the size of a pencil running across your motor from one location(black "box"). They will each end at a plug. actually its a little more difficult than the last answer.. 3 are easy to see on top of the engine.. the other 3 are underneath the manifold.. you have to remove it to get to them along with your air intake hose.. good luck with this one.. when you do it.. you should replace the gaskit on the manifold too.. keeps everything running well. Happy hunting and good luck,. :)
How do you find heated seat relay or fuse 2004 Sebring?
On a 2002, it's in the fuse box located under the hood, on the left side of the car where the RED + jump start post is. The box is about 6" x 8".
Where is the thermostat on the Chrysler sebring 2003?
2.4L should be located at the engine end of the upper radiator hose
On the 2.7 motor the thermostat is located at the engine side of the lower radiator hose
How do you reset the pcm or computer on a 1999 chrysler sebring?
You can either use a scan tool or unhook the battery for 5 minutes.
You can either use a scan tool or unhook the battery for 5 minutes.
Where is the PCM located on a 1998 Chrysler Sebring?
On the right side of the engine compartment next to the air cleaner. It is a large silver box.
Why will a Chrysler Sebring not go in gear?
If the shifter will not move you have a mechanical or electric issued with the shifter. If the shifter does move you may have low fluid or a failed transmission.
Where are the spark plugs on 2.4 2007 sebring?
If your looking at the valve cover on the engine you will see the the plug wires going straright in to the valve cover, obviously there are four. Those will be the plugs under the wires.
Are there any recalls on a 2007 Chrysler Sebring?
There could be. If you call your local dealership with the VIN, they will check for free.
There could be. If you call your local dealership with the VIN, they will check for free.
Where is the fuel pump on a 2003 Chrysler Sebring?
The fuel pump is inside the fuel tank.
The fuel pump is inside the fuel tank.
How do you replace a serpentine belt for a 1998 Chrysler Sebring Convertible?
jack up the front passanger tire take off the tire and remove the plastic panels and belts are located there and look for the tensioners and loosen the bolt on the top for the main and the middle for the other. then use a 1/2 inch rachet in the givven spot and turn it till the tensioner lets the belt loose. do reverse for install.
How can you restitch a convertible top?
Unless you're a fantastic seamster or seamstress, this is a job for an upholstery or convertible top shop. Price to fix is between $200 to $500 depending on where you go.
Where is the ECM located in a 1997 Chrysler Sebring LX?
when looking from the front of your car into the engine compartment it is to the right of the air filter on the left of the engine fuse box that is below your positive jump start post.
What would be the best replacement motor to put in a 1999 sebring conv jxi 6-cylinder?
Exactly what it came with from the factory. Yup, yup. You need to use the same engine that came out of a JXI. The coupe and convertables are 2 totally different cars. The LXI is considered to be the coupe, and they have a Mitsubishi engine in them, while the convertable have a Chrysler engine in it.
Could ba a blown fuse for blower motor Could be a bad switch for blower motor