0
Dodge Dakota
The Dodge Dakota is a mid-size pickup truck manufactured by Chrysler since 1987. The Dakota has been commonly used by many fire and police departments as bush truck, patrol car or off-road vehicle.
4,822 Questions
Which tires on a 2002 dodge dakotas have ABS?
Rear standard
4 wheel optional
Rear standard
4 wheel optional
What is joint arthrokinematics?
the general term for the specific movements of joint surfaces. Normal joint surface movement is necessary to ensure long-term joint integrity. (Joint surface movements are sometimes called joint play motions or component motions).
Joint surfaces move with respect to one another by simultaneously (1) rolling, (2) gliding, and (3) spinning.
How do you change front brake pads on a 2000 Dodge Dakota?
Remove wheels Re-install 2 lug nuts to hold rotor in place Remove 2 caliper mounting bolts Slide caliper off rotor Use a "C" clamp to fully retract piston into caliper body Install new inner and outer pads Re-Install caliper REMEMBER TO PUMP BRAKE PEDAL TO SET PADS AGAINST ROTOR PRIOR TO MOVING VEHICLE
Can you put the dashboard from a 1997 and up Dodge Dakota in the 1996 and older models?
Nope, the 96 and before Dakotas had a boxy dashboard. In 97 when they went to the rounder looking design for the truck the dashboard got the same rounded treatment.
Headlights and tail lights do not work on 1989 dodge Dakota pick up whats the problem?
A few possibilities are; 1. the main light control switch is bad(most likely this) 2. fuse(s) blown or fuse kinks 3. shorted wires; sometimes if the truck has rust along the door frame/front seat mounting area/floor board area the wires will corrode and short under the carpet. Also these same set of wires can sometimes run next to or along side the frame rails under the car and do get corroded or damaged.
How do you recharge a 1996 Olds 88 air conditioner?
Using a set of a/c gauges put the blue hose on the low side (suction side) and the red hose on the high side (discharge side) and make sure that there is no freon in the system and if you have freon in the system then you will have to go to an automotive a/c shop and have them reclaim it for you..
Put the yellow hose on your vacuum pump and let it run for about 1 hour and then let it sit for 1 hour so that you can see if it will at least hold the vacuum pulled.
If so then let it run for an additional hour and then start the recharging process remembering to keep the low side readings between 30 to 40psi and the high side between 200 to 250psi depending on the outside temperature…………….
change both filters and be sure both are tight
How do you take the cooling fan off a 1994 Ford F-150 6-cylinder?
F-150 6CYL, MOST OF THE LATE MODEL FORDS AND CHEVYS INCLUDING THE DIESELS,"SCREW" THE FAN CLUTCH ONTO THE WATER PUMP. THIS ONLY REQUIRES YOU GOING TO YOU LOCAL AUTO PARTS STORE AND BUYING A "FAN WRENCH SET". PAY ATTENTION, THERE ARE 2 OR 3 DIFFERENT SIZES. THE COUNTER MAN SHOULD BE ABLE TO LOOK IT UP FOR YOURS. IF YOUR IN POSSESION OF A LARGE CRESENT WRENCH, IT WILL ALSO WORK, BUT, YOU'LL HAVE TO FIND SOMEWAY TO STOP THE WATER PUMP PULLEY FROM TURNING. THAT'S WHAT ONE OF THE 2 WRENCHS IN THE WRENCH KIT DOES. HAPPY MOTORING
Where is located the heater blower motor resistor on a 2002 Dodge 1500?
If the 2002 is like the 2004...
Check the bottom passenger side.
Unclick and remove the (1/2"x1/2") connector to it.
Remove the two screws.
The resistor should fall out.
Hand tighten the screws back in place so you don't lose them.
How do you read computer codes for a 94 dodge Dakota?
Cycle ignition key on,off,on,off,on and count the flashes of the check engine light. It will flash two digit codes. Two flashes, pause, two flashes would be a code 22.
The other option is an OBD 1 capable scan tool.
Where is asd relay on 1998 dodge Dakota?
In the fuse box, left side of the vehicle behind the battery.
Where is the crankshaft sensor located on a 1992 Oldsmobile Toronado?
not true all you need to do is remove right front tire all the plastic mud guard from wheel well and the sensor will be right in front of you you will need to remove the the torque mount on the engine but that will also be right in front of you....
as for tools you will need a harmonic balancer puller and a few sockets and a torque wrench is a MUST... hope this helps
What makes a dodge Dakota misfire?
To fix the notorious random multiple cylinder misfire code on mid 90s dodge trucks like the Dakota and the ram. After much research and headaches. It basically comes down to two things, secondary ignition crossfire which there is a TSB you can follow and it is, TSB18-48-98. It has to be followed exactly or it wont help. The second thing has to do with the engine not having enough dedicated grounds. The first aftermarket ground you should add is on the left fuel rail going to the windshield wiper motor mounting bolt, the right rail already has a ground strap to the firewall. 2nd is off the ignition coil bottom mounting bolt to the web(side) of the frame.Make sure and use 12 gauge wire. This should fix most of yalls random misfire if you've ruled everything else out. NO CAR BEFORE MOPAR.
What is the procedure for removing the oil pan on a 2002 Dodge Stratus 2.4?
The question you ask is too involved for a proper answer. You need to go to a car parts store, and get a repair manual for your car. They cost about $16.00 Or, go to a Public Library.
Where is the cab access port in a dodge Dakota where an external antenna can be feed in?
There are not many places to access the outside without drilling but if you have enough cable ( and Im assuming you are talking about something like a xm satellite antenna) you can run it through the third brake light opening at the back of the cab. This will require removing the back portion of the headliner retainer and running the cable along the door sill and up behind the seat, possibly under the door trim and along the inside of the headliner so it will be hidden.
Where do I start trouble shooting a Dakota with a fault code 54?
54
No camshaft signal detected during engine cranking.**
Where would the oxygen sensors be located on a 1997 Dodge Dakota?
There are two and they are on the exhaust pipe. One in front of the catalytic converter (upstream) and one behind (downstream). Replacement is roughly equivalent to replacing a spark plug. Make sure to get the special socket that Autozone loans out.
Hey Bob==They are on the exhaust pipes.I don't know if it has one or two. GoodluckJoe
Where is the number one plug located on a 318 engine for a Dodge truck?
Engine left front See the following site: http://www.sweptline.com/tech/engine2.html Y-THINK-Y
