answersLogoWhite

0

🚗

Dodge Ram

The Dodge Ram is a large pick-up truck produced by Chrysler from 1981 to present. The car, which features a front engine and rear/four-wheel drive, was named “Truck of the Year” three times by the Motor Trend magazine.

13,744 Questions

How much oil does an air compresser hold 1998 dodge ram?

Total capacity is 4 ounces.

Total capacity is 4 ounces.

Where is crank position sensor on a 1999 dodge 5.2 liter truck?

Top of the bell housing, behind the passenger side cylinder head. It is almost under the transmission dipstick tube.

What is the wiring positions from the spark plugs to the distributor cap on a 1996 dodge ram pickup 5.9 liter?

Firing order, 1-8-4-3-6-5-7-2 clockwise.

#1 should be labelled on the cap.

Cylinder numbers

pass side 2-4-6-8

drivers 1-3-5-7

What is the maximum towing capacity of the 2002 Dodge Durango?

The maximum tosing capacity of the 2002 Dodge Durango is 7550 lbs..

Clearing a 2003 dodge ram 1500 5.7 liter oxygen sensor code?

To clear a hard code. You need a scanner to connect to the vehicles ECM.

How do you reset the tipm on a 2006 dodge ram 3500?

From what I understand, you must take it to the dealership. Sorry for the bad news... Yes the dealers scan tool is required.

Where can you find wiring diagrams for both the engine compartment and the interior on a 1992 Geo Tracker?

THERE IS A COMPLETE ELECTRICAL WIRING DIAGRAM IN THE CHILTON'S REPAIR MANUAL.

Haynes also has a fairly good diagram, I found the dealers shop repair manual to be the best source, most GM dealers will make a photo-copy of whichever pages you need

If you need a water pump on a 1992 Buick Skylark does the engine have to be cranked up to change it because the belt is around the motor mount?

Yeah, that's it!!!!! Have the engine running while you replace the water pump.... This kind of question is a good example of why children are taught NOT to eat paste.

What does a ECU fuse do?

AnswerThat is Electronic Control Unit, the computer.

If you blow or remove the ECU fuse the car will not run.

Where is the crank sensor located on a 1995 dodge ram?

The crank sensor is located on the passenger side of the bell housing near the valve cover. It is held in place by two Allen head cap screws.

How do you remove tailgate from 2004 dodge ram pickup?

The tailgate on a 2004 Dodge Ram pickup can be removed by removing the gate from the hinges holding it in place. Open the tailgate halfway and remove the slotted hinge from each side while holding the gate up. Then open the tailgate all the way and slide the tailgate off.

What would cause a front brake caliper to stick on a 89 Dodge Ram Van 250?

Brake calipers stick when they get old. You need to replace it and the other side While you're at it.

What grade fuel can you use in the 08 HEMI MDS engine?

Any grade is fine. It doesn't require premium or mid grade.

Where is the fuse for a 2003 dodge ram power outlet?

All fuses are in the box, under the hood, driver side. The lid has locations on it.

How do you change taillight on a 2002 dodge ram 1500 pickup?

You Need A Special Tool, Which You Can Buy At AutoZone Or Something. You Open The Tail Gate, Then You Use The Special Tool To Unscrew the Screws And The Taillight Comes out.

Dodge Dynasty overheats fan doesn't come on is it a fuse or sensor bad where is the best area to check first?

Engine overheats When a car or truck overheats idling, in town, on the highway, while towing, etc. it is important to find out the reason to prevent engine damage. First, with the engine cold, make sure the radiator is full of coolant; if it is low, fill it and keep the radiator cap off while the engine idles to insure all air is bled out of the system ( air trapped in the system can cause overheating also). Check the coolant level daily; if the coolant goes down without visible leaks, it may be a head gasket starting to leak which will also cause the heater to blow cold air due to the lack of available coolant. If the coolant stays full, but the car continues to overheat, the next step is to replace the thermostat in the engine and flush the cooling system if that has not been done over the last few years.Buy a thermostat at a parts store and a PRESTONE flush kit which has excellent directions on the package.After completing these steps and the vehicle still overheats, have your cooling fan sensor/switch ( if equipped)checked out to insure it is coming on. Water pumps are seldom the cause as they are mechanical and will continue to work until their bearings give out. Finally, the radiator itself is often the problem as it tends to build up corrosion internally which prevents it from transfering engine heat to the coolant. Remove it and have it 're-cored'. One of these steps will solve the problem.

How do you replace the heater core on a 1998 Cherokee sport?

Changing the heater core requires complete removal of the dash panel and plenum box. To do this you have to remove the steering wheel, steering column, evacuate and recharge the refrigerant system and drain the radiator. I would only consider changing the heater core if it is physically leaking into the passenger compartment. If the problem is heat transfer to the HVAC system only, the problem is more likely with the blend doors. Check heatertreater.net for pictures and diagnostic information.

How do you install a cold air intake on a 1996 dodge neon?

there are plenty of "How-To's" for home made CAI's (Cold Air Intake) at Neon enthusiast forums (NeonTuners.com and Neons.org are IMO the best examples)