0
Ford Explorer
The Ford Explorer is a full-size crossover SUV built by the Ford Motor Company as a replacement for the Ford Bronco II. Its fifth generation model is available as a 5-door SUV with a 6-speed automatic transmission.
6,601 Questions
What kind of transmission does the 2004 Ford Explorer have?
The 2004 Ford Explorer has a 5-speed automatic.
Location of fuse for a 2001 Ford Explorer windshield washer pump?
According to the owner's manual a 2001 Ford Explorer Sport Trac has a 7.5 amp fuse in location # 12 for the washer pump relay and in the power distribution box of a 2001 Sport Trac ( PD BOX IS LIVE - DISCONNECT YOUR NEGATIVE BATTERY CABLE) in location # 46 B is the front washer pump relay.
The overdrive light flashes on and off while driving your 2000 ford explorer 4.0 v6 sohc?
A malfunction has been detected - get it checked out
Where is the dipstick of transmission fluid of a 2005 Ford Explorer?
Starting in 2002 the Ford Explorer 4 door does not have an automatic
transmission fluid dipstick
Is there an access panel for changing fuel pump on 93 Ford Explorer?
The 1993 Ford Explorer fuel pump access panel is located on the gas tank. The gas tank should be drained in order to access the fuel pump.
Why is your gas pedal squeaking?
Try spraying the pedal linkage with wd40 or something similar and see if the noise goes away.
How do you reset the alarm system on a 1995 Ford Ranger Super-cab?
hey, you will probly need to go to your ford dealer nearest you.
How do you remove the rear rotors on a 2003 ford explorer?
Once you remove the break system and the caliber your rotor will be exposed, check the back to make sure their are no more lines in or around your rotor and get a hammer and block of wood(so you don't dammage or chip your rotor) or a rubber malet if available. Tap all the way around your rotor, beating to the inside like your trying to put it back on. This should loosen the dust and rust and allow you to take it off. If not tap it from the back all the way around attempting to drive it off the studs.
How many miles to gal on a Ford Explorer?
It depends if you used light gasoline,
------------------------------------------------------------------------------------------
A little more information please ( Year of Ford Explorer , engine size ,
2 wheel drive or 4x4 , automatic or manual transmission )
How do you repair the mass air flow sensor on a 2002 ford explorer?
This is not a "repairable" item, it must be replaced. It will be between the air filter and the throttle body. Look for a wire connector on the intake. If you go to autozone's website they may have a diagram (job diagram) that shows exactly where it is. If not, just ask the guys at the parts counter, they'll show you and may even install it for you, its a quick remove and replace job. Most auto parts stores will also code scan your computer for you for free to see if you have any other issues.
If you hear grinding and clicking when braking in a 2001 Kia Sephia what is it?
Pads or shoes worn out. Take it to a brake place.
How far can a Ford Explorer V6 or V8 go without needing to refuel?
ALL VEHICLES are designed to go approx. 300 miles per tankful. It doesn't matter what size, make, or model. Example: an SUV that gets low MPG has a LARGE gas tank (capable of approx. 300 mi.) An economy car that gets high MPG has a SMALL gas tank (capable of approx. 300 mi.)
Where is EEC located on 94 explorer?
I believe it is behind the kick panel in the right front passenger footwell
Where is this 4x4 shift motor located at and how do you take it off on a 2002 Ford Explorer?
The shift motor on my 1996 Ford Explorer is located at the end of the transmission, around 1/2 way back on the left side of the under carriage. May be in the same spot for 02 models.
What can cause power windows in a 1994 ford explorer to not go up or down?
From what I understand of your problem, IF the fuse for that circuit IS good, then the problem is probably that the wiring of that circuit is suffering from an "open" condition, is disconnected somewhere.
For an electrical circuit to function, the circuit must be complete which means that a conductor [wire] must be attached from the Positive terminal of the battery and run [through various harnesses, connectors, and plugs, etc.] to the fuse, then to a control switch, then to the electrical device (in this case your window motors), and then another wire [called a ground] back to the Negative terminal of the battery. Usually the ground wire does not go all the way back to the battery Negative terminal, but instead connects to the body sheet metal near the device, and the body sheet metal is all grounded to the Negative terminal of the battery.
This continuous line of conduction is what is called a "circuit." IF any part of that circuit is disconnected at a connector, or a screw terminal, or at a sheet metal ground screw, the circuit is "open," incomplete, and cannot conduct the electricity.
The "fix" for your problem is for someone who understands and is experienced in automotive electrical systems to fully "troubleshoot" that electrical circuit to find and identify the defect [s] and then to properly correct it.
Although there could be only one of many possible defects, you need to find it, and fix it in order to cause the circuit to work as it should. The first thing that should be checked is the fuse [s] for the nonfunctional circuit.
Another thing that comes to mind is that often fuses can "look OK," yet be incapable of conducting electricity. You need to test fuses that look OK with a VOM [Volt-Ohm meter] to confirm that there is conductivity.
Is the timing chain in a engine changeable?
Timing chains wear over time. They also stretch out and if allowed to go too long can "jump a tooth" and throw your motor out of time. They can also break. Check your vehicle manufacturer for recommended mileage to change your timing chain. If you do the job yourself make sure to use new tensioners and check the cam and crank gear teeth for wear.
Why is my oil pressure gauge reading high on my 1994 ford explorer?
Have you checked your oil pressure? The gauge may be right.
It is possible that your gauge is failing, but the oil sender unit is more likely. That's a cheap and simple fix on the first gen explorers.
The gauge and the light use different senders, but if you tell the parts store which you have they will get you the right sender.
A pair of pliers will remove the old one. thread the new one in by hand and tighten it hand tight, reconnect the one wire and you are ready to roll.
What is causing my Front differential to leak on 1998 ford explorer?
Is the fluid coming from the vent hose ? When the differential fluid gets warm , it expands , and sometimes can come out the vent tube ( especially if someone has " topped it up " when it is colder ) or is it leaking from a front axle seal ?
How many gallons of fuel does a 99 4Runner hold?
I have a 99 4Runner SR5; I believe it is an 18.3 gallon tank, but don't quote me on that. It is at least 18.
Where is the Oxygen Sensor for Bank 1 Sensor 1 on a 2002 Ford Explorer V6?
Bank 1 is the passenger side of the engine in your Ford Explorer
Sensor 1 will be somewhere in the exhaust system , close to the engine , before the exhaust enters the catalytic converter ( upstream )
How do you measure 2005 Ford Explorer XLT wheel size?
They came with 16 or 17" in 6(steels) 6.5 or 7 inch widths (aluminum rims) aluminums have 12mm offset. If they are factory rims the driver's door/jam sticker will give diameter and width, on the back of the rim spoke will also give this info and part#. If you want to measure it yourself diameter is across the rim from bead/bead (16 or 17"), width is the distance between the inner/outer lip of the rim. Backspacing is measured from a straight edge placed across the rim(facing down) to the mounting flange( example 3.5 inches), offset is the different between the backspacing and the middle of the rim, usually in MM. Negative offset push the rim farther out(more frame clearance) and positive move the rim in.
Where can you find vacuum schematics for a 97 Ford Explorer?
http://www.explorerforum.com/forums/showthread.php?t=169945
How do you manually roll up the window on a 1995 Ford Explorer?
If it is hard to roll up and has no broken regulator, you can spray silicone lubricante in thre tracks.
