0
GMC Sonoma
The GMC Sonoma, also known as the Chevrolet S-10, is a small pickup truck manufactured by General Motors from 1982 to 2004 in North America and 1995 to the present in Brazil. It features a front engine and rear/four-wheel drive.
926 Questions
What is the purpose of the small bulb in the rear taillight of a 1999 GMC Sonoma?
The one that lights the outside edge, a marker light to be seen from the side
Where is the evap canister located on a S-10 Chevrolet pickup?
On a 2002 Chevy S-10 4WD Crew Cab, it is mounted underneath the bed, drivers side, above the rear axle. It's a black rectangular canister, dealer priced at about $180.
Where is the thermostat located on a GMC 4.3L V6?
as on almost any gasoline engine vehicle, you can find it by following the top radiator hose. one end of this hose is attached to the radiator and the other end is attached to the thermostat housing. the housing is attached to the engine block with two bolts. remove the end of the hose and then take these two bolts out and, carefully, remove the housing. the thermostat is right under the housing. parts in the coolant system are usually stuck together, so initially, a little tapping on the side of the housing may help loosen it. also, the thermostat may either be stuck to the engine block, or inside the housing when you remove that. (its usually in the block). try looking for a picture of a thermostat on the internet for reference. heres a link...... http://www.exoticperformanceplus.com/performance_parts/images/701296442.jpg hope this was helpful.
Bolt torque specs for 2.2L 2000 GMC Sonoma?
There are lots of bolts holding that 2.2 together. Need to know which bolts you are asking about.
A squealing belt on a 2001 GMC sonoma?
A worn belt will cause a squealing noise. The squealing noise is caused when the belt slips. Tightening the belt will temporarily fix the problem.
Where do you plug in a 2003 Sonoma?
The spark plugs in a 2003 GMC Sonoma can be changed relatively easily with a socket wrench. However, the spare wheel must be removed from the wheel well to allow access.
How much fluid does a borg warner T5 transmission hold?
WRONG -> 2.7 liters or 2.8 quarts depending on model it takes dextron 2 or 3
Borg Warner T5 manual transmission doesn't use automatic transmission fluid or (ATF) it uses gear oil.
Why do the left signal lights not flash on your GMC Sonoma?
If the right one works,it might be a bad bulb or a bad ground.
Where is the crankshaft position sensor on a 1994 Chevy blazer 4.3 vortec?
It is bolted to the side of the timing cover right behind the harmonic balancer. That is the bottom pulley on the front of the engine.
Where is computer located on gmc sonoma?
Depends on the year for '98-'99 it is under the hood, car's right side over the coolant overflow tank.
How do you install brake light switch on 01 gmc sonoma?
Are you talking about the switch located on the brake pedal? If that is the one you are interested in removing and replacing it is held onto the brake pedal by a consarned clip that is difficult to nie on to impossible for the novice to take off and replace. I have mine off and am trying to put it back on with little success. Ifg anyone out there knows an easy simple way to do this please answer.
Does a 1991 gmc sonoma 4.3L v6 auto have a 4L60 transmission?
Yes. Note that this will be a mechanical 4L60, not the electronic 4L60E, which was introduced in 1993.
Which pully do you loosen to change the belt on a 1993 GMC Sonoma?
Look for the idler pully,it will be the one that runs against the back of your surpentine belt,It is spring loaded,it is smooth,use a breaker bar or 1/2 drive ratchet,there is a bolt head that sticks out of the front of the pulley find a socket that fits this bolt head it should be metric,make sure that you take note on how it is already installed so you can reinstall it the same way,using your tool put the correct socket on the bolt and pull in the direction that the pulley moves freely,then you can remove the old belt,there should be a schemetic on your radiator support that shows the routing of your belts.
How do you change the battery on a 200 gmc sonoma?
take the negative batter cable off, then the positive cable off, undo batter hold down clamp, take battery out. put new battery in, install batter hold down, install positive cable, then install negative cable. (in that order)
How do you remove a manual shift knob from a 1996 gmc sonoma?
pull the shift boot down. loosen the jam nut under the shift knob then unscrew the shift knob.
Were is the location of oil sending unit on 1994 GMC pickup with a V6 4.3?
The oil sending unit is located on the back of the block, directly behind/below the distributor.
How do you replace the mass air flow sensor on a 2003 s10?
The air flow sensor is located between the large round hose that connects to the air filter and the engine. It is connected with a strap that has a screw on it. Remove the old **make sure you note the direction of the arrow on the air flow sensor then put the new one back with the arrow facing in the same direction as the old . Reconnect hoses if you had to disconnect them. Also be careful to NOT push on the screen at any time. They are fragile and might break. I also use some type of air pressure to blow the dirt out of the electrical connection that should also be located on the hose and secured with a clip.
Which wire do you hook up an aftermarket tach to get a tach signal on a 94 gmc sonoma 2.2 liter?
green wire on aftermarket tachs are the signal wire i belive
What is the companion flange on 95 gmc sonoma rear end?
A companion flange is where the end of the driveshaft meets the rear end(two flat pieces that bolt together).
